The validity of the cubic law for laminar flow of fluids through open fractures consisting of parallel planar plates has been established by others over a wide range of conditions with apertures ranging down to a minimum of 0.2 µm. The law may be given in simplified form by Q/Δh = C(2b)3, where Q is the flow rate, Δh is the difference in hydraulic head, C is a constant that depends on the flow geometry and fluid properties, and 2b is the fracture aperture. The validity of this law for flow in a closed fracture where the surfaces are in contact and the aperture is being decreased under stress has been investigated at room temperature by using homogeneous samples of granite, basalt, and marble. Tension fractures were artificially induced, and the laboratory setup used radial as well as straight flow geometries. Apertures ranged from 250 down to 4µm, which was the minimum size that could be attained under a normal stress of 20 MPa. The cubic law was found to be valid whether the fracture surfaces were held open or were being closed under stress, and the results are not dependent on rock type. Permeability was uniquely defined by fracture aperture and was independent of the stress history used in these investigations. The effects of deviations from the ideal parallel plate concept only cause an apparent reduction in flow and may be incorporated into the cubic law by replacing C by C/ƒ. The factor ƒ varied from 1.04 to 1.65 in these investigations. The model of a fracture that is being closed under normal stress is visualized as being controlled by the strength of the asperities that are in contact. These contact areas are able to withstand significant stresses while maintaining space for fluids to continue to flow as the fracture aperture decreases. The controlling factor is the magnitude of the aperture, and since flow depends on (2b)3, a slight change in aperture evidently can easily dominate any other change in the geometry of the flow field. Thus one does not see any noticeable shift in the correlations of our experimental results in passing from a condition where the fracture surfaces were held open to one where the surfaces were being closed under stress.

/pdf/validity-of-cubic-law-for-fluid-flow-in-a-deformable-rock-2ynq4id3hq.pdf

VALIDITY OF CUBIC LAW FOR FLUID FLOW IN A DEFORMABLE ROCK FRACTURE - eScholarship

Evaluating Fractured Reservoirs Reservoir Management Detecting And Predicting Fracture Occurrence and Intensity Analysis Of Anisotropic Reservoirs Analysis Procedures in Fractured Reservoirs Appendix A: List of Documented Fractured Reservoirs Appendix B: Procedures Checklist Appendix C: Averaging Techniques

Geologic Analysis of Naturally Fractured Reservoirs

A one-dimensional dual-porosity model has been developed for the purpose of studying variably saturated water flow and solute transport in structured soils or fractured rocks. The model involves two overlaying continua at the macroscopic level: a macropore or fracture pore system and a less permeable matrix pore system. Water in both pore systems is assumed to be mobile. Variably saturated water flow in the matrix as well as in the fracture pore system is described with the Richards' equation, and solute transport is described with the convection-dispersion equation. Transfer of water and solutes between the two pore regions is simulated by means of first-order rate equations. The mass transfer term for solute transport includes both convective and diffusive components. The formulation leads to two coupled systems of nonlinear partial differential equations which were solved numerically using the Galerkin finite element method. Simulation results demonstrate the complicated nature of solute leaching in structured, unsaturated porous media during transient water flow. Sensitivity studies show the importance of having accurate estimates of the hydraulic conductivity near the surface of soil aggregates or rock matrix blocks. The proposed model is capable of simulating preferential flow situations using parameters which can be related to physical and chemical properties of the medium.

A dual-porosity model for simulating the preferential movement of water and solutes in structured porous media

A review of techniques, advances and outstanding issues in numerical modelling for rock mechanics and rock engineering

In this paper, theoretical and experimental approaches to flow, hydrodynamic dispersion, and miscible and immiscible displacement processes in reservoir rocks are reviewed and discussed. Both macroscopically homogeneous and heterogeneous rocks are considered. The latter are characterized by large-scale spatial variations and correlations in their effective properties and include rocks that may be characterized by several distinct degrees of porosity, a well-known example of which is a fractured rock with two degrees of porosity---those of the pores and of the fractures. First, the diagenetic processes that give rise to the present reservoir rocks are discussed and a few geometrical models of such processes are described. Then, measurement and characterization of important properties, such as pore-size distribution, pore-space topology, and pore surface roughness, and morphological properties of fracture networks are discussed. It is shown that fractal and percolation concepts play important roles in the characterization of rocks, from the smallest length scale at the pore level to the largest length scales at the fracture and fault scales. Next, various structural models of homogeneous and heterogeneous rock are discussed, and theoretical and computer simulation approaches to flow, dispersion, and displacement in such systems are reviewed. Two different modeling approaches to these phenomena are compared. The first approach is based on the classical equations of transport supplemented with constitutive equations describing the transport and other important coefficients and parameters. These are called the continuum models. The second approach is based on network models of pore space and fractured rocks; it models the phenomena at the smallest scale, a pore or fracture, and then employs large-scale simulation and modern concepts of the statistical physics of disordered systems, such as scaling and universality, to obtain the macroscopic properties of the system. The fundamental roles of the interconnectivity of the rock and its wetting properties in dispersion and two-phase flows, and those of microscopic and macroscopic heterogeneities in miscible displacements are emphasized. Two important conceptual advances for modeling fractured rocks and studying flow phenomena in porous media are also discussed. The first, based on cellular automata, can in principle be used for computing macroscopic properties of flow phenomena in any porous medium, regardless of the complexity of its structure. The second, simulated annealing, borrowed from optimization processes and the statistical mechanics of spin glasses, is used for finding the optimum structure of a fractured reservoir that honors a limited amount of experimental data.

Flow phenomena in rocks : from continuum models to fractals, percolation, cellular automata, and simulated annealing

The theory of flow through fractured rock and homogeneous anisotropic porous media is used to determine when a fractured rock behaves as a continuum. A fractured rock can be said to behave like an equivalent porous medium when (1) there is an insignificant change in the value of the equivalent permeability with a small addition or subtraction to the test volume and (2) an equivalent permeability tensor exists which predicts the correct flux when the direction of a constant gradient is changed. Field studies of fracture geometry are reviewed and a realistic, two-dimensional fracture system model is developed. The shape, size, orientation, and location of fractures in an impermeable matrix are random variables in the model. These variables are randomly distributed according to field data currently available in the literature. The fracture system models are subjected to simulated flow tests. The results of the flow tests are plotted as permeability ‘ellipses.’ The size and shape of these permeability ellipses show that fractured rock does not always behave as a homogeneous, anisotropic porous medium with a symmetric permeability tensor. Fracture systems behave more like porous media when (1) fracture density is increased, (2) apertures are constant rather than distributed, (3) orientations are distributed rather than constant, and (4) larger sample sizes are tested. Preliminary results indicate the use of this new tool, when perfected, will greatly enhance our ability to analyze field data on fractured rock systems. The tool can be used to distinguish between fractured systems which can be treated as porous media and fractured systems which must be treated as a collection of discrete fracture flow paths.

/pdf/porous-media-equivalents-for-networks-of-discontinuous-3bc2n5am14.pdf

J.S. Remer

Papers

Porous media equivalents for networks of discontinuous fractures

Porous Media Equivalents For Networks Of Discontinous Fractures

Porous media equivalents for networks of discontinuous fractures [Hydrology]