Siemens, s.r.o. Žižkova 13 040 01 Košice Tel.: 095/728 2811 Fax: 095/728 2833 SWH, s.r.o. Stromová 9 837 96 Bratislava Tel.: 07/5868 4011 Fax: 07/598 5400 Osram Slovakia, a.s. Komárňanská cesta 7 940 93 Nové Zámky Tel.: 0817/464 111 Fax: 0817/464 880 Siemens, s.r.o. Adama Trajána 4648/2 921 01 Piešťany Tel.: 0838/7724 311 Fax: 0838/7628 995 Siemens i-center, s.r.o. Stará Vajnorská cesta 15 832 74 Bratislava Tel.: 07/721 123 Fax: 07/721 110 BSH Drives and Pumps, s.r.o. Továrenská 2 071 90 Michalovce Tel.: 0946/6417 404 Fax: 0946/6417 587 Siemens, s.r.o. Nám. gen. Svobodu 1 9765 17 Banská Bystrica Tel.: 088/4132 871 Fax: 088/4132 872 Volkswagen Elektrické systémy, s.r.o. Na Priehon 50 949 05 Nitra Tel.: 087/51 82 48 Fax: 0875/51 37 46 Technical University of Košice Slovakia Faculty of Electrical Engineering and Informatics

Annual Report for 1999

Integrated optical frequency comb technologies

We use dispersive Fourier transformation to measure shot-to-shot spectral instabilities in femtosecond supercontinuum generation. We study both the onset phase of supercontinuum generation with distinct dispersive wave generation, as well as a highly-unstable supercontinuum regime spanning an octave in bandwidth. Wavelength correlation maps allow interactions between separated spectral components to be identified, even when such interactions are not apparent in shot-to-shot or average measurements. Experimental results are interpreted using numerical simulations. Our results show the clear advantages of dispersive Fourier transformation for studying spectral noise during supercontinuum generation.

Real time noise and wavelength correlations in octave-spanning supercontinuum generation

We present a 1.75-GHz self-referenceable frequency comb from a vertical external-cavity surface-emitting laser (VECSEL) passively modelocked with a semiconductor saturable absorber mirror (SESAM). The VECSEL delivers 231-fs pulses with an average power of 100 mW and is optimized for stable and reliable operation. The optical spectrum was centered around 1038 nm and nearly transform-limited with a full width half maximum (FWHM) bandwidth of 5.5 nm. The pulses were first amplified to an average power of 5.5 W using a backward-pumped Yb-doped double-clad large mode area (LMA) fiber and then compressed to 85 fs with 2.2 W of average power with a passive LMA fiber and transmission gratings. Subsequently, we launched the pulses into a highly nonlinear photonic crystal fiber (PCF) and generated a coherent octave-spanning supercontinuum (SC). We then detected the carrier-envelope offset (CEO) frequency (fCEO) beat note using a standard f-to-2f-interferometer. The fCEO exhibits a signal-to-noise ratio of 17 dB in a 100-kHz resolution bandwidth and a FWHM of 10 MHz. To our knowledge, this is the first report on the detection of the fCEO from a semiconductor laser, opening the door to fully stabilized compact frequency combs based on modelocked semiconductor disk lasers.

Gigahertz Self-referenceable Frequency Comb from a Semiconductor Disk Laser

Ability to selectively enhance the amplitude and maintain high coherence of the supercontinuum signal with long pulses is gaining significance. In this work an extra degree of freedom afforded by varying the dispersion profile of a waveguide is utilized to selectively enhance supercontinuum. As much as 16 dB signal enhancement in the telecom window and 100 nm of wavelength extension is achieved with a cascaded waveguide, compared to a fixed dispersion waveguide. Waveguide tapering, in particular with increasing width, is determined to have a flatter and more coherent supercontinuum than a fixed dispersion waveguide when longer input pulses are used. Furthermore, due to the strong birefringence of an asymmetric silicon waveguide the supercontinuum signal is broadened by pumping simultaneously with both quasitransverse electric (TE) and quasi-transverse magnetic (TM) mode in the anomalous dispersion regime. Thus, by controlling the dispersion for the two modes selective signal generation is obtained. Such waveguides offer several advantages over optical fiber as the variation in dispersion can be controlled with greater flexibility in an integrated platform. This work paves the way forward for various applications in fields ranging from medicine to telecom where specific wavelength windows need to be targeted.

Supercontinuum generation in varying-dispersion and birefringent silicon waveguide

A topical review of numerical and experimental studies of supercontinuum generation in photonic crystal fiber is presented over the full range of experimentally reported parameters, from the femtosecond to the continuous-wave regime. Results from numerical simulations are used to discuss the temporal and spectral characteristics of the supercontinuum, and to interpret the physics of the underlying spectral broadening processes. Particular attention is given to the case of supercontinuum generation seeded by femtosecond pulses in the anomalous group velocity dispersion regime of photonic crystal fiber, where the processes of soliton fission, stimulated Raman scattering, and dispersive wave generation are reviewed in detail. The corresponding intensity and phase stability properties of the supercontinuum spectra generated under different conditions are also discussed.

H. Ludvigsen

Papers

Supercontinuum generation, photonic crystal fiber

Analysis of the linewidth and continous tuning range of a grating cavity