scispace - formally typeset
Search or ask a question
Topic

Magnetorheological fluid

About: Magnetorheological fluid is a research topic. Over the lifetime, 8538 publications have been published within this topic receiving 131502 citations. The topic is also known as: MRF & MR fluid.


Papers
More filters
Journal ArticleDOI
TL;DR: In this article, two kinds of MREs differing in matrix type represented by silicone elastomer and thermoplastic elastomers are prepared, and pristine carbonyl iron (CI) particles and siloxane-modified CI particles were used for each matrix.

65 citations

Journal ArticleDOI
TL;DR: In this paper, a magneto-rheological (MR) fluid variable damper was used for semi-active vibration suppression of a truss beam, and the experimental results showed that the vibration was suppressed nicely by the variable MR damper.
Abstract: The purpose of this paper is to demonstrate that vibrations of a truss structure can be suppressed nicely by a magneto-rheological (MR) fluid variable damper for semiactive vibration suppression. A variable MR fluid damper was designed and fabricated for this study. The principal characteristics of an MR damper were measured in dynamic tests, and a mathematical model of the damper was proposed. To investigate if the variable damper effectively suppresses the vibration of actual truss structures, semiactive vibration suppression experiments were performed using a cantilevered ten-bay truss beam. The experimental result has shown that the vibration was suppressed nicely by the variable MR damper, and that was compared with that of an electro-rheological (ER) damper investigated in previous research. The MR damper showed a higher performance than that of the ER damper.

65 citations

Journal ArticleDOI
TL;DR: In this article, a mixed mode-type magneto-rheological fluid mount (MR mount in short) is devised by considering the nondimensional formulation of Bingham plastic flow, and applied to vibration control of a structural system subjected to external excitations.
Abstract: In this work, a mixed mode-type magneto-rheological fluid mount (MR mount in short) is devised by considering the nondimensional formulation of Bingham plastic flow, and applied to vibration control of a structural system subjected to external excitations. The structural system consists of a vibrating mass, semi-active MR fluid mount, and passive rubber mounts. The MR mount is installed on the beam structure as a semi-active actuator and supports the vibrating mass, while the flexible beam structure is supported by two passive rubber mounts. After verifying the field-dependent damping force characteristics of the MR mount, the governing equation of the structural system is derived in the modal coordinate and rewritten as a state space control model. The linear quadratic Gaussian (LQG) controller is then formulated in order to attenuate vibration of the structural system. The LQG controller is experimentally realized and control responses such as accelerations and transmitted forces of the structural system are presented in the frequency domain.

65 citations

Journal ArticleDOI
15 Feb 2013
TL;DR: In this article, the tensile modulus of magnetorheological elastomers based on magnetically hard particles was determined by measuring small and large strain regimes through mechanical elongation with a table top machine.
Abstract: It has been experimentally determined the tensile modulus of magnetorheological elastomers based on magnetically hard particles. Samples of the elastomer consisting of a soft elastic matrix and micron-sized particles of FeNdB powder have been magnetized in uniform magnetic fields of varying strength in order to provide different remanence magnetizations. The tensile modulus of these samples was measured small and large strain regimes (up to 6.6%) through mechanical elongation with a table top machine. The relative change in the tensile modulus after the sample was magnetized can reach 360%, depending on the remanence magnetization and the strain.

64 citations

Journal ArticleDOI
01 Aug 2018-Polymer
TL;DR: In this article, the possibility of employing a suitable 3D printing technology for the development of one of the smart materials, the magnetorheological elastomer (MRE), has been explored.

64 citations


Network Information
Related Topics (5)
Finite element method
178.6K papers, 3M citations
82% related
Control theory
299.6K papers, 3.1M citations
78% related
Ultimate tensile strength
129.2K papers, 2.1M citations
78% related
Nonlinear system
208.1K papers, 4M citations
77% related
Fracture mechanics
58.3K papers, 1.3M citations
77% related
Performance
Metrics
No. of papers in the topic in previous years
YearPapers
20241
2023283
2022678
2021419
2020512
2019652