scispace - formally typeset
Search or ask a question
Topic

Imaging phantom

About: Imaging phantom is a research topic. Over the lifetime, 28170 publications have been published within this topic receiving 510003 citations. The topic is also known as: phantom.


Papers
More filters
Journal ArticleDOI
TL;DR: System design and image reconstruction techniques are described, along with simulation and phantom results that demonstrate the characteristics and limitations of system accuracy and resolution.
Abstract: Laminar optical tomography (LOT) is a new technique that combines the advantages of diffuse optical tomography image reconstruction and a microscopy-based setup to allow noncontact imaging with 100–200‐µm resolution effective over depths of 0–2.5 mm. LOT is being developed primarily for multispectral imaging of rat cortex, for which resolving functional dynamics in various layers of the brain’s cortex (to depths of 1500 µm) is of increasing interest to neurophysiologists. System design and image reconstruction techniques are described, along with simulation and phantom results that demonstrate the characteristics and limitations of system accuracy and resolution.

158 citations

Journal ArticleDOI
TL;DR: The results show significant dosimetric differences when using a calibration phantom with materials which are not tissue equivalent, particularly in the radial direction.
Abstract: The availability of cone beam computerized tomography (CBCT) images at the time of treatment has opened possibilities for dose calculations representing the delivered dose for adaptive radiation therapy. A significant component in the accuracy of dose calculation is the calibration of the Hounsfield unit (HU) number to electron density (ED). The aim of this work is to assess the impact of HU to ED calibration phantom insert composition and phantom volume on dose calculation accuracy for CBCT. CBCT HU to ED calibration curves for different commercial phantoms were measured and compared. The effect of the scattering volume of the phantom on the HU to ED calibration was examined as a function of phantom length and radial diameter. The resulting calibration curves were used at the treatment planning system to calculate doses for geometrically simple phantoms and a pelvic anatomical phantom to compare against measured doses. Three-dimensional dose distributions for the pelvis phantom were calculated using the HU to ED curves and compared using Chi comparisons. The HU to ED calibration curves for the commercial phantoms diverge at densities greater than that of water, depending on the elemental composition of the phantom insert. The effect of adding scatter material longitudinally, increasing the phantom length from 5 cm to 26 cm, was found to be up to 260 HU numbers for the high-density insert. The change in the HU value, by increasing the diameter of the phantom from 18 to 40 cm, was found to be up to 1200 HU for the high-density insert. The effect of phantom diameter on the HU to ED curve can lead to dose differences for 6 MV and 18 MV x-rays under bone inhomogeneities of up to 20% in extreme cases. These results show significant dosimetric differences when using a calibration phantom with materials which are not tissue equivalent. More importantly, the amount of scattering material used with the HU to ED calibration phantom has a significant effect on the dosimetric accuracy, particularly in the radial direction.

157 citations

Journal ArticleDOI
TL;DR: The spectral–spatial reconstruction problem is found to efficiently separate into a chemical‐shift inversion followed by a spatial reconstruction and is successfully demonstrated for dynamic, multislice [1‐13C]pyruvate metabolic MR imaging in phantom and in vivo rat experiments.
Abstract: Metabolic imaging with hyperpolarized [1-(13)C]pyruvate offers the unique opportunity for a minimally invasive detection of cellular metabolism. Efficient and robust acquisition and reconstruction techniques are required for capturing the wealth of information present for the limited duration of the hyperpolarized state (~1 min). In this study, the Dixon/IDEAL type of water-fat separation is expanded toward spectroscopic imaging of [1-(13) C]pyruvate and its down-stream metabolites. For this purpose, the spectral-spatial encoding is based on single-shot spiral image encoding and echo-time shifting in between excitations for the chemical-shift encoding. In addition, also a free-induction decay spectrum is acquired and the obtained chemical-shift prior knowledge is efficiently used in the reconstruction. The spectral-spatial reconstruction problem is found to efficiently separate into a chemical-shift inversion followed by a spatial reconstruction. The method is successfully demonstrated for dynamic, multislice [1-(13)C]pyruvate metabolic MR imaging in phantom and in vivo rat experiments.

157 citations

Journal ArticleDOI
TL;DR: Stereolithographic models can now be confidently employed as accurate, three-dimensional replicas of complex, anatomical structures in such areas as pre-operative planning of complex surgical procedures and for applications where higher accuracy is required.
Abstract: A study was undertaken to determine the dimensional accuracy of anatomical replicas derived from X-ray 3D computed tomography (CT) images and produced using the rapid prototyping technique of stereolithography (SLA). A dry bone skull and geometric phantom were scanned, and replicas were produced. Distance measurements were obtained to compare the original objects and the resulting replicas. Repeated measurements between anatomical landmarks were used for comparison of the original skull and replica. Results for the geometric phantom demonstrate a mean difference of +0.47 mm, representing an accuracy of 97.7-99.12%. Measurements of the skull produced a range of absolute differences (maximum +4.62 mm, minimum +0.1 mm, mean +0.85 mm). These results support the use of SLA models of human anatomical structures in such areas as pre-operative planning of complex surgical procedures. For applications where higher accuracy is required, improvements can be expected by utilizing smaller pixel resolution in the CT images. Stereolithographic models can now be confidently employed as accurate, three-dimensional replicas of complex, anatomical structures.

157 citations

Journal ArticleDOI
TL;DR: The implementation of the technique of echo‐planar diffusion imaging, which allows reproducible quantitative values of the diffusion coefficient to be measured in vivo, and shows a significant “perfusion fraction” in grey matter.
Abstract: Use of the Stejskal-Tanner sequence for performing diffusion images in the human brain tends to be complicated by the presence of artifacts caused by voluntary or involuntary, sometimes pulsatile, motion. We describe the implementation of the technique of echoplanar diffusion imaging, which avoids these artifacts and allows reproducible quantitative values of the diffusion coefficient to be measured in vivo. The effects of perfusion are easily visible in a phantom containing a gel. The results for human brain show a significant “perfusion fraction” in grey matter, consistent with an extracellular, possibly microvascular, VO~Ume of about 10%. 0 1991 Academic Press, Inc.

157 citations


Network Information
Related Topics (5)
Iterative reconstruction
41.2K papers, 841.1K citations
89% related
Image quality
52.7K papers, 787.9K citations
88% related
Positron emission tomography
19.9K papers, 555.2K citations
82% related
Image resolution
38.7K papers, 736.5K citations
82% related
Detector
146.5K papers, 1.3M citations
81% related
Performance
Metrics
No. of papers in the topic in previous years
YearPapers
20231,623
20223,476
20211,221
20201,482
20191,568
20181,503