This article is concerned with the mechanisms by which type II superconductors can carry currents. The equilibrium properties of the vortex lattice are described and the generalized driving force in gradients of temperature and field is derived using irreversible thermodynamics. This leads to expressions for thermal cross effects which can include pinning forces. The field distributions which occur in a range of situations are derived and a number of useful solutions of the critical state given. In particular, the distribution in a longitudinal field is obtained, and the conditions under which force-free configurations can break down by the cutting of vortices discussed. The effects of lattice rigidity on the summation of pinning forces is considered and it is shown that a summation based on statistical arguments uses the same approximations and leads to the same results as a dissipation argument. Theoretical expressions are derived for the vortex pinning interaction to a number of different metallurgical...

Flux vortices and transport currents in type II superconductors

This review paper illustrates the main normal and superconducting state properties of magnesium diboride, a material known since the early 1950s but only recently discovered to be superconductive at a remarkably high critical temperature Tc = 40 K for a binary compound. What makes MgB2 so special? Its high Tc, simple crystal structure, large coherence lengths, high critical current densities and fields, and transparency of grain boundaries to current promise that MgB2 will be a good material for both large-scale applications and electronic devices. During the last seven months, MgB2 has been fabricated in various forms: bulk, single crystals, thin films, tapes and wires. The largest critical current densities, greater than 10 MA cm−2, and critical fields, 40 T, are achieved for thin films. The anisotropy ratio inferred from upper critical field measurements is yet to be resolved as a wide range of values have been reported, γ = 1.2–9. Also, there is no consensus on the existence of a single anisotropic or double energy gap. One central issue is whether or not MgB2 represents a new class of superconductors, which is the tip of an iceberg awaiting to be discovered. To date MgB2 holds the record for the highest Tc among simple binary compounds. However, the discovery of superconductivity in MgB2 revived the interest in non-oxides and initiated a search for superconductivity in related materialss; several compounds have since been announced to be superconductive: TaB2, BeB2.75, C–S composites, and the elemental B under pressure.

https://iopscience.iop.org/article/10.1088/0953-2048/14/11/201/pdf

Review of the superconducting properties of MgB2

Magnetic flux can penetrate a type-II superconductor in the form of Abrikosov vortices (also called flux lines, flux tubes, or fluxons) each carrying a quantum of magnetic flux phi 0=h/2e. These tiny vortices of supercurrent tend to arrange themselves in a triangular flux-line lattice (FLL), which is more or less perturbed by material inhomogeneities that pin the flux lines, and in high-Tc superconductors (HTSCs) also by thermal fluctuations. Many properties of the FLL are well described by the phenomenological Ginzburg-Landau theory or by the electromagnetic London theory, which treats the vortex core as a singularity. In Nb alloys and HTSCs the FLL is very soft mainly because of the large magnetic penetration depth lambda . The shear modulus of the FLL is c66~1/ lambda 2, and the tilt modulus c44(k)~(1+k2 lambda 2)-1 is dispersive and becomes very small for short distortion wavelengths 2 pi /k<< lambda . This softness is enhanced further by the pronounced anisotropy and layered structure of HTSCs, which strongly increases the penetration depth for currents along the c axis of these (nearly uniaxial) crystals and may even cause a decoupling of two-dimensional vortex lattices in the Cu-O layers. Thermal fluctuations and softening may `melt` the FLL and cause thermally activated depinning of the flux lines or ofthe two-dimensional `pancake vortices` in the layers. Various phase transitions are predicted for the FLL in layered HTSCs. Although large pinning forces and high critical currents have been achieved, the small depinning energy so far prevents the application of HTSCs as conductors at high temperatures except in cases when the applied current and the surrounding magnetic field are small.

https://iopscience.iop.org/article/10.1088/0034-4885/58/11/003/pdf

The flux-line lattice in superconductors

Magnetic flux can penetrate a type-II superconductor in form of Abrikosov vortices. These tend to arrange in a triangular flux-line lattice (FLL) which is more or less perturbed by material inhomogeneities that pin the flux lines, and in high-$T_c$ supercon- ductors (HTSC's) also by thermal fluctuations. Many properties of the FLL are well described by the phenomenological Ginzburg-Landau theory or by the electromagnetic London theory, which treats the vortex core as a singularity. In Nb alloys and HTSC's the FLL is very soft mainly because of the large magnetic penetration depth: The shear modulus of the FLL is thus small and the tilt modulus is dispersive and becomes very small for short distortion wavelength. This softness of the FLL is enhanced further by the pronounced anisotropy and layered structure of HTSC's, which strongly increases the penetration depth for currents along the c-axis of these uniaxial crystals and may even cause a decoupling of two-dimensional vortex lattices in the Cu-O layers. Thermal fluctuations and softening may melt the FLL and cause thermally activated depinning of the flux lines or of the 2D pancake vortices in the layers. Various phase transitions are predicted for the FLL in layered HTSC's. The linear and nonlinear magnetic response of HTSC's gives rise to interesting effects which strongly depend on the geometry of the experiment.

The Flux-Line Lattice in Superconductors

Since the first days of high-Tc superconductivity, the materials science and the physics of grain boundaries in superconducting compounds have developed into fascinating fields of research. Unique electronic properties, different from those of the grain boundaries in conventional metallic superconductors, have made grain boundaries formed by high-Tc cuprates important tools for basic science. They are moreover a key issue for electronic and large-scale applications of high-Tc superconductivity. The aim of this review is to give a summary of this broad and dynamic field. Starting with an introduction to grain boundaries and a discussion of the techniques established to prepare them individually and in a well-defined manner, the authors present their structure and transport properties. These provide the basis for a survey of the theoretical models developed to describe grain-boundary behavior. Following these discussions, the enormous impact of grain boundaries on fundamental studies is reviewed, as well as high-power and electronic device applications.

/pdf/grain-boundaries-in-high-t-c-superconductors-2widq11ljn.pdf

Grain boundaries in high- T c superconductors

The ability of large-grain (RE)Ba2Cu3O7−δ ((RE)BCO; RE = rare earth) bulk superconductors to trap magnetic fields is determined by their critical current. With high trapped fields, however, bulk samples are subject to a relatively large Lorentz force, and their performance is limited primarily by their tensile strength. Consequently, sample reinforcement is the key to performance improvement in these technologically important materials. In this work, we report a trapped field of 17.6 T, the largest reported to date, in a stack of two silver-doped GdBCO superconducting bulk samples, each 25 mm in diameter, fabricated by top-seeded melt growth and reinforced with shrink-fit stainless steel. This sample preparation technique has the advantage of being relatively straightforward and inexpensive to implement, and offers the prospect of easy access to portable, high magnetic fields without any requirement for a sustaining current source.

https://iopscience.iop.org/article/10.1088/0953-2048/27/8/082001/pdf

A trapped field of 17.6 T in melt-processed, bulk Gd-Ba-Cu-O reinforced with shrink-fit steel

A numerical method is proposed to analyse the electromagnetic behaviour of systems including high-temperature superconductors (HTSCs) in time-varying external fields and superconducting cables carrying AC transport current. The E–J constitutive law together with an H-formulation is used to calculate the current distribution and electromagnetic fields in HTSCs, and the magnetization of HTSCs; then the forces in the interaction between the electromagnet and the superconductor and the AC loss of the superconducting cable can be obtained. This numerical method is based on solving the partial differential equations time dependently and is adapted to the commercial finite element software Comsol Multiphysics 3.2. The advantage of this method is to make the modelling of the superconductivity simple, flexible and extendable.

https://iopscience.iop.org/article/10.1088/0953-2048/19/12/004/pdf

Numerical solution of critical state in superconductivity by finite element software

A general treatment of losses in multifilamentary superconductors

Strong evidence for high intergranular critical current densities and large bulk magnetic flux pinning in superconducting polycrystalline MgB2 has been observed. The presence of strongly-coupled grain boundaries in this material has been confirmed by a dramatic collapse of the magnetic hysteresis loop when a bulk specimen is ground into a fine powder and re-measured under similar conditions. Further evidence for strong intergrain links in polycrystalline MgB2 is provided by the continuous variation of the remanent magnetic moment up to the full penetration field of a bulk sample. The absence of weak-link nature in this material has profound implications for its potential in a wide range of engineering applications.

https://iopscience.iop.org/article/10.1088/0953-2048/14/4/101/pdf

A.M. Campbell

Papers

A trapped field of 17.6 T in melt-processed, bulk Gd-Ba-Cu-O reinforced with shrink-fit steel

Numerical solution of critical state in superconductivity by finite element software

A general treatment of losses in multifilamentary superconductors

High intergranular critical currents in metallic MgB2 superconductor

Bulk high temperature superconductors for magnet applićations