Stratigraphic, temperature gradient, hydrogeochemical, and hydrologic data have been integrated with geologic data from previous studies to show the structural configuration of the Valles caldera hydrothermal ouflow plume. Hydrologic data suggest that 25–50% of the discharge of the Valles outflow is confined to the Jemez fault zone, which predates caldera formation. Thermal gradient data from bores penetrating the plume show that shallow gradients are highest in the vicinity of the Jemez fault zone (up to 190°C/km). Shallow heat flow above the hydrothermal plume is as high as 500 mW m−2 near core hole VC-1 (Jemez fault zone) to 200 mW m−2 at Fenton Hill (Jemez Plateau). Chemical and isotopic data indicate that two source reservoirs within the caldera (Redondo Creek and Sulphur Springs reservoirs) are parents to mixed fluids flowing in the hydrothermal plume. However, isotopic data, borehole data, basic geology, and inverse relations between temperature and chloride content at major hot springs indicate that no single reservoir fluid and no single diluting fluid are involved in mixing. The Valles caldera hydrothermal plume is structurally dominated by lateral flow through a belt of vertical conduits (Jemez fault zone) that strike away from the source reservoir. Stratigraphically confined flow is present but dispersed over a wide area in relatively impermeable rocks. The Valles configuration is contrasted with the configuration of the hydrothermal plume at Roosevelt Hot Springs, which is dominated by lateral flow through a near-surface, widespread, permeable aquifer. Data from 12 other representative geothermal systems show that outflow plumes occur in a variety of magmatic and tectonic settings, have varying reservoir compositions, and have different flow characteristics. Although temperature reversals are commonly observed in wells penetrating outflow plumes, reversals are not observed in all plumes. Less information is available on the absolute age of hydrothermal outflow plumes, although the data show that they can be as old as 106 years and display episodic behavior.

The Hydrothermal Outflow Plume of Valles Caldera, New Mexico, and a Comparison With Other Outflow Plumes

A conceptual geologic model of the Roosevelt Hot Springs hydrothermal system was developed by a review of the available literature. The hydrothermal system consists of a meteoric recharge area in the Mineral Mountains, fluid circulation paths to depth, a heat source, and an outflow plume. A conceptual model based on the available data can be simulated in the native state using parameters that fall within observed ranges. The model temperatures, recharge rates, and fluid travel times are sensitive to the permeability in the Mineral Mountains. The simulation results suggests the presence of a magma chamber at depth as the likely heat source. A two-dimensional study of the hydrothermal system can be used to establish boundary conditions for further study of the geothermal reservoir.

/pdf/conceptual-geologic-model-and-native-state-model-of-the-1cyejqq975.pdf

Conceptual geologic model and native state model of the Roosevelt Hot Springs hydrothermal system

Generalized geologic and other data are tabulated for 24 potential hot dry rock (HDR) sites in the contiguous United States. The data show that HDR resources occur in many geologic and tectonic settings. Potential reservoir rocks at each prospect are described and each system is cateogrized accoridng to inferred heat sources. The Fenton Hill area in New Mexico is discussed in detail because this region may be considered ideal for HDR development. Three other prospectively valuable localities are described: The Geysers-Clear lake region in California, the Roosevelt Hot Springs area in Utah, and the White Mountains region in New Hampshire. These areas are singled out to illustrate the roles of significantly different geology and geophysics, reservoir rocks, and reservoir heat contents in possible HDR developments.

Candidate sites for future hot-dry-rock development in the United States

https://digital.library.unt.edu/ark:/67531/metadc1189295/m2/1/high_res_d/6537080.pdf

/pdf/conceptual-geologic-model-and-native-state-model-of-the-2z3f3tzd12.pdf

The Roosevelt Hot Springs area in west-central Utah possesses several features indicating potential for hot dry rock (HDR) geothermal development. The area is characterized by extensional tectonics and a high regional heat flow of greater than 105 mW/m/sup 2/. The presence of silicic volcanic rocks as young as 0.5 to 0.8 Myr and totaling 14 km/sup 3/ in volume indicates underlying magma reservoirs may be the heat source for the thermal anomaly. Several hot dry wells have been drilled on the periphery of the geothermal field. Information obtained on three of these deep wells shows that they have thermal gradients of 55 to 60/sup 0/C/km and bottom in impermeable Tertiary granitic and Precambrian gneissic units. The Tertiary granite is the preferred HDR reservoir rock because Precambrian gneissic rocks possess a well-developed banded foliation, making fracture control over the reservoir more difficult. Based on a fairly conservative estimate of 160 km/sup 2/ for the thermal anomaly present at Roosevelt Hot Springs, the area designated favorable for HDR geothermal exploration may be on the order of seven times or more than the hydrogeothermal area currently under development.

/pdf/hot-dry-rock-geothermal-potential-of-roosevelt-hot-springs-1324py9o08.pdf

J. East

Papers

Hot dry rock geothermal potential of Roosevelt Hot Springs area: review of data and recommendations