scispace - formally typeset
Search or ask a question
Topic

Sawdust

About: Sawdust is a research topic. Over the lifetime, 5526 publications have been published within this topic receiving 86499 citations. The topic is also known as: wood dust & hard wood dust.


Papers
More filters
Journal ArticleDOI
TL;DR: In this paper, sawdust from three Ghanaian wood species (Triplochiton scleraxylon, Ceiba pentandra and Terminalia superba) were collected and their cellulose, hemicelluloses, lignin and nitrogen contents determined using standard methods.
Abstract: The objective of this study was to find out if the sawdust generated from some of the Ghanaian wood species can be used in the cultivation of pleurotus ostreatus (oyster mushroom) and their subsequent effect on the quality and yield of the mushrooms produced. Sawdust from three Ghanaian wood species (Triplochiton scleraxylon, Ceiba pentandra and Terminalia superba) were collected and their cellulose, hemicelluloses, lignin and nitrogen contents determined using standard methods. Triplochiton scleraxylon gave 46.76%, 15.69%, 27.55%, 0.01% w/w, Ceiba pentandra gave 44.79%, 15.32%, 34.08%, 0.02% w/w and Terminalia superba gave 46.64%, 16.29%, 31.17%, 0.02% w/w of the cellulose, hemicelluloses, lignin and nitrogen content respectively. Compost was then made from each of the wood and used as substrate for the cultivation of pleurotus ostreatus. The highest yield of mushroom was obtained from T. scleraxylon 334g followed by T. superba 277 g and C. pentandra gave the lowest yield of 193 g fresh weight after 3 flushes. The proximate composition of the mushrooms produced gave crude protein ranging 16.33 - 18.20, fat 1.67 - 2.07, carbohydrate 40.86 - 50.53, fibre 4.14 - 6.73 and ash content of 4.40% - 5.80%. The report has shown that the yield and nutritional content of the oyster mushroom on sawdust depends on the chemical constituents such as the cellulose content, the hemicellulose content, the lignin content, the nitrogen content of the particular substrate used. Triplochiton scleraxylon gave the best yield and nutritional content, considering that these substrates are freely available and regarded as “waste”, it can be used to cultivate edible mushrooms to supplement nutritional requirement and source of income to make life better for many people.

35 citations

Journal ArticleDOI
TL;DR: In this paper, a surface reaction methodology was employed for the optimization of cadmium removal onto sawdust with respect to various physico-chemical parameters, and the biosorption equilibrium data were best represented by Khan and Langmuir isotherms.
Abstract: Surface reaction methodology was employed for the optimization of cadmium removal onto sawdust with respect to various physico-chemical parameters. FT-IR was principally employed for the assessment of the chemical structure of sawdust. The biosorption equilibrium data were best represented by Khan and Langmuir isotherms. The monolayer sorption capacity obtained from Langmuir model was found to be 41.21 mg/g. Biosorption showed pseudo second order rate kinetics at different initial concentration of Cd(II). The intraparticle diffusion study indicated that film diffusion may be involved in the current study. Thermodynamic parameters showed that the sorption process is exothermic and non-spontaneous.

35 citations

Journal ArticleDOI
TL;DR: Two kinds of pinewood sawdust activated carbon adsorbents were prepared by fast activation with H3PO4 in a spouted bed, and it was found that the P-containing groups also involved in the adsorption of copper ion.
Abstract: Two kinds of pinewood sawdust activated carbon adsorbents were prepared by fast activation with H3PO4 in a spouted bed, and the application in adsorption of copper ions was investigated. With only 3 min of activation time, the BET surface area of activated carbons reached 1537.5 m2/g for impregnation mass ratio of H3PO4 to sawdust at 1:1 and activation temperature of 500 °C (IR1-500), whereas it was 1750.7 m2/g for the impregnation ratio at 4:1 and activation temperature of 800 °C (IR4-800). The pseudo second-order reaction kinetics well describes the experimental adsorption of copper ion in this study, indicating chemisorption dominated in the process. By the C1s spectrum, activated carbons from IR1-500 contained more carboxyl groups (-COOH) and carbonyl groups (C=O), which played an important role in copper ions adsorption. In addition, it was found that the P-containing groups (metaphosphates) also involved in the adsorption of copper ion.

35 citations

Journal ArticleDOI
TL;DR: Analysis of the chemical structure of liquid products of the pinewood sawdust co-pyrolysis with polystyrene and polypropylene with and without the zinc chloride as an additive proved that the structure and the quality of bio-oil strongly depend on both the composition of the blend and the presence of ZnCl(2) as a additive.

35 citations

Journal ArticleDOI
TL;DR: In this article, the authors evaluated the impact of various nanofibrillation degrees of waste sawdust generated from the primary processing of different hardwood species on the physical properties of CNF films.
Abstract: The production of cellulose nanofibrils (CNFs) from Amazonian wood wastes could reduce pollution and raw material costs for cellulose industry. Further studies are required to analyze the feasibility of using hardwood sawdust for the production of high-quality CNF films. Therefore, the objective of this study was to evaluate the impact of various nanofibrillation degrees of waste sawdust generated from the primary processing of different hardwood species on the physical properties of CNF films. Raw sawdust was submitted to alkaline and bleaching pre-treatments. The chemical composition of the bleached fibers was determined. The CNFs were obtained by mechanical shearing of the bleached fibers using a grinder Super MassColloider after 10, 20, 30 and 40 passages. CNFs were evaluated by transmission electron microscopy. The CNF films were formed by the casting method. Residual lignin and hemicelluloses content greatly varied among species after bleaching. No clear influence of the number of passages on apparent density was observed. None of the films was degraded in significant amounts after water immersion. Water vapor absorption (WVA) consistently decreased with more passages through the Super MassColloider for Amazonian species until 30 passages. Residual hemicelluloses of the bleached fibers adversely affected WVA. Bleached fibers made of highly purified cellulose or containing residual lignin showed lower WVA after 30 and 40 passages. Water vapor permeability showed consistent relation with the apparent density of the films. For hardwood wastes, 10–30 passages through the grinder are recommended.

35 citations


Network Information
Related Topics (5)
Biomass
57.2K papers, 1.4M citations
85% related
Cellulose
59K papers, 1.4M citations
84% related
Wastewater
92.5K papers, 1.2M citations
79% related
Fermentation
68.8K papers, 1.2M citations
79% related
Sorption
45.8K papers, 1.3M citations
78% related
Performance
Metrics
No. of papers in the topic in previous years
YearPapers
2023443
2022827
2021331
2020323
2019383
2018334