Topic
Surface roughness
About: Surface roughness is a research topic. Over the lifetime, 70112 publications have been published within this topic receiving 1084515 citations. The topic is also known as: roughness & texture.
Papers published on a yearly basis
Papers
More filters
TL;DR: In this article, the authors used the atomic force microscope to measure the forces between a planar surface and an individual colloid particle, a silica sphere of radius 3.5 µm, attached to the force sensor in the microscope and measured in solutions of sodium chloride.
Abstract: THE forces between colloidal particles dominate the behaviour of a great variety of materials, including paints, paper, soil, clays and (in some circumstances) cells. Here we describe the use of the atomic force microscope to measure directly the force between a planar surface and an individual colloid particle. The particle, a silica sphere of radius 3.5 µm, was attached to the force sensor in the microscope and the force between the particle and the surface was measured in solutions of sodium chloride. The measurements are consistent with the double-layer theory1,2 of colloidal forces, although at very short distances there are deviations that may be attributed to hydration forces3–6 or surface roughness, and with previous studies on macroscopic systems4–6. Similar measurements should be possible for a wide range of the particulate and fibrous materials that are often encountered in industrial contexts, provided that they can be attached to the microscope probe.
1,900 citations
1,882 citations
TL;DR: This work describes a simple and inexpensive method for forming a superhydrophobic coating using polypropylene (a simple polymer) and a suitable selection of solvents and temperature to control the surface roughness.
Abstract: Superhydrophobic surfaces are generally made by controlling the surface chemistry and surface roughness of various expensive materials, which are then applied by means of complex time-consuming processes. We describe a simple and inexpensive method for forming a superhydrophobic coating using polypropylene (a simple polymer) and a suitable selection of solvents and temperature to control the surface roughness. The resulting gel-like porous coating has a water contact angle of 160 degrees. The method can be applied to a variety of surfaces as long as the solvent mixture does not dissolve the underlying material.
1,692 citations
TL;DR: A superhydrophobic surface is a surface with a water contact angle close to or higher than 150° as discussed by the authors, and it is the combination of surface roughness and low-surface-energy modification that leads to super-hydrophobicity.
Abstract: A superhydrophobic surface is a surface with a water contact angle close to or higher than 150°. In this feature article, we review the historical and present research on superhydrophobic surfaces, including the characterization of superhydrophobicity, different ways to fabricate rough surfaces, and low-surface-energy modifications on inorganic and organic rough surfaces. It is the combination of surface roughness and low-surface-energy modification that leads to superhydrophobicity. Notably, research on superhydrophobic surfaces has not only fundamental interest but various possible functional applications in micro- and nano-materials and devices.
1,588 citations
01 Jun 1970
TL;DR: In this article, the authors give a general theory of contact between two rough plane surfaces and show that the important results of the previous models are unaffected: in particular, the load and the area of contact remain almost proportional, independently of the detailed mechanical and geometrical properties of the asperities.
Abstract: Most models of surface contact consider the surface roughness to be on one of the contacting surfaces only. The authors give a general theory of contact between two rough plane surfaces. They show that the important results of the previous models are unaffected: in particular, the load and the area of contact remain almost proportional, independently of the detailed mechanical and geometrical properties of the asperities. Further, a single-rough-surface model can always be found which will predict the same laws as a given two-rough-surface model, although the required model may be unrealistic. It does not seem possible to deduce the asperity shape or deformation mode from the load-compliance curve.
1,435 citations