scispace - formally typeset
Search or ask a question
Topic

Voltage droop

About: Voltage droop is a research topic. Over the lifetime, 14594 publications have been published within this topic receiving 206342 citations.


Papers
More filters
Journal ArticleDOI
TL;DR: In this article, a power control strategy for a low-voltage microgrid is proposed, where the mainly resistive line impedance, the unequal impedance among distributed generation (DG) units, and the microgrid load locations make the conventional frequency and voltage droop method unpractical.
Abstract: In this paper, a power control strategy is proposed for a low-voltage microgrid, where the mainly resistive line impedance, the unequal impedance among distributed generation (DG) units, and the microgrid load locations make the conventional frequency and voltage droop method unpractical. The proposed power control strategy contains a virtual inductor at the interfacing inverter output and an accurate power control and sharing algorithm with consideration of both impedance voltage drop effect and DG local load effect. Specifically, the virtual inductance can effectively prevent the coupling between the real and reactive powers by introducing a predominantly inductive impedance even in a low-voltage network with resistive line impedances. On the other hand, based on the predominantly inductive impedance, the proposed accurate reactive power sharing algorithm functions by estimating the impedance voltage drops and significantly improves the reactive power control and sharing accuracy. Finally, considering the different locations of loads in a multibus microgrid, the reactive power control accuracy is further improved by employing an online estimated reactive power offset to compensate the effects of DG local load power demands. The proposed power control strategy has been tested in simulation and experimentally on a low-voltage microgrid prototype.

1,060 citations

Journal ArticleDOI
TL;DR: In this paper, a novel control strategy for parallel inverters of distributed generation units in an AC distribution system is presented, based on the droop control method, using only locally measurable feedback signals.
Abstract: This paper presents a novel control strategy for parallel inverters of distributed generation units in an AC distribution system. The proposed control technique, based on the droop control method, uses only locally measurable feedback signals. This method is usually applied to achieve good active and reactive power sharing when communication between the inverters is difficult due to its physical location. However, the conventional voltage and frequency droop methods of achieving load sharing have a slow and oscillating transient response. Moreover, there is no possibility to modify the transient response without the loss of power sharing precision or output-voltage and frequency accuracy. In this work, a great improvement in transient response is achieved by introducing power derivative-integral terms into a conventional droop scheme. Hence, better controllability of the system is obtained and, consequently, correct transient performance can be achieved. In addition, an instantaneous current control loop is also included in the novel controller to ensure correct sharing of harmonic components when supplying nonlinear loads. Simulation and experimental results are presented to prove the validity of this approach, which shows excellent performance as opposed to the conventional one.

1,003 citations

Journal ArticleDOI
TL;DR: In this article, a novel approach to conceive the secondary control in droop-controlled microgrids (MGs) is presented, where a distributed networked control system is used in order to implement a distributed secondary control (DSC), thus avoiding its implementation in MGCC.
Abstract: This paper presents a novel approach to conceive the secondary control in droop-controlled microgrids (MGs). The conventional approach is based on restoring the frequency and amplitude deviations produced by the local droop controllers by using an MG central controller (MGCC). A distributed networked control system is used in order to implement a distributed secondary control (DSC), thus avoiding its implementation in MGCC. The proposed approach is not only able to restore frequency and voltage of the MG but also ensures reactive power sharing. The distributed secondary control does not rely on a central control, so that the failure of a single unit will not produce the fail down of the whole system. Experimental results are presented to show the feasibility of the DSC. The time latency and data drop-out limits of the communication systems are studied as well.

928 citations

Journal ArticleDOI
TL;DR: In this article, a lowbandwidth communication (LBC)-based improved droop control method is proposed to improve the performance of the dc microgrid operation, which does not require a centralized secondary controller.
Abstract: Droop control is the basic control method for load current sharing in dc microgrid applications. The conventional dc droop control method is realized by linearly reducing the dc output voltage as the output current increases. This method has two limitations. First, with the consideration of line resistance in a droop-controlled dc microgrid, since the output voltage of each converter cannot be exactly the same, the output current sharing accuracy is degraded. Second, the dc-bus voltage deviation increases with the load due to the droop action. In this paper, in order to improve the performance of the dc microgrid operation, a low-bandwidth communication (LBC)-based improved droop control method is proposed. In contrast with the conventional approach, the control system does not require a centralized secondary controller. Instead, it uses local controllers and the LBC network to exchange information between converter units. The droop controller is employed to achieve independent operation, and the average voltage and current controllers are used in each converter to simultaneously enhance the current sharing accuracy and restore the dc bus voltage. All of the controllers are realized locally, and the LBC system is only used for changing the values of the dc voltage and current. Hence, a decentralized control scheme is accomplished. The simulation test based on MATLAB/Simulink and the experimental validation based on a 2 × 2.2 kW prototype were implemented to demonstrate the proposed approach.

865 citations

Journal ArticleDOI
TL;DR: This work shows that a network of loads and DC/AC inverters equipped with power-frequency droop controllers can be cast as a Kuramoto model of phase-coupled oscillators, and proposes a distributed integral controller based on averaging algorithms, which dynamically regulates the system frequency in the presence of a time-varying load.

819 citations


Network Information
Related Topics (5)
Voltage
296.3K papers, 1.7M citations
92% related
Electric power system
133K papers, 1.7M citations
91% related
Capacitor
166.6K papers, 1.4M citations
89% related
Wind power
99K papers, 1.5M citations
88% related
Energy storage
65.6K papers, 1.1M citations
86% related
Performance
Metrics
No. of papers in the topic in previous years
YearPapers
2023426
2022993
2021644
2020917
2019932
2018909