Potassium iodate

About: Potassium iodate is a research topic. Over the lifetime, 611 publications have been published within this topic receiving 5940 citations. The topic is also known as: KIO3.

Kinetic spectrophotometric method for the determination of ramipril in pharmaceutical formulations.

Abstract: The objective of this research was to develop a kinetic spectrophotometric method for determination of ramipril in pure form and pharmaceutical formulations. The method was based on the reaction of carboxylic acid group of the drug with a mixture of potassium iodate (KIO3) and potassium iodide (KI) in aqueous medium at room temperature. The reaction is followed spectrophotometrically by measuring the increase in absorbance at 352 nm as a function of time. The initial-rate and fixed-time methods were adopted for constructing the calibration curves. Both the calibration curves were linear in the concentration range of 10.0–70.0 μg mL−1. The detection limits were 0.02μg mL−1 and 0.15-μg mL−1 for initial rate and fixed time methods, respectively. The proposed methods are validated statistically and through recovery studies. The point and interval hypothesis tests have been performed confirming that there is no significant difference between the proposed methods and the reference method. The experimental true bias of all samples is less than ±2%. The methods have been successfully applied to the determination of ramipril in tablets and capsules.

Fast Colorimetric Method for Measuring Urinary Iodine

Abstract: International groups recommend the following median urinary iodine concentration as the best single indicator of iodine nutrition in populations: severe deficiency, 0–0.15 μmol/L (0–19 μg/L); moderate deficiency, 0.16–0.38 μmol/L (20–49 μg/L); mild deficiency, 0.40–0.78 μmol/L (50–99 μg/L); optimal iodine nutrition, 0.79–1.56 μmol/L (100–199 μg/L); more than adequate iodine intake, 1.57–2.36 μmol/L (200–299 μg/L); and excessive iodine intake, ≥2.37 μmol/L (≥300 μg/L) (1). The range in which the median falls is more important than the precise number (2)(3). Many methods for assessing urinary iodine exist (3)(4)(5)(6)(7)(8), most based on the Sandell–Kolthoff reaction (9), in which iodide catalyzes the reduction of ceric ammonium sulfate (yellow) to the colorless cerous form in the presence of arsenious acid. Although iodide is the chemical form for both the catalytic reaction and in urine, some preliminary treatment is needed to rid urine of impurities, most commonly by acid digestion (3)(5). We have extended previous approaches (5)(6)(10) with improved conditions and here present a new method (“Fast B”) that is rapid, inexpensive, reliable, and flexible. The equipment required for the Fast B method includes a heating block, Pyrex test tubes (13 × 100 mm), two fixed-volume pipettes (0.5 mL and 1.0 mL), one adjustable pipette (0–200 μL), and a multipet (Eppendorf) for quick reagent volume additions of 0.125 and 0.1 mL. The basic chemicals used are potassium iodate, arsenic trioxide, ammonium persulfate, ammonium cerium(IV) sulfate dihydrate, sodium chloride, ferroine, and sulfuric acid. The solutions used in the assay are as follows:

Kinetic aspects of the Bray–Liebhafsky oscillatory reaction

Abstract: The decomposition of hydrogen peroxide in the presence of potassium iodate and sulphuric acid (the Bray–Liebhafsky oscillatory reaction) at constant temperature is elucidated. The forms of the time evolution of this process and some kinetic parameters are presented as a function of the concentrations of the reactants.