Indentation

About: Indentation is a research topic. Over the lifetime, 13002 publications have been published within this topic receiving 340476 citations.

Spherical indentation of freestanding circular thin films in the membrane regime

Abstract: We present theoretical and experimental results to describe the mechanics of indentation of a clamped circular membrane with a frictionless spherical indenter. Analytical expressions and numerical simulations are presented for the relationships between contact radius, finite indentation strains (and stresses), pre-stretch, loads and deflection. These closed-form solutions are contrasted with point-load models that neglect the contact size (i.e. classical Schwerin-type solutions), and lead to important differences in the indentation strain and load–deflection response. The accuracy of these closed form expressions is illustrated by comparisons with detailed numerical results and experiments on thin elastomer films. We show that the closed-form solutions can be used to extract mechanical properties from indentation testing of freestanding films, with important implications for developing new tests on nanoscale films and/or compliant materials such as polymers and biological substances.

Non-Hertzian approach to analyzing mechanical properties of endothelial cells probed by atomic force microscopy.

Abstract: Detailed measurements of cell material properties are required for understanding how cells respond to their mechanical environment. Atomic force microscopy (AFM) is an increasingly popular measurement technique that uniquely combines subcellular mechanical testing with high-resolution imaging. However, the standard method of analyzing AFM indentation data is based on a simplified "Hertz" theory that requires unrealistic assumptions about cell indentation experiments. The objective of this study was to utilize an alternative "pointwise modulus" approach, that relaxes several of these assumptions, to examine subcellular mechanics of cultured human aortic endothelial cells (HAECs). Data from indentations in 2- to 5-microm square regions of cytoplasm reveal at least two mechanically distinct populations of cellular material. Indentations colocalized with prominent linear structures in AFM images exhibited depth-dependent variation of the apparent pointwise elastic modulus that was not observed at adjacent locations devoid of such structures. The average pointwise modulus at an arbitrary indentation depth of 200 nm was 5.6+/-3.5 kPa and 1.5+/-0.76 kPa (mean+/-SD, n=7) for these two material populations, respectively. The linear structures in AFM images were identified by fluorescence microscopy as bundles of f-actin, or stress fibers. After treatment with 4 microM cytochalasin B, HAECs behaved like a homogeneous linear elastic material with an apparent modulus of 0.89+/-0.46 kPa. These findings reveal complex mechanical behavior specifically associated with actin stress fibers that is not accurately described using the standard Hertz analysis, and may impact how HAECs interact with their mechanical environment.

Observation, Analysis, and Simulation of the Hysteresis of Silicon Using Ultra-Micro-Indentation with Spherical Indenters

Abstract: The recently reported hysteretic behavior of silicon under indentation (Clarke et al.1 and Pharret al.2-5) is investigated using an ultra-micro-indentation system with an 8.5 μm spherical-tipped indenter. The onset of “plastic” behavior during loading and hysteresis during unloading was readily observed at loads in excess of 70 mN. Cracking about the residual impression was observed only at loads of 350 mN and higher. An analysis of the data is presented that estimates the following: (1) the initial onset of deformation occurs at a mean pressure of 11.8 ± 0.6 GPa, (2) the mean pressure at higher loads is 11.3 ± 1.3 GPa, and (3) the hysteretic transition on unloading occurs at mean pressures between 7.5 and 9.1 GPa. These values are in good agreement with the accepted literature values for the known silicon transformation pressures. A simulation of the force-displacement data based on the analysis and model is presented and is found to fit the observations very well.