Maximum power point tracking (MPPT) techniques are used in photovoltaic (PV) systems to maximize the PV array output power by tracking continuously the maximum power point (MPP) which depends on panels temperature and on irradiance conditions. The issue of MPPT has been addressed in different ways in the literature but, especially for low-cost implementations, the perturb and observe (PO moreover, it is well known that the P&O algorithm can be confused during those time intervals characterized by rapidly changing atmospheric conditions. In this paper it is shown that, in order to limit the negative effects associated to the above drawbacks, the P&O MPPT parameters must be customized to the dynamic behavior of the specific converter adopted. A theoretical analysis allowing the optimal choice of such parameters is also carried out. Results of experimental measurements are in agreement with the predictions of theoretical analysis.

/pdf/optimization-of-perturb-and-observe-maximum-power-point-z7a8beok09.pdf

Optimization of perturb and observe maximum power point tracking method

Asymptotic waveform evaluation (AWE) provides a generalized approach to linear RLC circuit response approximations. The RLC interconnect model may contain floating capacitors, grounded resistors, inductors, and even linear controlled sources. The transient portion of the response is approximated by matching the initial boundary conditions and the first 2q-1 moments of the exact response to a lower-order q-pole model. For the case of an RC tree model, a first-order AWE approximation reduces to the RC tree methods. >

Asymptotic waveform evaluation for timing analysis

The application of a hybrid two-port model to teleoperators with force and velocity sensing at the master and slave is presented. The interfaces between human operator and master, and between environment and slave, are ports through which the teleoperator is designed to exchange energy between the operator and the environment. By computing or measuring the input-output properties of this two-port network, the hybrid two-port model of an actual or simulated teleoperator system can be obtained. It is shown that the hybrid model (as opposed to other two-port forms) leads to an intuitive representation of ideal teleoperator performance and applies to several teleoperator architectures. Thus measured values of the h matrix or values computed from a simulation can be used to compare performance with the ideal. The frequency-dependent h matrix is computed from a detailed SPICE model of an actual system, and the method is applied to a proposed architecture. >

A design framework for teleoperators with kinesthetic feedback

A new model for the study of power system stability via Lyapunov functions is proposed. The key feature of the model is an assumption of frequency-dependent load power, rather than the usual impedance loads which are subsequently absorbed into a reduced network. The original network topology is explicitly represented. This approach has the important advantage of rigorously accounting for real power loads in the Lyapunov functions. This compares favorably with existing methods involving approximations to allow for the significant transfer conductances in reduced network models. The preservation of network topology can be exploited in stability analysis, with the concepts of critical and vulnerable cutsets playing central roles in dynamic and transient stability evaluation respectively. Of fundamental importance is the feature that the Lyapunov functions give a true representation of the spatial distribution of stored energy in the system

A Structure Preserving Model for Power System Stability Analysis

An improved electrical impedance tomographic reconstruction algorithm is presented that is generally guaranteed to converge. The algorithm is attractive for several reasons. A modified Newton?Raphson method varies a finite-element model of resistivities to fit a set of voltage measurements in a least-squared sense. Two procedures for calculating the Jacobian matrix are derived. One is standard, while the other is based on the compensation theorem. This second procedure is more efficient for computations, and just as accurate as the standard one. The inherent ill-conditioning in the approximate Hessian matrix of the linearized system is eliminated using the Marquardt method. Results from two-dimensional computer simulations are compared to four other reconstruction algorithms, which are based on methods proposed by other authors. The modified Newton?Raphson method provided significantly better reconstructions than any of the other methods. The algorithms compared are the perturbation, equipotential, iterative-equipotential, and the double-constraint methods. The modified Newton?Raphson method was found to be sensitive to measurement error, but future work in designing electrode-probing configurations is expected to reduce this sensitivity.

Comparing Reconstruction Algorithms for Electrical Impedance Tomography

为了适应科学技术的飞速发展,为了迅速改变我国科学技术的现状,我们必须以现代科学技术水平为起点,来组织我们的教学工作,培养出适应当前科学技术发展要求的科学技术人材。否则我们就始终只能跟在人家的后面,一步一步地爬行。从这个角度来看,我院领导正确地决定了电工基础课程采用University of California,Berkeley(伯克莱加大)Charles A.Desor and Ernest S.Kuh 所著《Basic Cirouif Theory》教材是非常适时的。

戴旦前

Papers

使用《Basic circuit Theory》进行教学的初步体会