Organic semiconductor

About: Organic semiconductor is a research topic. Over the lifetime, 15905 publications have been published within this topic receiving 533881 citations.

Highly soluble [1]benzothieno[3,2-b]benzothiophene (BTBT) derivatives for high-performance, solution-processed organic field-effect transistors.

Abstract: 2,7-Dialkyl[1]benzothieno[3,2-b]benzothiophenes were tested as solution-processible molecular semiconductors. Thin films of the organic semiconductors deposited on Si/SiO2 substrates by spin coating have well-ordered structures as confirmed by XRD analysis. Evaluations of the devices under ambient conditions showed typical p-channel FET responses with the field-effect mobility higher than 1.0 cm2 V-1 s-1 and Ion/Ioff of ∼107.

Exciton Diffusion Measurements in Poly(3‐hexylthiophene)

Abstract: The problem of making reliable measurements of exciton diffusion lengths in organic semiconductors is addressed. The exciton diffusion length is an extremely important quantity in the operation of organic solar cells. We focus on the polymer P3HT because of its widespread use in solar cells and are able to fit the exciton diffusion in a range of films with a single diffusion constant, showing that our approach is particularly robust.

Single-wall carbon nanotube/conjugated polymer photovoltaic devices

Abstract: We report the optoelectronic properties occurring in single-walled carbon nanotubes (SWNTs)—conjugated polymer, poly(3-octylthiophene) composites. Composite films were drop or spin cast from a solution on indium–tin oxide (ITO) and quartz substrates and studied using absorption spectroscopy and electrical characterization methods. Diodes (Al/polymer-nanotube composite/ITO) with a low nanotube concentration (<1%) show photovoltaic behavior, with an open circuit voltage of 0.7–0.9 V. The short circuit current is increased by two orders of magnitude compared with the pristine polymer diodes and the fill factor also increases from 0.3 to 0.4 for the nanotube/polymer cells. It is proposed that the main reason for this increase is the photoinduced electron transfer at the polymer/nanotube interface. The results show that the conjugated polymer-SWNTs composite represents an alternative class of organic semiconducting material that is promising for organic photovoltaic cells with improved performance.

Control of carrier density by self-assembled monolayers in organic field-effect transistors

Abstract: Organic thin-film transistors are attracting a great deal of attention due to the relatively high field-effect mobility in several organic materials. In these organic semiconductors, however, researchers have not established a reliable method of doping at a very low density level, although this has been crucial for the technological development of inorganic semiconductors. In the field-effect device structures, the conduction channel exists at the interface between organic thin films and SiO2 gate insulators. Here, we discuss a new technique that enables us to control the charge density in the channel by using organosilane self-assembled monolayers (SAMs) on SiO2 gate insulators. SAMs with fluorine and amino groups have been shown to accumulate holes and electrons, respectively, in the transistor channel: these properties are understood in terms of the effects of electric dipoles of the SAMs molecules, and weak charge transfer between organic films and SAMs.

Pentacene thin film transistors on inorganic dielectrics: Morphology, structural properties, and electronic transport

Abstract: The structural and transport properties of evaporated pentacene organic thin film transistors (TFTs) are reported, and they show the influence of the deposition conditions with different inorganic dielectrics. Dielectrics compatible with large area fabrication were explored to facilitate low cost electronics on glass or flexible plastic substrates. X-ray diffraction and atomic force microscopy show a clear correlation between the morphology and the structure of the highly polycrystalline films for all dielectrics investigated. The roughness of the dielectric has a distinct influence on the morphology and the structural properties, whereas the films on smooth thermal oxide are in general highly ordered and independent of the deposition conditions. The ordered films exhibit a “thin film” and a bulk phase, and the bulk phase volume fraction increases with the deposition temperature and the film thickness. Careful control of the deposition conditions gives virtually identical films on thermal oxide and silico...