Phased array

About: Phased array is a research topic. Over the lifetime, 19428 publications have been published within this topic receiving 229231 citations. The topic is also known as: Phased Array Radar, PAR.

Phaser: enabling phased array signal processing on commodity WiFi access points

Abstract: Signal processing on antenna arrays has received much recent attention in the mobile and wireless networking research communities, with array signal processing approaches addressing the problems of human movement detection, indoor mobile device localization, and wireless network security. However, there are two important challenges inherent in the design of these systems that must be overcome if they are to be of practical use on commodity hardware. First, phase differences between the radio oscillators behind each antenna can make readings unusable, and so must be corrected in order for most techniques to yield high-fidelity results. Second, while the number of antennas on commodity access points is usually limited, most array processing increases in fidelity with more antennas. These issues work in synergistic opposition to array processing: without phase offset correction, no phase-difference array processing is possible, and with fewer antennas, automatic correction of these phase offsets becomes even more challenging. We present Phaser, a system that solves these intertwined problems to make phased array signal processing truly practical on the many WiFi access points deployed in the real world. Our experimental results on three- and five-antenna 802.11-based hardware show that 802.11 NICs can be calibrated and synchronized to a 20° median phase error, enabling inexpensive deployment of numerous phase-difference based spectral analysis techniques previously only available on costly, special-purpose hardware.

A 28GHz Bulk-CMOS dual-polarization phased-array transceiver with 24 channels for 5G user and basestation equipment

Abstract: Developing next-generation cellular technology (5G) in the mm-wave bands will require low-cost phased-array transceivers [1]. Even with the benefit of beamforming, due to space constraints in the mobile form-factor, increasing TX output power while maintaining acceptable PA PAE, LNA NF, and overall transceiver power consumption is important to maximizing link budget allowable path loss and minimizing handset case temperature. Further, the phased-array transceiver will need to be able to support dual-polarization communication. An IF interface to the analog baseband is desired for low power consumption in the handset or user equipment (UE) active antenna and to enable use of arrays of transceivers for customer premises equipment (CPE) or basestation (BS) antenna arrays with a low-loss IF power-combining/splitting network implemented on an antenna backplane carrying multiple tiled antenna modules.

Metascreen-Based Acoustic Passive Phased Array

Abstract: Manipulating sound waves is key in applications such as ultrasound imaging and nondestructive testing. To this end, the authors present an acoustic phased array using a metascreen that transmits sound energy from a single source and steers the outgoing wavefront in the desired direction. Significantly, this metascreen does not itself contain any source of sound, unlike a conventional phased array with many individual sources. This passive array is therefore notably appealing for its simplicity, low cost, and good acoustic performance.

Frequency-shifted feedback cavity used as a phased array antenna controller and carrier interference multiple access spread-spectrum transmitter

Abstract: An optical processor for controlling a phased antenna array uses a frequency-shifted feedback cavity (FSFC), which includes a traveling-wave cavity. The FSFC incrementally delays and incrementally frequency shifts optical signals circulating in the traveling-wave cavity. Optical signals coupled out of the FSFC are separated by frequency, hence by delay, and processed to control either or both transmit and receive beam-forming operations. The FSFC provides a receiver with multiple receive signals which have incremental values of frequency. Each frequency corresponds to an incremental time sampling of optical signals input into the FSFC. Transmit signals coupled out of the FSFC have frequency and phase relationships that result in short time-domain pulses when combined. Controlling modulation and frequency of the transmit signals achieves carrier interference multiple access, a new type of spread-spectrum communications.

Time reversal imaging of obscured targets from multistatic data

Abstract: The methods employed in time-reversal imaging are applied to radar imaging problems using multistatic data collected from sparse and unstructured phased array antenna systems. The theory is especially suitable to problems involving the detection and tracking (locating) of moving ground targets (MGT) from satellite based phased array antenna systems and locating buried or obscured targets from multistatic data collected from phased array antenna systems mounted on unmanned aerial vehicles (UAV). The theory is based on the singular value decomposition (SVD) of the multistatic data matrix K and applies to general phased array antenna systems whose elements are arbitrarily located in space. It is shown that the singular vectors of the K matrix together with knowledge of the Green function of the background medium in which the targets are embedded lead directly to classical time-reversal based images of the target locations as well as super-resolution images based on a generalized Multiple-Signal-Classification algorithm recently developed for use with the K matrix. The theory is applied in a computer simulation study of the TechSat project whose goal is the location of MGTs from an unstructured and sparse phased array of freely orbiting antennas located above the ionosphere.