Topic
Wavelength-division multiplexing
About: Wavelength-division multiplexing is a research topic. Over the lifetime, 25059 publications have been published within this topic receiving 332027 citations. The topic is also known as: WDM.
Papers published on a yearly basis
Papers
More filters
TL;DR: In this article, the authors demonstrate the viability of spatial multiplexing to reach a data rate of 5.1 Tbit/s−1/carrier−1 on a single wavelength over a single fiber, by employing few-mode multicore fiber, compact three-dimensional waveguide multiplexers and energy-efficient frequency-domain MIMO equalization.
Abstract: Single-mode fibres with low loss and a large transmission bandwidth are a key enabler for long-haul high-speed optical communication and form the backbone of our information-driven society. However, we are on the verge of reaching the fundamental limit of single-mode fibre transmission capacity. Therefore, a new means to increase the transmission capacity of optical fibre is essential to avoid a capacity crunch. Here, by employing few-mode multicore fibre, compact three-dimensional waveguide multiplexers and energy-efficient frequency-domain multiple-input multiple-output equalization, we demonstrate the viability of spatial multiplexing to reach a data rate of 5.1 Tbit s−1 carrier−1 (net 4 Tbit s−1 carrier−1) on a single wavelength over a single fibre. Furthermore, by combining this approach with wavelength division multiplexing with 50 wavelength carriers on a dense 50 GHz grid, a gross transmission throughput of 255 Tbit s−1 (net 200 Tbit s−1) over a 1 km fibre link is achieved. A few-mode, multicore fibre allows ultra-high-speed data transmission on a single wavelength of light.
426 citations
TL;DR: A survey of two new technologies which are still in the experimental stage-optical packet switching and optical burst switching-and comment on their suitability for transporting IP traffic.
Abstract: Wavelength-division multiplexing appears to be the solution of choice for providing a faster networking infrastructure that can meet the explosive growth of the Internet. Several different technologies have been developed so far for the transfer of data over WDM. We survey two new technologies which are still in the experimental stage-optical packet switching and optical burst switching-and comment on their suitability for transporting IP traffic.
413 citations
01 Jan 2008
TL;DR: In this paper, the use of a coherent digital receiver for compensation of linear transmission impairments and polarization demultiplexing in a transmission system compatible with a future 100-Gb/s Ethernet standard is discussed.
Abstract: We discuss the use of a coherent digital receiver for the compensation of linear transmission impairments and polarization demultiplexing in a transmission system compatible with a future 100-Gb/s Ethernet standard. We present experimental results on the transmission performance of 111 Gbit/s POLMUX-RZ-DQPSK. For a dense WDM setup with channels carrying 111 Gbit/s with a 50 GHz channel spacing (2.0 bits/s/Hz), we show the feasibility of 2375 km transmission. This is enabled through coherent detection which results in excellent noise performance, and subsequent electronic equalization which provides the high tolerance to polarization mode dispersion and chromatic dispersion (CD). Furthermore, we discuss the impact of sampling and digital signal processing with either 1 or 2 samples/bit. We show that when combined with low-pass electrical filtering, 1 sample/bit signal processing is sufficient to obtain a large tolerance towards CD. The proposed modulation and detection techniques enable 111 Gbit/s transmission that is directly compatible with the existing 10 Gbit/s infrastructure.
405 citations
TL;DR: In this paper, the principles and practice of optical fiber communications are discussed, and the authors propose a framework for optical fiber communication based on the principles of principle and practice, which they call Optica Acta.
Abstract: (1986). Optical Fiber Communications: Principles and Practice. Optica Acta: International Journal of Optics: Vol. 33, No. 6, pp. 685-685.
403 citations
TL;DR: This paper discusses MIMO capacities in optical SDM systems, including related outage considerations which are an important part in the design of such systems, and extracts scaling rules for mode-average and mode-dependent loss.
Abstract: With wavelength-division multiplexing (WDM) rapidly nearing its scalability limits, space-division multiplexing (SDM) seems the only option to further scale the capacity of optical transport networks. In order for SDM systems to continue the WDM trend of reducing energy and cost per bit with system capacity, integration will be key to SDM. Since integration is likely to introduce non-negligible crosstalk between multiple parallel transmission paths, multiple-input multiple output (MIMO) signal processing techniques will have to be used. In this paper, we discuss MIMO capacities in optical SDM systems, including related outage considerations which are an important part in the design of such systems. In order to achieve the low-outage standards required for optical transport networks, SDM transponders should be capable of individually addressing, and preferably MIMO processing all modes supported by the optical SDM waveguide. We then discuss the effect of distributed optical noise in MIMO SDM systems and focus on the impact of mode-dependent loss (MDL) on system capacity and system outage. Through extensive numerical simulations, we extract scaling rules for mode-average and mode-dependent loss and show that MIMO SDM systems composed of up to 128 segments and supporting up to 128 modes can tolerate up to 1 dB of per-segment MDL at 90% of the system's full capacity at an outage probability of 10(-4).
401 citations