J. Antonio Travieso-Rodriguez

TL;DR: In this paper, the fatigue response of PLA parts manufactured through fused filament fabrication (FFF) was analyzed through an L27 Taguchi experimental design, which is run for two different infills: linear and honeycomb.

TL;DR: The results show that the infill density is the most important parameter for both of the studied patterns and are useful to design and manufacture ABS end-use parts that are expected to work under oscillating periodic loads.

TL;DR: Results show that layer orientation is the most influential parameter, followed by layer height, filament width, and printing velocity, whereas the fill density and infill pattern show no significant influence.

TL;DR: In this paper, the influence of the athermal effects of electroplasticity on the bottom bending process when the Joule effect is minimized to negligible values was investigated. But the results showed that the results of the electrically-assisted bending process show that the force drops up to 18% in aluminium and 6% in stainless steel.

TL;DR: In this paper, the fatigue behavior of a polylactic acid-based composite reinforced with wood (trademarked as Timberfill) processed through fused filament fabrication is analyzed through rotating bending fatigue tests.