Sonication

About: Sonication is a research topic. Over the lifetime, 2943 publications have been published within this topic receiving 84280 citations.

High-concentration solvent exfoliation of graphene.

Abstract: A method is demonstrated to prepare graphene dispersions at high concentrations, up to 1.2 mg mL(-1), with yields of up to 4 wt% monolayers. This process relies on low-power sonication for long times, up to 460 h. Transmission electron microscopy shows the sonication to reduce the flake size, with flake dimensions scaling as t(-1/2). However, the mean flake length remains above 1 microm for all sonication times studied. Raman spectroscopy shows defects are introduced by the sonication process. However, detailed analysis suggests that predominantly edge, rather than basal-plane, defects are introduced. These dispersions are used to prepare high-quality free-standing graphene films. The dispersions can be heavily diluted by water without sedimentation or aggregation. This method facilitates graphene processing for a range of applications.

High-concentration, surfactant-stabilized graphene dispersions.

Abstract: A method is presented to produce graphene dispersions, stabilized in water by the surfactant sodium cholate, at concentrations up to 0.3 mg/mL. The process uses low power sonication for long times (up to 400 h) followed by centrifugation to yield stable dispersions. The dispersed concentration increases with sonication time while the best quality dispersions are obtained for centrifugation rates between 500 and 2000 rpm. Detailed TEM analysis shows the flakes to consist of 1−10 stacked monolayers with up to 20% of flakes containing just one layer. The average flake consists of ∼4 stacked monolayers and has length and width of ∼1 μm and ∼400 nm, respectively. These dimensions are surprisingly stable under prolonged sonication. However, the mean flake length falls from ∼1 μm to ∼500 nm as the centrifugation rate is increased from 500 to 5000 rpm. Raman spectroscopy shows the flake bodies to be relatively defect-free for centrifugation rates below 2000 rpm. The dispersions can be easily cast into high-qualit...

Enhanced Antibacterial Activity of Nanocrystalline ZnO Due to Increased ROS-Mediated Cell Injury

Abstract: An innovative study aimed at understanding the influence of the particle size of ZnO (from the microscale down to the nanoscale) on its antibacterial effect is reported herein. The antibacterial activity of ZnO has been found to be due to a reaction of the ZnO surface with water. Electron-spin resonance measurements reveal that aqueous suspensions of small nanoparticles of ZnO produce increased levels of reactive oxygen species, namely hydroxyl radicals. Interestingly, a remarkable enhancement of the oxidative stress, beyond the level yielded by the ZnO itself, is detected following the antibacterial treatment. Likewise, an exposure of bacteria to the small ZnO nanoparticles results in an increased cellular internalization of the nanoparticles and bacterial cell damage. An examination of the antibacterial effect is performed on two bacterial species: Escherichia coli (Gram negative) and Staphylococcus aureus (Gram positive). The nanocrystalline particles of ZnO are synthesized using ultrasonic irradiation, and the particle sizes are controlled using different solvents during the sonication process. Taken as a whole, it is apparent that the unique properties (i.e., small size and corresponding large specific surface area) of small nanometer-scale ZnO particles impose several effects that govern its antibacterial action. These effects are size dependent and do not exist in the range of microscale particles.