Imaging phantom

About: Imaging phantom is a research topic. Over the lifetime, 28170 publications have been published within this topic receiving 510003 citations. The topic is also known as: phantom.

A signal-to-noise calibration procedure for NMR imaging systems

Abstract: A nuclear magnetic resonance (NMR) imaging system signal-to-noise calibration technique based on an NMR projection of distilled water in a cylindrical bottle is proposed. This measurement can characterize any arrangement of rf coils in any magnetic field as signal to noise per ml times root Hz. Inductive losses in a typical patient must be included in the calibration, and such losses can be simulated in a particular system by an externally attached resistor(s) appropriate to that system. Alternatively, an rf inductive damping phantom consisting of a conducting loop of wire containing an appropriate resistor is suggested that can be inserted into any NMR imaging coil to simulate subject Q damping. The same resistor can be used, independent of the details of the coil construction. Furthermore, if the loop inductance is tuned out at each frequency with a series capacitor, then the same loop resistance will serve for all frequencies as a good approximation to human subject damping. This "projection method" signal-to-noise ratio is related to the conventional signal-to-noise ratio measured from a Lorentzian-shaped spectral line as psi P = psi L [2/T2]1/2, where psi stands for signal-to-noise ratio, subscripts P and L stand, respectively, for the projection and "Lorentzian" methods, and T2 is the transverse relaxation time of the spectral line used in the Lorentzian method.

A complete distortion correction for MR images: I. Gradient warp correction

Abstract: MR images are known to be distorted because of both gradient nonlinearity and imperfections in the B0 field, the latter caused either by an imperfect shim or sample-induced distortions. This paper describes in detail a method for correcting the gradient warp distortion, based on a direct field mapping using a custom-built phantom with three orthogonal grids of fluid-filled rods. The key advance of the current work over previous contributions is the large volume of the mapping phantom and the large distortions (>25 mm) corrected, making the method suitable for use with large field of view, extra-cranial images. Experimental measurements on the Siemens AS25 gradient set, as installed on a Siemens Vision scanner, are compared with a theoretical description of the gradient set, based on the manufacturer's spherical harmonic coefficients. It was found that over a volume of 320x200x340 mm3 distortions can be successfully mapped to within the voxel resolution of the raw imaging data, whilst outside this volume, correction is still good but some systematic errors are present. The phenomenon of through-plane distortion (also known as 'slice warp') is examined in detail, and the perturbation it causes to the measurements is quantified and corrected. At the very edges of the region of support provided by the phantom, through-plane distortion is extreme and only partially corrected by the present method. Solutions to this problem are discussed. Both phantom and patient data demonstrate the efficacy of the gradient warp correction.

Sensitivity of laser opto-acoustic imaging in detection of small deeply embedded tumors

Abstract: Current imaging modalities fail to detect small tumors in the breast. Opto-acoustic tomography is a novel technique for early cancer detection with promising diagnostic capability. The experimental limit of sensitivity and maximal depth of the laser opto-acoustic detection for small model tumors located within bulk phantom tissue were studied. Two phantoms with optical properties similar to that of breast tissue in the near infrared spectral range were used in these studies: turbid gelatin slabs with the thickness of 100 mm and chicken breast muscle slabs with the thickness of up to 80 mm. Gelatin spheres with enhanced absorption coefficient relative to the background absorption and liver tissue were used to simulate small tumors. The experiments demonstrated the capability of laser optoacoustic imaging to detect and localize phantom tumors with the diameter of 2 mm at a depth of up to 60 mm within the gelatin phantoms and 3/spl times/2/spl times/0.6-mm piece of liver tissue within 80-mm chicken breast tissue. Theoretical studies on sensitivity of opto-acoustic detection at various diameters, depths of location, and absorption coefficients of small tumors were performed using the experimental data. Our results suggest that the opto-acoustic imaging may occupy a significant niche in early detection of cancer in the breast and other organs.

96-Channel Receive-Only Head Coil for 3 Tesla: Design Optimization and Evaluation

Abstract: The benefits and challenges of highly parallel array coils for head imaging were investigated through the development of a 3T receive-only phased-array head coil with 96 receive elements constructed on a close-fitting helmet-shaped former. We evaluated several designs for the coil elements and matching circuitry, with particular attention to sources of signal-to-noise ratio (SNR) loss, including various sources of coil loading and coupling between the array elements. The SNR and noise amplification (g-factor) in accelerated imaging were quantitatively evaluated in phantom and human imaging and compared to a 32-channel array built on an identical helmet-shaped former and to a larger commercial 12-channel head coil. The 96-channel coil provided substantial SNR gains in the distal cortex compared to the 12- and 32-channel coils. The central SNR for the 96-channel coil was similar to the 32-channel coil for optimum SNR combination and 20% lower for root-sum-of-squares combination. There was a significant reduction in the maximum g-factor for 96 channels compared to 32; for example, the 96-channel maximum g-factor was 65% of the 32-channel value for acceleration rate 4. The performance of the array is demonstrated in highly accelerated brain images.