Shields

About: Shields is a research topic. Over the lifetime, 1456 publications have been published within this topic receiving 10896 citations.

New Shielding Materials for High-Temperature Application

Abstract: Investigation and development of several new materials for high-temperature shields have yielded three reasonably cheap materials which are structurally stable and able to withstand high temperatur

Designing Space Vehicle Shields for Meteoroid Protection - a New Analysis

Abstract: A new analysis for designing dual-layer shields is presented which is based on energy and momentum conservation, fundamental electromagnetic radiation physics, and the observation of results of extensive experimental impact studies performed at relatively low velocities (near 7 km/s). An important finding is that most of the kinetic energy of a meteoroid striking a dual-layer shield is expended as radiation at the stagnation zone on the face plate of the underlying structure. Systematic procedures for evaluating the response of shield designs for a given impact threat are described. It is noted that similar applications of the analysis can be employed to support a mathematically rigorous procedure for optimum shield design.

Minimum attenuation of spherical shields

Abstract: In this communication, a simple formula for the minimum attenuation of incoming plane waves in spherical shields is presented for practical purposes. This worst case condition is attained when the TM 011 resonance occurs in the room. The medium inside and outside the shield is air and the material is supposed to be well conducting.

Developed a New Radiation Shielding Absorber Composed of Waste Marble, Polyester, PbCO3, and CdO to Reduce Waste Marble Considering Environmental Safety

Abstract: The usage of radiation is mandatory for modern life; in the same manner, controlling the outflow of harmful radiation is vital and could be achieved via employing a shielding material to eliminate any potential nuclear and radiation accidents and incidents. Considering this point, this study aims to manufacture composite samples based on waste marble as novel radiation shields. The physical and radiation shielding ability of the prepared shields were determined and analyzed. For this purpose, a high-purity germanium (HPGe) detector was used to detect the incoming photons emitted from three point sources (Am-241, Cs-137, and Co-60). The radiation attenuation factors for the new marble-based composites were measured for some energies, ranging from 0.06 to 1.333 MeV. We examined the effect of increasing the PbCO3 and CdO contents on the physical properties and radiation attenuation factors of the newly developed radiation shielding absorber. We found that the density of the samples increases from 1.784 to 1.796 g/cm3 when the CdO changes from 0 to 12.5 wt%. The linear attenuation coefficient (LAC) for all marble compositions has the maximum value at 0.06 MeV, while the LAC decreases with increasing energy. The highest LAC was found for Marb-3, with a composition of waste marble (50 wt%), polyester (25 wt%), PbCO3 (17.5 wt%), and CdO (7.5 wt%). We studied the impact of the addition of CdO on the expense of PbCO3 and we found that the half value layer (HVL) decreases with increasing the CdO content. Hence, when there is no space problem, the newly developed radiation shielding absorber can be used to maintain the cost effectiveness and environmentally friendliness of products.