The current understanding of the fundamentals of recrystallization is summarized. This includes understanding the as-deformed state. Several aspects of recrystallization are described: nucleation and growth, the development of misorientation during deformation, continuous, dynamic, and geometric dynamic recrystallization, particle effects, and texture. This article is authored by the leading experts in these areas. The subjects are discussed individually and recommendations for further study are listed in the final section.

/pdf/current-issues-in-recrystallization-a-review-12181rj4pn.pdf

Current issues in recrystallization: a review

Dynamic and post-dynamic recrystallization under hot, cold and severe plastic deformation conditions

https://material.karlov.mff.cuni.cz/people/janecek/studenti/FyzMetNano/Estrin_AM61_2013_782.pdf

Extreme grain refinement by severe plastic deformation: A wealth of challenging science

In terms of the grain refinement mechanism induced by plastic straining, a novel surface mechanical attrition treatment (SMAT) was developed for synthesizing a nanostructured surface layer on metallic materials in order to upgrade the overall properties and performance. In this paper, the SMAT technique and the microstructure of the SMAT surface layer will be described. The grain refinement mechanism of the surface layer during the SMAT will be analyzed in terms of the microstructure observations in several typical materials. Obvious enhancements in mechanical properties and tribological properties of the nanostructured surface layer in different materials were observed. Further development and prospects will be addressed with respect to the SMAT as well as the performance and technological applications of the engineering materials with the nanostructured surface layer.

Nanostructured surface layer on metallic materials induced by surface mechanical attrition treatment

An investigation of surface nanocrystallization mechanism in Fe induced by surface mechanical attrition treatment

The microstructural evolution during polyslip in f.c.c. metals in investigated by the examples of Al, Ni, NiCo alloys and an AlMg alloy, deformed at room temperature either by rolling or by torsion. The principles governing this evolution appears to be the following: (a) There are differences in the number and selection of simultaneously acting slip systems among neighboring volume elements of individual grains. In any one volume element (called a cell block), the number of slip systems falls short of that required for homogeneous (Taylor) deformation, but groups of neighboring cell blocks fulfil the Taylor criterion collectively. (b) The dislocations are trapped into low-energy dislocation structures in which neigboring dislocations mutually screen their stresses. The microstructural evolution at small strains progresses by the subdivision of grains into cell blocks delineated by dislocation boundaries. These boundaries accomodate the lattice misorientations, which result from glide on different slip system combinations in neighbouring cell blocks. The cell blocks are subdivided into ordinary cells and both cell blocks and cells shrink with increasing strain. All observations appear to be in good accord with the theoretical interpretation. However, some problems remain to be solved quantitatively.

B. Bay

Papers

Overview no. 96: Evolution of F.C.C. deformation structures in polyslip