Tool Condition Monitoring (TCM) — The Status of Research and Industrial Application

The anisotropy of fiber-reinforced plastics (FRP) affects the chip formation and thrust force during drilling. Delamination is recognized as one of the major causes of damage during drilling of fiber reinforced plastics, which not only reduces the structural integrity, but also has the potential for long-term performance deterioration. It is difficult to produce good quality holes with high efficiency by conventional drilling method. This research concerning drilling of polymeric composites aims to establish a technology that would ensure minimum defects and longer tool life. Specifically, the authors conceived a new drilling method that imparts a low-frequency, high amplitude vibration to the workpiece in the feed direction during drilling. Using high-speed steel (HSS) drill, a series of vibratory drilling and conventional drilling experiments were conducted on glass fiber-reinforced plastics composites to assess thrust force, flank wear and delamination factor. In addition, the process-status during vibratory drilling was also assessed by monitoring acoustic emission from the workpiece. From the drilling experiments, it was found that vibratory drilling method is a promising machining technique that uses the regeneration effect to produce axial chatter, facilitating chip breaking and reduction in thrust force.

C.L. Jiaa

Papers

Experimental studies of sliding friction and wear via acoustic emission signal analysis