On The Measurement of Temperature in Material Removal Processes

The rapid wear rate of cutting tools due to high cutting temperature is a critical problem to be solved in high-speed machining (HSM) of hardened steels. Near-dry machining such as minimum quantity lubrication (MQL) is regarded as one of the solutions to this difficulty. However, the function of MQL in HSM is still uncertain so far which prevents MQL from widely being utilized in the machining of hardened steels. In this paper, the mechanism of MQL in HSM of hardened steel is investigated more comprehensively. Comparing with dry cutting, the tool performance can be enhanced by MQL under all cutting speeds in this study. It is found that MQL can provide extra oxygen to promote the formation of a protective oxide layer in between the chip–tool interface. This layer is basically quaternary compound oxides of Fe, Mn, Si, and Al, and is proved to act as diffusion barriers effectively. Hence, the strength and wear resistance of a cutting tool can be retained which leads to a significant improvement of tool life. It is found that there exists an optimal cutting speed at which a stable protective oxide layer can be formed. When cutting speed is lower than this speed, there is less oxide layer and the improvement of tool life is less apparent. As the cutting speed is far beyond the optimal value, the protective layer is absent and the thermal cracks are apt to occur at the cutting edge due to large fluctuation of temperature. Resultantly, application of MQL is inappropriate in the extreme high-speed cutting condition irrespective of its little increase in tool life. Based on this study, it is concluded that the tool life can be effectively improved by MQL in HSM of NAK80 hardened steels when cutting parameters are chosen properly.

Mechanism of minimum quantity lubrication in high-speed milling of hardened steel

Wear behaviour of cemented carbide tools in dry machining of aluminium alloy

Considerable research has been conducted over recent decades on the role of non‑metallic inclusions and their link to the machinability of different steels. The present work reviews the mechanisms of steel fractures during different mechanical machining operations and the behavior of various non-metallic inclusions in a cutting zone. More specifically, the effects of composition, size, number and morphology of inclusions on machinability factors (such as cutting tool wear, power consumption, etc.) are discussed and summarized. Finally, some methods for modification of non-metallic inclusions in the liquid steel are considered to obtain a desired balance between mechanical properties and machinability of various steel grades.

/pdf/the-effect-of-different-non-metallic-inclusions-on-the-2ykxd573g7.pdf

The effect of different non-metallic inclusions on the machinability of steels

This paper gives a bibliographical review of the finite element methods applied to the analysis and simulation of welding processes The bibliography is an addendum to the finite element analysis and simulation of welding: a bibliography (1976–96) published in Modelling Simul Mater Sci Eng (1996) 4 501–33 The added bibliography at the end of this paper contains approximately 550 references to papers and conference proceedings on the subject that were published in 1996–2001 These are classified in the following categories: modelling of welding processes in general; modelling of specific welding processes; influence of geometrical parameters; heat transfer and fluid flow in welds; residual stresses and deformations in welds; fracture mechanics and welding; fatigue of welded structures; destructive and non-destructive evaluation of weldments and cracks; welded tubular joints, pipes and pressure vessels/components; welds in plates and other structures/components

D. Zhang

Papers

An investigation of adhering layer formation during tool wear progression in turning of free-cutting stainless steel

FE analysis of cutting tool temperature field with adhering layer formation