A
Andrey V. Filippov
Researcher at Institute of Strength Physics and Materials Science SB RAS
Publications - 83
Citations - 698
Andrey V. Filippov is an academic researcher from Institute of Strength Physics and Materials Science SB RAS. The author has contributed to research in topics: Acoustic emission & Ultimate tensile strength. The author has an hindex of 13, co-authored 73 publications receiving 497 citations. Previous affiliations of Andrey V. Filippov include Tomsk Polytechnic University.
Papers
More filters
Journal ArticleDOI
Effect of heat input on phase content, crystalline lattice parameter, and residual strain in wire-feed electron beam additive manufactured 304 stainless steel
Sergei Yu. Tarasov,Andrey V. Filippov,N. L. Savchenko,S. V. Fortuna,Valery E. Rubtsov,E. A. Kolubaev,Sergey G. Psakhie +6 more
TL;DR: In this article, structural and mechanical characterization of electron beam additive manufactured stainless steel samples has been carried out, where the XRD measured austenite and ferrite lattice parameters showed their sensitivity to the heat input value, which was related to the chromium atom redistribution.
Journal ArticleDOI
Adhesion transfer in sliding a steel ball against an aluminum alloy
S. Yu. Tarasov,S. Yu. Tarasov,Andrey V. Filippov,Andrey V. Filippov,Evgeny Kolubaev,Evgeny Kolubaev,Tatiana Kalashnikova +6 more
TL;DR: In this article, high-temperature sliding experiments have been carried out to study both direct and back adhesion transfer between Al-Mg alloy metal and the ball bearing steel sample, and it was shown that a transfer layer consisting of aluminum alloy formed on the trailing hemisphere of the steel ball and then could stick back to the wear groove surface of the disk.
Journal ArticleDOI
Microstructural evolution and chemical corrosion of electron beam wire-feed additively manufactured AISI 304 stainless steel
S. Yu. Tarasov,Andrey V. Filippov,N. N. Shamarin,S. V. Fortuna,Galina G. Maier,Evgeny Kolubaev +5 more
TL;DR: In this paper, the authors used an electron beam wire-feed additive manufacturing to obtain different amounts of vermicular δ-ferrite that depended on the heat input value used.
Journal ArticleDOI
Vibration and acoustic emission monitoring the stability of peakless tool turning: Experiment and modeling
Andrey V. Filippov,Andrey V. Filippov,Anton Yu. Nikonov,Anton Yu. Nikonov,Valery E. Rubtsov,Valery E. Rubtsov,Andrey I. Dmitriev,Andrey I. Dmitriev,Andrey I. Dmitriev,S. Yu. Tarasov,S. Yu. Tarasov +10 more
TL;DR: In this article, a study of steady and chatter mode peakless tool turning has been carried out in order to reveal an acoustic emission response to the workpiece chatter during fine turning.
Journal ArticleDOI
Friction-induced slip band relief of -Hadfield steel single crystal oriented for multiple slip deformation
Dmitry V. Lychagin,Dmitry V. Lychagin,Dmitry V. Lychagin,Andrey V. Filippov,O.S. Novitskaia,Y.I. Chumlyakov,Evgeny Kolubaev,Olga V. Sizova +7 more
TL;DR: In this paper, the deformation behavior of Hadfield steel single crystals with compression and friction axis orientations was analyzed under constant loading conditions, and the authors determined the sequence and direction of shear in the analyzed systems by analyzing the shear stress value and deformation relief.