Topic
Photocatalysis
About: Photocatalysis is a research topic. Over the lifetime, 67088 publications have been published within this topic receiving 2145233 citations. The topic is also known as: photocatalyst.
Papers published on a yearly basis
Papers
More filters
TL;DR: In this paper, pure TiO 2 anatase particles with a crystallite diameters ranging from 4.5 to 29nm were prepared by precipitation and sol-gel method, characterized by X-ray diffraction (XRD), surface area measurement, UV-vis and scanning electron microscopy (SEM) and tested in CO 2 photocatalytic reduction.
Abstract: Pure TiO 2 anatase particles with a crystallite diameters ranging from 4.5 to 29 nm were prepared by precipitation and sol–gel method, characterized by X-ray diffraction (XRD), BET surface area measurement, UV–vis and scanning electron microscopy (SEM) and tested in CO 2 photocatalytic reduction. Methane and methanol were the main reduction products. The optimum particle size corresponding to the highest yields of both products was 14 nm. The observed optimum particle size is a result of competing effects of specific surface area, charge–carrier dynamics and light absorption efficiency.
459 citations
TL;DR: In this paper, a chemically bonded TiO2/graphene composites with a chemically-bonded interface were prepared by a facile solvothermal method using tetrabutyl orthotitanate (TBOT) as the Ti source.
Abstract: Recently, graphene-based semiconductor photocatalysts have attracted more attention because of their enhanced photocatalytic activity caused by interfacial charge transfer (IFCT). However, the effect of a chemical bond is rarely involved for the IFCT. In this work, TiO2/graphene composites with a chemically bonded interface were prepared by a facile solvothermal method using tetrabutyl orthotitanate (TBOT) as the Ti source. The chemically bonded TiO2/graphene composites effectively enhanced their photocatalytic activity in photodegradation of formaldehyde in air, and the graphene content exhibited an obvious influence on the photocatalytic activity. The prepared composite with 2.5 wt % graphene (G2.5-TiO2) showed the highest photocatalytic activity, exceeding that of Degussa P25, as-prepared pure TiO2 nanoparticles, and the mechanically mixed TiO2/graphene (2.5 wt %) composite by a factor of 1.5, 2.6, and 2.3, respectively. The enhancement in the photocatalytic activity was attributed to the synergetic ef...
458 citations
TL;DR: In this paper, a metal-free carbon doping-carbon nitride (BCM-C 3 N 4 ) nanocomposite was synthesized by introducing barbituric acid and cyanuric acids during the polymerization of melamine.
Abstract: Many organic and inorganic compounds have been developed as visible light driven photocatalysts for environment and energy application. In this work, a metal-free carbon doping–carbon nitride (BCM-C 3 N 4 ) nanocomposite was synthesized by introducing barbituric acid and cyanuric acid during the polymerization of melamine. The BCM-C 3 N 4 was characterized by structure, porosity, optical performance, and photoelectrochemical properties. Results demonstrated that BCM-C 3 N 4 sample exhibited higher surface area, lower fluorescence intensity, better photocurrent signals and more efficient charge transfer in comparison to pure C 3 N 4 . The BCM-C 3 N 4 exhibits excellent photocatalytic degradation ability of sulfamethazine (SMZ) under visible light irradiation. Much superior photocatalytic activity and high pollutant mineralization rate was achieved by BCM-C 3 N 4 , where it was 5 times than that of pristine C 3 N 4 . The effect of initial SMZ concentrations on photocatalyst was also investigated. Additionally, the trapping experiments and electron spin resonance tests demonstrated that the main active species, such as O 2 − and h + , could be produced under light irradiation. This work might provide an effective approach to the design of low-cost and highly efficient photocatalysis degradation systems for water treatment.
458 citations
TL;DR: In this paper, a detailed degradation pathway has been determined by careful identification of intermediate products, in particular, carboxylic acids, whose decarboxylation by photo-Kolbe reactions constitutes the main source of CO2 evolution.
456 citations
TL;DR: In this paper, a simple sonoelectrochemical anodization method was proposed to grow smooth and ultrathin (5−7 nm thick) Fe2O3 nanotube arrays (3−4 μm long) on Fe foil in as little as 13 min.
Abstract: One-dimensional nanostructures exhibit quantum confinement that leads to unique electronic properties, making them attractive as the active elements for various applications. Iron oxide (α-Fe2O3 or hematite) nanotubes are of particular interest in catalysis, sensor devices, Li-ion battery, environmental remediation and photocatalysis. Here, we report a simple sonoelectrochemical anodization method to grow smooth and ultrathin (5−7 nm thick) Fe2O3 nanotube arrays (3−4 μm long) on Fe foil in as little as 13 min. The prepared catalyst has shown tremendous potential to split water to generate hydrogen under solar light illumination. A photocurrent density of 1.41 mA/cm2 is observed for hematite nanotube arrays with more than 50% being contributed by the visible light components of the solar spectrum.
456 citations