G
Guangjie Huang
Researcher at Chongqing University
Publications - 11
Citations - 298
Guangjie Huang is an academic researcher from Chongqing University. The author has contributed to research in topics: Alloy & Magnesium alloy. The author has an hindex of 4, co-authored 11 publications receiving 183 citations.
Papers
More filters
Journal ArticleDOI
Tailoring the texture of magnesium alloy by twinning deformation to improve the rolling capability
TL;DR: In this paper, a method to weaken the strong basal texture of rolled magnesium alloy by twinning deformation is reported, and the corresponding mechanisms are addressed and discussed, as well as a dramatically increased maximum thickness reduction per pass during subsequent rolling at 300°C is achieved.
Journal ArticleDOI
Improvement of mechanical properties of a cryorolled Al-Mg-Si alloy through warm rolling and aging
TL;DR: In this paper, the performance of Al-Mg-Si alloys with and without pre-aging treatment were investigated by tensile tests, differential scanning calorimetry, X-ray diffraction and transmission electron microscopy.
Journal ArticleDOI
Effect of warm deformation on precipitation and mechanical properties of a cryorolled Al-Zn-Mg-Cu sheet
TL;DR: In this paper, the effect of warm rolling on precipitation and mechanical properties of a cryorolled Al-Zn-Mg-Cu sheet was investigated by hardness measurements, tensile tests, Electron backscatter diffraction, X-ray diffraction and transmission electron microscopy and atom probe tomography.
Journal ArticleDOI
A weak texture dependence of Hall–Petch relation in a rare-earth containing magnesium alloy
Junmin Li,Jing Xu,E Aiden,Bo Guan,Yunchang Xin,Xuedong Wei,Guangjie Huang,Chenglu Liu,Qing Liu,Qing Liu +9 more
TL;DR: In this paper, the authors reported a weak texture dependence of k in a rare earth containing Mg-2Zn-1Gd plate with two peaks of (0002) poles inclining approximately ± 30° away from the ND toward the TD.
Journal ArticleDOI
Investigation of the hardening behavior during recrystallization annealing in Al-Mg-Sc alloy
TL;DR: In this article, the hardness of Al-3Mg-0.2Sc alloy with a single pass friction stir processing (FSP) was cold rolled, followed by recrystallization annealing.