Solar simulators are used to test components and systems under controlled and repeatable conditions, often in locations with unsuitable insolation for outdoor testing. The growth in renewable energy generation has led to an increased need to develop, manufacture and test components and subsystems for solar thermal, photovoltaic (PV), and concentrating optics for both thermal and electrical solar applications. At the heart of any solar simulator is the light source itself. This paper reviews the light sources available for both low and high-flux solar simulators used for thermal applications. Criteria considered include a comparison of the lamp wavelength spectrum with the solar spectrum, lamp intensity, cost, stability, durability, and any hazards associated with use. Four main lamp types are discussed in detail, namely argon arc, the metal halide, tungsten halogen lamp, and xenon arc lamps. In addition to describing the characteristics of each lamp type, the popularity of usage of each type over time is also indicated. This is followed by guidelines for selecting a suitable lamp, depending on the requirements of the user and the criteria applied for selection. The appropriate international standards are also addressed and discussed. The review shows that metal halide and xenon arc lamps predominate, since both provide a good spectral match to the solar output. The xenon lamp provides a more intense and stable output, but has the disadvantages of being a high-pressure component, requiring infrared filtering, and the need of a more complex and expensive power supply. As a result, many new solar simulators prefer metal halide lamps.

/pdf/light-source-selection-for-a-solar-simulator-for-thermal-1s0tou712q.pdf

Light source selection for a solar simulator for thermal applications: A review

Plasmonic nanofluids for high photothermal conversion efficiency in direct absorption solar collectors: Fundamentals and applications

Flat-plate solar-collector performance evaluation with a solar simulator as a basis for collector selection and performance prediction

Development of a simple low-cost solar simulator for indoor collector testing

The fabrication and testing of a solar simulator for indoor testing of solar collector are described. Consisting of Philips 500 W halogen lamps with built-in reflector, which are arranged at 30 cm apart, the system covers a test area suitable for a solar collector of size 120 cm by 53 cm. The height of the lamps above the solar collector under test is set to 160 cm. Measurement of the uniformity of the irradiance over the test area has been made. Four sets of irradiance mapping were performed at 466, 580, 686, and 804 W/m2 , yielding at each point the irradiance uniformity percentage of 8.9, 7.6, 6.9, and 7.8%, respectively. The infrared radiation produced by the lamps was filtered by air flowing over the test area.

Fabrication and Irradiance Mapping of a Low Cost Solar Simulator for Indoor Testing of Solar Collector

A low cost air mass 2 solar simulator for testing flat-plate solar collectors was developed and operated at Lewis. Total cost was less than $10,800/sq m ($1000/sq ft). It consists of an array of 143 tungsten-halogen 300-watt lamps, each having integral dichroic coated reflectors. A second array of 143 respective hexagonal-shaped plastic Fresnel lenses are located approximately 1 focal length from the lamps. The simulator will produce a uniform collimated beam covering an area of 1.2 by 1.2m(4 by 4 ft). Design features, construction details, and component costs are given, as well as measured results on a 12-lamp prototype.

https://ntrs.nasa.gov/api/citations/19740019606/downloads/19740019606.pdf

H.B. Curtis

Papers

Low-cost, air mass 2 solar simulator