The field of enthalpy relaxation is reviewed. Current phenomenologies for dealing with the non-linear and non-exponential character of enthalpy relaxation are presented, and their successes and shortcomings are discussed. Qualitative experimental data and quantitative parameterizations are summarized, and some directions for future research are suggested.

Enthalpy relaxation and recovery in amorphous materials

Evaluation of amorphous solid dispersion properties using thermal analysis techniques.

The viscoelastic properties of mod were investigated using dynamic mechanical thermal analysis and differential scanning calorimetry. Under a limited set of conditions, two separate glass transitions (T
 g) could be identified with both techniques. These two transitions were identified as arising from the amorphous lignin and hernicellulose matrix in the wood cell wall. Moisture dramatically affected the temperature at which the two dispersions occurred and, consequently, the ability to resolve their independent responses. The relationship betweenT
 g and moisture for both components could be modelled with the Kwei equation, which accounts for the presence of secondary interactions. Annealing and specific interactions of a series of organic diluents were wed in an attempt to enhance the resolution of the two components values ofT
 g. Time-temperature superposition was shown to be applicable to wood plasticized with ethyl formamide, following Williams-Landel-Ferry behaviour over the temperature rangeT
 g toT
 g + 85° C. These observations allow certain conclusions to be drawn concerning the applicability of existing models of the wood cell wall's supermolecular morphology. Most notably, models of thein situ morphology of the three wood components can be limited to those which consider the amorphous matrix of lignin and hemicellulose to be immiscible.

Relaxation behaviour of the amorphous components of wood

Two types of polymer–silica nanocomposites have been prepared by undergoing free radical polymerization of 2-hydroxyethyl methacrylate (HEMA) either in the presence of HEMA-functionalized SiO2 nanoparticles (Type 1) or during the simultaneous in situ growing of the silica phase through the acid-catalyzed sol–gel polymerization of tetraethoxysilane (TEOS) (Type 2). Relationships between synthesis conditions, chemical structure, and resulting morphology have been studied. Type 1 systems exhibit a classical particle-matrix morphology, but where particles tend to form aggregates. Type 2 systems possess a finer morphology characterized by a very open mass-fractal silicate structure, which is believed to be bicontinuous with the organic phase at a molecular level. © 1999 John Wiley & Sons, Inc. J Polym Sci B: Polym Phys 37: 3172–3187, 1999

Ann L. Young

Papers

DSC on Freeze-Dried Poly(methyl methacrylate)-Polystyrene Blends