Pulse duration

About: Pulse duration is a research topic. Over the lifetime, 19429 publications have been published within this topic receiving 286507 citations.

53-attosecond X-ray pulses reach the carbon K-edge

Abstract: The motion of electrons in the microcosm occurs on a time scale set by the atomic unit of time—24 attoseconds. Attosecond pulses at photon energies corresponding to the fundamental absorption edges of matter, which lie in the soft X-ray regime above 200 eV, permit the probing of electronic excitation, chemical state, and atomic structure. Here we demonstrate a soft X-ray pulse duration of 53 as and single pulse streaking reaching the carbon K-absorption edge (284 eV) by utilizing intense two-cycle driving pulses near 1.8-μm center wavelength. Such pulses permit studies of electron dynamics in live biological samples and next-generation electronic materials such as diamond. Isolated attosecond pulses are produced using high harmonic generation and sources of these pulses often suffer from low photon flux in soft X-ray regime. Here the authors demonstrate efficient generation and characterization of 53 as pulses with photon energy near the water window.

Sonoporation by ultrasound-activated microbubble contrast agents: effect of acoustic exposure parameters on cell membrane permeability and cell viability

Abstract: This work investigates the effect of ultrasound exposure parameters on the sonoporation of KHT-C cells in suspension by perflutren microbubbles. Variations in insonating acoustic pressure (0.05 to 3.5 MPa), pulse frequency (0.5 to 5.0 MHz), pulse repetition frequency (10 to 3000 Hz), pulse duration (4 to 32 micros) and insonation time (0.1 to 900 s) were studied. The number of cells permeabilised to a fluorescent tracer molecule (70 kDa FITC-dextran) and the number of viable cells were measured using flow cytometry. The effect of exposure on the microbubble population was measured using a Coulter counter. Cell viability and membrane permeability were found to depend strongly on the acoustic exposure conditions. Cell permeability increased and viability decreased with increasing peak negative pressure, pulse repetition frequency, pulse duration and insonation time and with decreasing pulse centre frequency. The highest therapeutic ratio (defined as the ratio of permeabilised to nonviable cells) achieved was 8.8 with 32 +/- 4% permeabilization and 96 +/- 1% viability at 570 kPa peak negative pressure, 8 micros pulse duration, 3 kHz pulse repetition frequency, 500 kHz centre frequency and 12 s insonation time with microbubbles at 3.3% volume concentration. These settings correspond to an acoustic energy density (E(SPPA)) of 3.12 J/cm(2). Cell permeability and viability did not correlate with bubble disruption. The results indicate that ultrasound exposure parameters can be optimized for therapeutic sonoporation and that bubble disruption is a necessary but insufficient indicator of ultrasound-induced permeabilization.

Versatile multi-wavelength ultrafast fiber laser mode-locked by carbon nanotubes.

Abstract: Multi-wavelength lasers have widespread applications (e.g. fiber telecommunications, pump-probe measurements, terahertz generation). Here, we report a nanotube-mode-locked all-fiber ultrafast oscillator emitting three wavelengths at the central wavelengths of about 1540, 1550 and 1560 nm, which are tunable by stretching fiber Bragg gratings. The output pulse duration is around 6 ps with a spectral width of ~0.5 nm, agreeing well with the numerical simulations. The triple-laser system is controlled precisely and insensitive to environmental perturbations with <0.04% amplitude fluctuation. Our method provides a simple, stable, low-cost, multi-wavelength ultrafast-pulsed source for spectroscopy, biomedical research and telecommunications.

Millijoule pulse energy high repetition rate femtosecond fiber chirped-pulse amplification system

Abstract: We report on an ytterbium-doped fiber chirped-pulse amplification (CPA) system delivering millijoule level pulse energy at repetition rates above 100 kHz corresponding to an average power of more than 100 W. The compressed pulses are as short as 800 fs. As the main amplifier, an 80 μm core diameter short length photonic crystal fiber is employed, which allows the generation of pulse energies up to 1.45 mJ with a B-integral as low as 7 at a stretched pulse duration of 2 ns. A stretcher-compressor unit consisting of dielectric diffraction gratings is capable of handling the average power without beam and pulse quality distortions. To our knowledge, we present the highest pulse energy ever extracted from fiber based femtosecond laser systems, and a nearly 2 orders of magnitude higher repetition rate than in previously published millijoule-level fiber CPA systems.