Topic
Nitrobenzene
About: Nitrobenzene is a(n) research topic. Over the lifetime, 5285 publication(s) have been published within this topic receiving 83368 citation(s). The topic is also known as: essence of mirbane & nitrobenzol.
Papers published on a yearly basis
Papers
More filters
TL;DR: The properties of iron metal that make it useful in remediation of chlorinated solvents may also lead to reduction of other groundwater contaminants such as nitro aromatic compounds (NACs) as mentioned in this paper.
Abstract: The properties of iron metal that make it useful in remediation of chlorinated solvents may also lead to reduction of other groundwater contaminants such as nitro aromatic compounds (NACs). Nitrobenzene is reduced by iron under anaerobic conditions to aniline with nitrosobenzene as an intermediate product. Coupling products such as azobenzene and azoxybenzene were not detected. First-order reduction rates are similar for nitrobenzene and nitrosobenzene, but aniline appearance occurs more slowly (typical pseudo-first-order rate constants 3.5 × 10-2, 3.4 × 10-2, and 8.8 × 10-3 min-1, respectively, in the presence of 33 g/L acid-washed, 18−20 mesh Fluka iron turnings). The nitro reduction rate increased linearly with concentration of iron surface area, giving a specific reaction rate constant (3.9 ± 0.2 × 10-2 min-1 m-2 L). The minimal effects of solution pH or ring substitution on nitro reduction rates, and the linear correlation between nitrobenzene reduction rate constants and the square-root of mixing ra...
665 citations
TL;DR: Fenton reagent has been used to test the degradation of different organic compounds in aqueous solution and eliminates the toxic substances and increases the biodegradability of the treated water (measured as the ratio BOD5/COD).
Abstract: Fenton reagent has been used to test the degradation of different organic compounds (formic acid, phenol, 4-chlorophenol, 2,4-dichlorophenol and nitrobenzene) in aqueous solution. A stoichiometric coefficient for the Fenton reaction was found to be 0.5 mol of organic compound/mol of hydrogen peroxide, except for the formic acid where a value of approximately one was obtained (due to the direct formation of carbon dioxide). The treatment eliminates the toxic substances and increases the biodegradability of the treated water (measured as the ratio BOD5/COD). Biodegradability is attained when the initial compound is removed.
568 citations
TL;DR: The oxidation kinetics of butyl chloride, nitrobenzene, anisole, and methylmercury in the presence of hydroxyl radical (OH) scavengers were used to determine the rate and quantum efficiency for production of OH from irradiated nitrate ions in water.
Abstract: The oxidation kinetics of butyl chloride, nitrobenzene, anisole, and methylmercury in the presence of hydroxyl radical (OH) scavengers were used to determine the rate and quantum efficiency for production of OH from irradiated nitrate ions in water. The experiments were conducted under steady-state irradiations with monochromatic radiation (313 nm) and with sunlight. The mean quantum efficiency for OH production at 313 nm rises from 0.013 +/- 0.002 at 20 /sup 0/C to 0.017 +/- 0.003 at 30 /sup 0/C in the pH range 6.2-8.2. Results of this study are used to estimate nitrate-induced photooxidation rates of trace organic chemicals under a variety of environmental conditions. 27 references, 6 figures, 2 tables.
496 citations
TL;DR: An indirect electrochemical method, which is very efficient for the degradation of organic pollutants in water, is described in this paper, which is based on electrocatalytical generation of Fenton's reagent to produce hydroxyl radicals, which are very active toward organic compounds.
Abstract: An indirect electrochemical method, which is very efficient for the degradation of organic pollutants in water, is described. The method, named electro-Fenton, is based on electrocatalytical generation of Fenton's reagent to produce hydroxyl radicals, which are very active toward organic compounds. An industrial pollutant, p-nitrophenol (PNP), was chosen for this study and was eventually mineralized. The major intermediary degradation products such as hydroquinone, benzoquinone, 4-nitrocatechol, 1,2,4-trihydroxybenzene and 3,4,5-trihydroxy- nitrobenzene were unequivocally identified by HPLC and GC-MS methods. The rate constants of the hydroxylation reactions were determined. The mineralization of the initial pollutant and the intermediates formed during electro-Fenton treatment was followed by total organic carbon (TOC) analyses. Dependence of mineralization on the amount of electrical energy consumed is shown by the relative decrease of TOC values. A mineralization reaction mechanism is proposed.
463 citations
TL;DR: In this paper, the effects of carboxylic and carbonyl groups on the adsorption of dissolved aromatics on activated carbon have been studied, and the main mechanisms by which surface oxygen groups influence the adorption capacity were found not to be significant.
Abstract: The effects of oxygen-containing groups, particularly carboxylic and carbonyl groups, on the adsorption of dissolved aromatics on ash-free activated carbon have been studied. Adsorption isotherms for phenol, aniline, nitrobenzene, and benzoic acid were generated in both aqueous and cyclohexane media, using carbons with different amounts of surface oxygen groups. It was found that water adsorption, dispersive/repulsive interactions, and hydrogen-bonding were the main mechanisms by which surface oxygen groups influence the adsorption capacity, while donor–acceptor interactions were found not to be significant. The adsorption mechanism was also found to be influenced by the properties of the functional group on the aromatic adsorbate, especially its ability to hydrogen-bond and through its activating/deactivating influence on the aromatic ring.
408 citations