Internal structure and permeability of major strike-slip fault zones: the Median Tectonic Line in Mie Prefecture, Southwest Japan

Carbon capture and storage is a subject around which there is a growing level of public awareness. A range of geological scenarios may be used for underground CO2 storage; declining oil and gas fields, saline aquifers and coal seams. Saline aquifers are reckoned to offer the largest overall storage potential and the this book offers key insights into aquifer storage issues. 

European collaborative projects between 1998 and 2006 have researched the potential for large-scale storage of CO2 in underground saline aquifer formations. This book consolidates the findings of the SACS and the CO2STORE projects into a manual of observations and recommendations, aiming to provide technically robust guidelines for effective and safe storage of CO2 in a range of geological settings. A wide range of geological, environmental and planning issues are addressed, and it forms a sound basis for establishing recommended procedures for the planning and setting up of a potential CO2 storage operation.

It will be useful to commercial companies, regulatory authorities and NGOs in evaluating possible new CO2 storage sites in Europe and elsewhere.

Best practice for the storage of CO2 in saline aquifers - observations and guidelines from the SACS and CO2STORE projects

[1] Detailed experimental studies of the development of permeability of crustal rock during deformation are essential in helping to understand fault mechanics and constrain larger-scale models that predict bulk fluid flow within the crust. Permeability is particularly enhanced in the damage zone of faults, where microfracture damage accumulates under stress less than that required for macroscopic failure. Experiments performed in the prefailure region can provide data directly applicable to these zones of microfracture damage surrounding faults. The strength, permeability, and pore fluid volume evolution of initially intact crystalline rocks (Cerro Cristales granodiorite and Westerly granite) under increasing differential load leading to macroscopic failure has been determined at water pore pressures of 50 MPa and varying effective pressures from 10 to 50 MPa. Permeability is seen to increase by up to, and over, 2 orders of magnitude prior to macroscopic failure, with the greatest increase seen at lowest effective pressures. Postfailure permeability is shown to be over 3 orders of magnitude higher than initial intact permeabilities and approaches the lower limit of predicted in situ bulk crustal permeabilities. Increasing amplitude cyclic loading tests show permeability-stress hysteresis, with high permeabilities maintained as differential stress is reduced and the greatest permeability increases are seen between 90 and 99% of the failure stress. Prefailure permeabilities are nearly 7 to 9 orders of magnitude lower than that predicted by some high-pressure diffusive models suggesting that if these models are correct, microfracture matrix flow cannot dominate, and that bulk fluid flow must be dominated by larger-scale structures such as macrofractures. We present a model, based on our data, in which the permeability of a highly stressed fault tip process zone in low-permeability crystalline rocks increases by more than 2 orders of magnitude. Stress reduction related to the onward migration of the fault tip close damage zone cracks, while some permeability is maintained due to hysteresis from permanent microfracture damage.

/pdf/experimental-measurements-of-permeability-evolution-during-4y7a8inhnr.pdf

Experimental measurements of permeability evolution during triaxial compression of initially intact crystalline rocks and implications for fluid flow in fault zones

J.D. Blacic

Papers

Hydraulic diffusivity measurements on laboratory rock samples using an oscillating pore pressure method