Topic
Thermogravimetric analysis
About: Thermogravimetric analysis is a research topic. Over the lifetime, 37248 publications have been published within this topic receiving 862144 citations. The topic is also known as: thermal gravimetric analysis & TGA.
Papers published on a yearly basis
Papers
More filters
••
TL;DR: In this paper, different compositions of polyvinyl alcohol (PVA) and carboxymethyl cellulose (CMC) blends have been prepared using the casting method using differential scanning calorimetery (DSC), TGA and dielectric spectroscopy of all compositions.
Abstract: Films with different compositions of polyvinyl alcohol (PVA) and carboxymethyl cellulose (CMC) blends have been prepared using the casting method. Differential scanning calorimetery (DSC), thermogravimetric analysis (TGA) and dielectric spectroscopy of all compositions have been investigated. It was found that PVA and CMC are compatible in the studied range of composition. With increasing CMC content, the thermal stability of PVA increases. Based on DSC and TGA data, the activation energies of all the investigated samples were calculated. The absorption edge ( E a ) was also determined from Ultraviolet–visible (UV–vis) spectra. Dielectric permittivity, loss tangent and ac conductivity of all samples were studied as functions of temperature and frequency. The results show that the dielectric dispersion consists of both dipolar and interfacial polarization. The frequency dependence of the ac conductivity indicates that the correlated barrier hopping (CBH) is the most suitable mechanism for conduction. The polaron binding energy ( U M ) was determined. Results of the present system are compared with those of similar materials.
222 citations
••
TL;DR: In this paper, the graft densities of polymers on the surfaces of magnetite particles were estimated at 0.12−0.20 chains/nm2 by thermogravimetric analysis (TGA).
Abstract: Polymer-grafted magnetite (Fe3O4) nanoparticles (diameter about 10 nm) were prepared through a direct polymer grafting reaction from their surfaces. The chemisorbed initiator (TEMPO-based alkoxyamine) for nitroxide-mediated radical polymerization with a phosphoric acid group gave controlled polystyrene (PS) and poly(3-vinylpyridine) (P3VP) graft layers on the surface. The graft densities of polymers on the surfaces of magnetite particles were estimated at 0.12−0.20 chains/nm2 by thermogravimetric analysis (TGA). The improvement in the dispersibility of PS-modified magnetite in good solvents was verified by ultraviolet−visible (UV−vis) absorption spectroscopy, transmission electron microscopy (TEM), and dynamic light scattering (DLS). In the case of P3VP-modified magnetite, the particles were stably dispersed in good solvents, by protonation, in acid solution, and by quarternization with iodomethane, in neutral aqueous solution. The magnetic response of the polymer-grafted magnetite against an external mag...
222 citations
••
TL;DR: PAS-GO had a priority tendency to adsorb Pb, Cu and Fe from a mixed solution of metal ions, especially from a practical industrial effluent, especially in removing Pb(II) ions from water.
222 citations
••
TL;DR: In this paper, a composite phase change materials (PCM) for latent heat thermal energy storage was made by mixing two different kinds of exfoliated graphite nanoplatelets into paraffin wax.
222 citations
••
TL;DR: In this article, the effects of anion type, C-2 hydrogen substitution, and alkyl chain length on the flammability, thermal stability, and phase change characteristics of 1,2,3-trialkylimidazolium room temperature ionic liquids were investigated.
222 citations