Magnetorheological fluid

About: Magnetorheological fluid is a research topic. Over the lifetime, 8538 publications have been published within this topic receiving 131502 citations. The topic is also known as: MRF & MR fluid.

Magnetorheological fluid composites

Abstract: An interesting extension in the use of magnetic fluids has resulted from the development of magnetic fluid composites obtained by dispersing micrometre-sized non-magnetic particles in a magnetic fluid. The composites possess a yield stress in a magnetic field which can be described at sufficiently high strain rates by the Bingham relation , where is the shear stress perpendicular to the applied field, the extrapolated yield stress, the strain rate and the plastic viscosity. Thus, a composite, particle concentration , in a field 0.036 T with has a yield stress of 26 Pa. The yield stresses obtained experimentally for different and correspond well to values predicted theoretically by Rosensweig using a determination of based on a continuum concept of unsymmetric stress that develops in the deformed but unyielded anisotropic medium.

Colloids on the frontier of ferrofluids. Rheological properties.

Abstract: This paper is devoted to the steady-state rheological properties of two new kinds of ferrofluids. One of these was constituted by CoNi nanospheres of 24 nm in diameter, whereas the other by CoNi nanofibers of 56 nm in length and 6.6 nm in width. These ferrofluids were subjected to shear rate ramps under the presence of magnetic fields of different intensity, and the corresponding shear stress values were measured. From the obtained rheograms (shear stress vs shear rate curves) the values of both the static and the dynamic yield stresses were obtained as a function of the magnetic field. The magnetoviscous effect was also obtained as a function of both the shear rate and the magnetic field. The experimental results demonstrate that upon magnetic field application these new ferrofluids develop yield stresses and magnetoviscous effects much greater than those of conventional ferrofluids, based on nanospheres of approximately 10 nm in diameter. Besides some expected differences, such as the stronger magnetorheological effect in the case of ferrofluids based on nanofibers, some intriguing differences are found between the rheological behaviors of nanofiber ferrofluids and nanosphere ferrofluid. First, upon field application the rheograms of nanofiber ferrofluids present N-shaped dependence of the shear stress on the shear rate. The decreasing part of the rheograms takes place at low shear rate. These regions of negative differential viscosity, and therefore, unstable flow is not observed in the case of nanosphere ferrofluids. The second intriguing difference concerns the curvature of the yield stress vs magnetic field curves. This curvature is negative in the case of nanosphere ferrofluid, giving rise to saturation of the yield stress at medium field, as expected. However, in the case of nanofiber ferrofluid this curvature is positive, which means a faster increase of the yield stress with the magnetic field the higher the magnitude of the latter. These interesting differences may be due to the existence of strong interparticle solid friction in the case of nanofiber ferrofluids. Finally, theoretical models for the static yield stress of the ferrofluids were developed. These models consider that upon field application the ferrofluid nanoparticles are condensed in drops of dense phase. These drops tend to be aligned along the field direction, opposing the flow of the ferrofluids and being responsible for the static quasielastic deformation and the yield-stress phenomena. By considering the existence of interparticle dry friction only in the case of nanofiber ferrofluids, the developed models predicted quite well not only the magnitude of the static yield stress but also the differences in curvature of the yield stress vs magnetic field curves.

Valve and position control using magnetorheological fluids

Abstract: Magnetorheological fluids, which solidify in response to a magnetic field, offer the ability to simplify many of the valves and control systems used downhole in the search for and production of oil and gas. They lessen the need for moving parts, provide solid-state valves, and can provide a differential movement of fluid through the valves by varying the strength of the magnetic field. Combinations of permanent and electro-magnets can improve safety by providing valves that fail, when power is lost, in either an open or closed position, depending on design. A number of examples are given.

An Active-damping-compensated Magnetorheological Elastomer Adaptive Tuned Vibration Absorber

Abstract: This article presents the development of an active-damping-compensated magnetorheological elastomer (MRE) adaptive tuned vibration absorber (ATVA). The principle and the vibration attenuation performance of the proposed active-damping-compensated ATVA were theoretically analyzed. Based on the analysis, a prototype was designed and manufactured. Its dynamic properties and vibration attenuation performances were experimentally investigated. The experimental results demonstrated that the damping ratio of the prototype was significantly reduced by the active force. Consequently, its vibration attenuation capability was significantly improved compared with a conventional MRE ATVA.

Dynamic yield stress enhancement in bidisperse magnetorheological fluids

Abstract: Particle-level simulations are employed to investigate the rheological properties of bidisperse magnetorheological fluids. These suspensions are treated as nonlinearly magnetizable, neutrally buoyant, non-Brownian spheres immersed in a nonmagnetizable Newtonian continuous phase. We examine the effects of particle size ratio, composition, and field strength on the dynamic yield stress. The dynamic yield stress of bidisperse suspensions is larger than that of monodisperse suspensions at the same particle volume fraction. The smaller particles cause the larger particles to form more chainlike aggregates than those formed in monodisperse suspensions.