Transmitter

About: Transmitter is a research topic. Over the lifetime, 61975 publications have been published within this topic receiving 874216 citations. The topic is also known as: radio transmitter & xmitter.

Performance of optimum transmitter power control in cellular radio systems

Abstract: Most cellular radio systems provide for the use of transmitter power control to reduce cochannel interference for a given channel allocation. Efficient interference management aims at achieving acceptable carrier-to-interference ratios in all active communication links in the system. Such schemes for the control of cochannel interference are investigated. The effect of adjacent channel interference is neglected. As a performance measure, the interference (outage) probability is used, i.e., the probability that a randomly chosen link is subject to excessive interference. In order to derive upper performance bounds for transmitter power control schemes, algorithms that are optimum in the sense that the interference probability is minimized are suggested. Numerical results indicate that these upper bounds exceed the performance of conventional systems by an order of magnitude regarding interference suppression and by a factor of 3 to 4 regarding the system capacity. The structure of the optimum algorithm shows that efficient power control and dynamic channel assignment algorithms are closely related. >

Information theoretic considerations for cellular mobile radio

Abstract: We present some information-theoretic considerations used to determine upper bounds on the information rates that can be reliably transmitted over a two-ray propagation path mobile radio channel model, operating in a time division multiplex access (TDMA) regime, under given decoding delay constraints. The sense in which reliability is measured is addressed, and in the interesting eases where the decoding delay constraint plays a significant role, the maximal achievable rate (capacity), is specified in terms of capacity versus outage. In this case, no coding capacity in the strict Shannon sense exists. Simple schemes for time and space diversity are examined, and their potential benefits are illuminated from an information-theoretic stand point. In our presentation, we chose to specialize to the TDMA protocol for the sake of clarity and convenience. Our main arguments and results extend directly to certain variants of other multiple access protocols such as code division multiple access (CDMA) and frequency division multiple access (FDMA), provided that no fast feedback from the receiver to the transmitter is available. >

Communication Over MIMO X Channels: Interference Alignment, Decomposition, and Performance Analysis

Abstract: In a multiple-antenna system with two transmitters and two receivers, a scenario of data communication, known as the X channel, is studied in which each receiver receives data from both transmitters. In this scenario, it is assumed that each transmitter is unaware of the other transmitter's data (noncooperative scenario). This system can be considered as a combination of two broadcast channels (from the transmitters' points of view) and two multiple-access channels (from the receivers' points of view). Taking advantage of both perspectives, two signaling schemes for such a scenario are developed. In these schemes, some linear filters are employed at the transmitters and at the receivers which decompose the system into either two noninterfering multiple-antenna broadcast subchannels or two noninterfering multiple-antenna multiple-access subchannels. The main objective in the design of the filters is to exploit the structure of the channel matrices to achieve the highest multiplexing gain (MG). It is shown that the proposed noncooperative signaling schemes outperform other known noncooperative schemes in terms of the achievable MG. In particular, it is shown that in some specific cases, the achieved MG is the same as the MG of the system if full cooperation is provided either between the transmitters or between the receivers. In the second part of the paper, it is shown that by using mixed design schemes, rather than decomposition schemes, and taking the statistical properties of the interference terms into account, the power offset of the system can be improved. The power offset represents the horizontal shift in the curve of the sum-rate versus the total power in decibels.

Design of low-density parity-check codes for modulation and detection

Abstract: A coding and modulation technique is studied where the coded bits of an irregular low-density parity-check (LDPC) code are passed directly to a modulator. At the receiver, the variable nodes of the LDPC decoder graph are connected to detector nodes, and iterative decoding is accomplished by viewing the variable and detector nodes as one decoder. The code is optimized by performing a curve fitting on extrinsic information transfer charts. Design examples are given for additive white Gaussian noise channels, as well as multiple-input, multiple-output (MIMO) fading channels where the receiver, but not the transmitter, knows the channel. For the MIMO channels, the technique operates within 1.25 dB of capacity for various antenna configurations, and thereby outperforms a scheme employing a parallel concatenated (turbo) code by wide margins when there are more transmit than receive antennas.

Wireless medical diagnosis and monitoring equipment

Abstract: The invention concerns medical diagnosis and monitoring equipment with wireless electrodes (2a...2f) designed to be secured to the skin of the patient (3). The electrodes (2a...2f) include, as well as microsensors, a digital transmitter (31) and receiver (30) unit and an antenna (36a). The electrodes (2a...2f) can be used, for instance, to detect EEG and ECG signals or to monitor body/berathing movements, temperature or perspiration. A preferred embodiment has an electrode which incorporates all functions in a semiconductor chip designed as an integrated circuit with the appropriate sensor, sensor-control, frequency-generation, transmitter and receiver units plus a switching control unit. The antenna (36a) can be mounted either in the flexible electrode covering or directly on the chip.