Volume fraction

About: Volume fraction is a research topic. Over the lifetime, 16312 publications have been published within this topic receiving 374181 citations.

Effect of SiC volume fraction and particle size on the fatigue resistance of a 2080 Al/SiCp composite

Abstract: The effect of SiC volume fraction and particle size on the fatigue behavior of 2080 Al was investigated. Matrix microstructure in the composite and the unreinforced alloy was held relatively constant by the introduction of a deformation stage prior to aging. It was found that increasing volume fraction and decreasing particle size resulted in an increase in fatigue resistance. Mechanisms responsible for this behavior are described in terms of load transfer from the matrix to the high stiffness reinforcement, increasing obstacles for dislocation motion in the form of S’ precipitates, and the decrease in strain localization with decreasing reinforcement interparticle spacing as a result of reduced particle size. Microplasticity was also observed in the composite, in the form of stress-strain hysteresis loops, and is related to stress concentrations at the poles of the reinforcement. Finally, intermetallic inclusions in the matrix acted as fatigue crack initiation sites. The effect of inclusion size and location on fatigue life of the composites is discussed.

Microwave dielectric characterization of binary mixtures of water, methanol, and ethanol

Abstract: The complex dielectric constants of binary mixtures of water–methanol and water–ethanol in the frequency range from 45 MHz to 26.5 GHz, and binary mixtures of methanol–ethanol in the range from 200 MHz to 26.5 GHz have been measured with various volume fractions around room temperature by means of an open‐ended coaxial sensor and a network analyzer. Methanol–ethanol mixtures display a near‐Debye dispersion while water–alcohol mixtures show a Cole–Davidson dispersion. The logarithm of relaxation time log τ and dielectric decrement Δe for methanol–ethanol mixtures show a good linear relation with the volume fraction of methanol, while log τ and Δe extracted with the Debye function for water–alcohol mixtures display a near‐linear relation with volume fraction of water. Two simple formulas are proposed for identifying the volume fractions of the components in binary mixtures of alcohol–alcohol and water–alcohol from a knowledge of τ and Δe for the pure liquids and the mixtures. The validity of these formulas has been demonstrated with three blind tests. The relation between the mole fraction of water and log τ for water–methanol and water–ethanol mixtures extracted by the use of a Cole–Davidson function clearly shows two linear regions, which implies a change of relaxation mechanism with mole fraction.

Effect of Particle Size on Thermal Conductivity of Nanofluid

Abstract: Nanofluids, containing nanometric metallic or oxide particles, exhibit extraordinarily high thermal conductivity. It is reported that the identity (composition), amount (volume percent), size, and shape of nanoparticles largely determine the extent of this enhancement. In the present study, we have experimentally investigated the impact of Al2Cu and Ag2Al nanoparticle size and volume fraction on the effective thermal conductivity of water and ethylene glycol based nanofluid prepared by a two-stage process comprising mechanical alloying of appropriate Al-Cu and Al-Ag elemental powder blend followed by dispersing these nanoparticles (1 to 2 vol pct) in water and ethylene glycol with different particle sizes. The thermal conductivity ratio of nanofluid, measured using an indigenously developed thermal comparator device, shows a significant increase of up to 100 pct with only 1.5 vol pct nanoparticles of 30- to 40-nm average diameter. Furthermore, an analytical model shows that the interfacial layer significantly influences the effective thermal conductivity ratio of nanofluid for the comparable amount of nanoparticles.