Fuqiang Shen

TL;DR: In this article, the application of various alloys and coatings in the oxidation protection of tungsten is reviewed, and their microstructure, oxidation behavior, and failure mechanism are analyzed and summarized.

TL;DR: In this paper, the evolution behavior of surface and interface morphologies, roughness and texture of tungsten disilicide coatings was studied using SEM, TEM, AFM combining with EBSD methodology.

TL;DR: In this paper, the evolution behavior of microstructure and phase composition of Si-MoSi2 composite coatings with different diffusion times were studied, and a typical three-layer diffusion structure was observed at cross-section of coatings, the MoSi2 phase and carbide phases formed in the outer layers, and the intermediate layer only consisted of MoSi 2 phase.

TL;DR: In this paper, a hot dip silicon-plating method was used to obtain fine MoSi2 grain size and higher surface silicon concentration, which results in a very low surface roughness.

TL;DR: Li et al. as mentioned in this paper summarized the relevant research of domestic and foreign scholars in the past 30 years, including the slurry sintering method (SS), suspension plasma spraying method (SPS), and halide activated pack cementation method (HAPC), including the growth mechanism and micromorphology of the coatings access by different preparation methods.