The direct electrochemistry of redox proteins has been achieved at a variety of electrodes, including modified gold, pyrolytic graphite and metal oxides. Careful design of electrode surfaces and electrolyte conditions are required for the attainment of rapid and reversible protein-electrode interaction. The electron transfer reactions of more complex systems, such as redox enzymes, are now being examined. The 'well-behaved' electrochemistry of redox proteins can be usefully exploited by coupling the electrode reaction to enzymes for which the redox proteins act as cofactors. In systems where direct electron transfer is very slow, small electron carriers, or mediators, may be employed to enhance the rate of electron exchange with the electrode. The organometallic compound ferrocene and its derivatives have proved particularly effective in this role. A new generation of electrochemical biosensors employs ferrocene derivatives as mediators.

https://febs.onlinelibrary.wiley.com/doi/pdf/10.1111/j.1432-1033.1988.tb13882.x

Direct and indirect electron transfer between electrodes and redox proteins

Immobilization of hemoglobin on zirconium dioxide nanoparticles for preparation of a novel hydrogen peroxide biosensor.

The structure and the electron-transfer properties of cytochrome c (cyt c) absorbed on a silver electrode were analyzed by surface-enhanced resonance Raman spectroscopy. It was found that the absorbed cyt c exists in various conformational states depending on the electrode potential. In state I the native structure of the heme protein is fully preserved and the redox potential (+0.02 V vs saturated calomel electrode) is close to the value for cyt c in solution. In state II the heme iron exists in a mixture of five-coordinated high-spin and six-coordinated low-spin configurations. It had been shown that these configurations form a thermal equilibrium [Hildebrandt, P., & Stockburger, M. (1986) J. Phys. Chem. 90,6017]. It is demonstrated that these equilibria strongly depend on the charge distribution within the electrical double layer of the silver electrode/electrolyte interface, indicating that the changes in the coordination shell are induced by electrostatic interactions. The structural alterations in state II are apparently restricted to the heme crevice, which assumes an open conformation compared to the close structure in state I. This leads to a strong decrease of the redox potentials, which were determined to be -0.31 and -0.41 V for the five-coordinated high-spin and six-coordinated low-spin configurations, respectively. On the other hand, gross distortions of the protein structure can be excluded since the reversible proton-induced conformational change of cyt c as found in solution at low pH also takes place in state II of the absorbed cyt c. The linkage of cyt c molecules to the surface is mediated by charged amino acid groups, and it depends on the potential which groups are thermodynamically favored to form such a molecular binding site. The conformational states I and II, which are in potential-dependent equilibrium, therefore refer to two different molecular binding sites. At potentials below zero charge (less than approximately -0.6 V) a rapid denaturation of the absorbed cyt c is noted, which is reflected by drastic and irreversible changes in the surface-enhanced resonance Raman spectrum. Our results are discussed on the background of previous electrochemical studies of cyt c at electrodes.

/pdf/cytochrome-c-at-charged-interfaces-1-conformational-and-5fsshlymsx.pdf

Cytochrome c at charged interfaces. 1. Conformational and redox equilibria at the electrode/electrolyte interface probed by surface-enhanced resonance Raman spectroscopy.

In biosensors based on direct electron transfer in redox proteins, efficient electron-transfer pathways between the immobilized redox protein and the electrode surface have to be established so to allow a fast electron transfer and concomitantly avoiding free-diffusing redox species. In this review, prerequisites for the direct electron transfer of redox proteins and immobilization of redox proteins on the electrode surfaces are addressed. Based on the specific nature of different proteins and non-manual immobilization procedures, possible biosensor designs are discussed, namely biosensors based on (1) ferritin; (2) cytochrome c; (3) myoglobin; (4) hemoglobin; (5) horseradish peroxidase; (6) catalase; (7) glucose oxidase; and (8) xanthine oxidase.

F. Scheller

Papers

Functional properties of adsorbed hemoproteins