Wireless Communications

Mobile users' data rate and quality of service are limited by the fact that, within the duration of any given call, they experience severe variations in signal attenuation, thereby necessitating the use of some type of diversity. In this two-part paper, we propose a new form of spatial diversity, in which diversity gains are achieved via the cooperation of mobile users. Part I describes the user cooperation strategy, while Part II (see ibid., p.1939-48) focuses on implementation issues and performance analysis. Results show that, even though the interuser channel is noisy, cooperation leads not only to an increase in capacity for both users but also to a more robust system, where users' achievable rates are less susceptible to channel variations.

http://dns2.asia.edu.tw/~ysho/YSHO-English/2000%20Engineering/PDF/IEE%20Tra%20Com51,%201927.pdf

User cooperation diversity. Part I. System description

We provide an overview of the extensive results on the Shannon capacity of single-user and multiuser multiple-input multiple-output (MIMO) channels. Although enormous capacity gains have been predicted for such channels, these predictions are based on somewhat unrealistic assumptions about the underlying time-varying channel model and how well it can be tracked at the receiver, as well as at the transmitter. More realistic assumptions can dramatically impact the potential capacity gains of MIMO techniques. For time-varying MIMO channels there are multiple Shannon theoretic capacity definitions and, for each definition, different correlation models and channel information assumptions that we consider. We first provide a comprehensive summary of ergodic and capacity versus outage results for single-user MIMO channels. These results indicate that the capacity gain obtained from multiple antennas heavily depends on the available channel information at either the receiver or transmitter, the channel signal-to-noise ratio, and the correlation between the channel gains on each antenna element. We then focus attention on the capacity region of the multiple-access channels (MACs) and the largest known achievable rate region for the broadcast channel. In contrast to single-user MIMO channels, capacity results for these multiuser MIMO channels are quite difficult to obtain, even for constant channels. We summarize results for the MIMO broadcast and MAC for channels that are either constant or fading with perfect instantaneous knowledge of the antenna gains at both transmitter(s) and receiver(s). We show that the capacity region of the MIMO multiple access and the largest known achievable rate region (called the dirty-paper region) for the MIMO broadcast channel are intimately related via a duality transformation. This transformation facilitates finding the transmission strategies that achieve a point on the boundary of the MIMO MAC capacity region in terms of the transmission strategies of the MIMO broadcast dirty-paper region and vice-versa. Finally, we discuss capacity results for multicell MIMO channels with base station cooperation. The base stations then act as a spatially diverse antenna array and transmission strategies that exploit this structure exhibit significant capacity gains. This section also provides a brief discussion of system level issues associated with MIMO cellular. Open problems in this field abound and are discussed throughout the paper.

/pdf/capacity-limits-of-mimo-channels-aigb402z31.pdf

Capacity limits of MIMO channels

Multiple transmit antennas in a downlink channel can provide tremendous capacity (i.e., multiplexing) gains, even when receivers have only single antennas. However, receiver and transmitter channel state information is generally required. In this correspondence, a system where each receiver has perfect channel knowledge, but the transmitter only receives quantized information regarding the channel instantiation is analyzed. The well-known zero-forcing transmission technique is considered, and simple expressions for the throughput degradation due to finite-rate feedback are derived. A key finding is that the feedback rate per mobile must be increased linearly with the signal-to-noise ratio (SNR) (in decibels) in order to achieve the full multiplexing gain. This is in sharp contrast to point-to-point multiple-input multiple-output (MIMO) systems, in which it is not necessary to increase the feedback rate as a function of the SNR

MIMO Broadcast Channels With Finite-Rate Feedback

It is now well known that employing channel adaptive signaling in wireless communication systems can yield large improvements in almost any performance metric. Unfortunately, many kinds of channel adaptive techniques have been deemed impractical in the past because of the problem of obtaining channel knowledge at the transmitter. The transmitter in many systems (such as those using frequency division duplexing) can not leverage techniques such as training to obtain channel state information. Over the last few years, research has repeatedly shown that allowing the receiver to send a small number of information bits about the channel conditions to the transmitter can allow near optimal channel adaptation. These practical systems, which are commonly referred to as limited or finite-rate feedback systems, supply benefits nearly identical to unrealizable perfect transmitter channel knowledge systems when they are judiciously designed. In this tutorial, we provide a broad look at the field of limited feedback wireless communications. We review work in systems using various combinations of single antenna, multiple antenna, narrowband, broadband, single-user, and multiuser technology. We also provide a synopsis of the role of limited feedback in the standardization of next generation wireless systems.

/pdf/an-overview-of-limited-feedback-in-wireless-communication-1njp2bb1kz.pdf

An overview of limited feedback in wireless communication systems

We derive performance limits for two closely related communication scenarios involving a wireless system with multiple-element transmitter antenna arrays: a point-to-point system with partial side information at the transmitter, and a broadcast system with multiple receivers. In both cases, ideal beamforming is impossible, leading to an inherently lower achievable performance as the quality of the side information degrades or as the number of receivers increases. Expected signal-to-noise ratio (SNR) and mutual information are both considered as performance measures. In the point-to-point case, we determine when the transmission strategy should use some form of beamforming and when it should not. We also show that, when properly chosen, even a small amount of side information can be quite valuable. For the broadcast scenario with an SNR criterion, we find the efficient frontier of operating points and show that even when the number of receivers is larger than the number of antenna array elements, significant performance improvements can be obtained by tailoring the transmission strategy to the realized channel.

/pdf/efficient-use-of-side-information-in-multiple-antenna-data-1qf1940ph6.pdf

A. Narula

Papers

Efficient use of side information in multiple-antenna data transmission over fading channels