Showing papers by "Esa Vuorinen published in 2020"

Converging criteria to characterize crack susceptibility in a micro-alloyed steel during continuous casting

Abstract: The ductility drop and decrease in strength that lead to crack formation during continuous casting of steel is typically investigated by means of the hot ductility test. In this study, hot ductility tests are performed by using a thermo-mechanical Gleeble system to simulate the deformation of steels at high temperatures and low deformation rates similar to those during continuous casting. Thus, temperature was varied between 600 and 1000 °C while strain rates covered a range from 0.001 to 0.1 s − 1 . Tests are carried out to identify the temperature range at which the steel is susceptible to crack formation as well as the effect of strain rate. Characterization of fractured surfaces and phase transformation after thermo-mechanical tests are conducted in the SEM and Optical Microscope. The combination of these techniques makes possible to formulate cracking mechanisms during hot processing which show critical strain for failure at temperatures between 700 and 900 °C based on the convergence of three different criteria: I) Reduction of area, II) True fracture strength-ductility and III) True total energy. This approach provides a better understanding of crack formation in steels at the high temperatures experienced during continuous casting. This information is key to productivity losses and avoid defect formation in the final cast products.

Scale Formation on HSLA Steel during Continuous Casting Part I: The Effect of Temperature–Time on Oxidation Kinetics

Abstract: The findings in this work enhance the understanding of oxidation mechanisms and scale growth at high temperatures of a high strength low alloy (HSLA) steel for improving surface quality during continuous casting. The oxidation phenomenon was investigated under dry air and water vapor atmospheres by heating specimens at 1000, 1100, and 1200 °C at different holding times. Temperature and time had great effects on the kinetics, where faster (i.e., parabolic) oxidation rates were present under water vapor when compared with the dry air condition. Temperature strongly influenced the number of defects, such as pores, voids, gaps and micro-cracks, formed in the oxide scale. A phase analysis confirmed the presence of FeO as the first phase formed at the steel surface, Fe3O4 as the middle and thicker phase, and Fe2O3 as the last phase formed in the oxide/air interface. The micromechanics of the oxides demonstrated that a combination of phases with high (wustite) and low plasticity (magnetite and hematite) could also have been the reason for the uneven cooling during Continuous Casting (CC) that resulted in the undesired surface quality of the steel slabs. This work gives a good look at the oxide scale effect on the surface quality of steel slabs through an understanding the kinetics during oxidation.

Scale Formation on HSLA Steel during Continuous Casting Part II : The Effect of Surface Conditions

Abstract: The present research addresses the effect of surface condition on oxide scale formation at high temperatures such as those experienced during secondary cooling in Continuous Casting. Tests were carried out in clean, as-cast and surfaces covered with casting powder to replicate the oxidation/re-oxidation after the mould. Specimens oxidized at 1000, 1100 and 1200 °C under dry air and water-vapour conditions revealed that the oxide scale formation is strongly influenced by temperature, environmental and surface conditions. The oxide scale thickness increases with temperature alterations in the surface (e.g., as-cast and covered with powder) where oxides and carbonates from the casting powder accelerate oxidation kinetics leading to thick and unstable scales. A high amount of carbon is present on surfaces covered with casting powder where it diffuses through the oxide scale forming CO and CO2 which lead to stress accumulation that makes scales prone to defects such as pores, voids and micro-cracks. Ultimately, if wustite remains attached to the steel surface or inside oscillation marks, it may disturb heat transfer during secondary cooling which has deep industrial implications for crack formation and overall casting yield. Therefore, accurate insights on scale type and growth mechanisms could lead to accurate control of its formation during casting.