Influence of cooling rate on the microstructure and corrosion behavior of Al–Fe alloys

https://ro.uow.edu.au/cgi/viewcontent.cgi?article=5674&context=eispapers

Microstructures and mechanical properties of dual phase steel produced by laboratory simulated strip casting

Recommendations and guidelines for the performance of accurate heat transfer measurements in rapid forming processes

http://www.gotrawama.eu/Siderurgia/Microstructure%20and%20solidification%20thermal%20parameters%20in%20thin%20strip.pdf

Microstructure and solidification thermal parameters in thin strip continuous casting of a stainless steel

Heat transfer - A review of 2000 literature

An experimental study of initial solidification of 304 stainless steel melts in direct contact with copper substrates under conditions approximating the meniscus region of a strip caster has highlighted the importance of interfacial heat transfer during the first 30 ms of contact. The mechanisms governing initial heat transfer are strongly influenced by dynamic wetting phenomena. This has been illustrated experimentally by the effects of the buildup and melting of oxide films such as manganese silicates at the interface during successive immersions, by the role of surface active agents such as tellurium in the melt, and by the use of specially designed substrate textures to control contact areas.

Geoffrey R. Belton

Papers

Mechanisms of initial melt/substrate heat transfer pertinent to strip casting