Subduction zones are home to the most seismically active faults on the planet. The shallow megathrust interfaces of subduction zones host Earth’s largest earthquakes and are likely the only faults capable of magnitude 9+ ruptures. Despite these facts, our knowledge of subduction zone geometry—which likely plays a key role in determining the spatial extent and ultimately the size of subduction zone earthquakes—is incomplete. We calculated the three-dimensional geometries of all seismically active global subduction zones. The resulting model, called Slab2, provides a uniform geometrical analysis of all currently subducting slabs.

https://science.sciencemag.org/content/sci/362/6410/58.full.pdf

Slab2, a comprehensive subduction zone geometry model

As the chronicle of plate motions through time, paleogeography is fundamental to our understanding of plate tectonics and its role in shaping the geology of the present-day. To properly appreciate the history of tectonics—and its influence on the deep Earth and climate—it is imperative to seek an accurate and global model of paleogeography. However, owing to the incessant loss of oceanic lithosphere through subduction, the paleogeographic reconstruction of ‘full-plates’ (including oceanic lithosphere) becomes increasingly challenging with age. Prior to 150 Ma ∼60% of the lithosphere is missing and reconstructions are developed without explicit regard for oceanic lithosphere or plate tectonic principles; in effect, reflecting the earlier mobilistic paradigm of continental drift. Although these ‘continental’ reconstructions have been immensely useful, the next-generation of mantle models requires global plate kinematic descriptions with full-plate reconstructions. Moreover, in disregarding (or only loosely applying) plate tectonic rules, continental reconstructions fail to take advantage of a wealth of additional information in the form of practical constraints. Following a series of new developments, both in geodynamic theory and analytical tools, it is now feasible to construct full-plate models that lend themselves to testing by the wider Earth-science community. Such a model is presented here for the late Paleozoic (410–250 Ma) together with a review of the underlying data. Although we expect this model to be particularly useful for numerical mantle modeling, we hope that it will also serve as a general framework for understanding late Paleozoic tectonics, one on which future improvements can be built and further tested.

Plate Tectonics in the Late Paleozoic

textIn the midst of the turbulence wrought by the global economy, it has become common to see projects as an essential medium for achieving change. However, project based learning practices - as a subset of organizational learning practices- have not kept pace with this development. To explore this concern, we have carried out a study on practices adopted by organizations for learning through projects involving nineteen companies from across Europe and from a range of different industries. We use the concepts of variation, selection and retention in organizational learning to analyze our findings and report the challenges faced by project based organizations in each of the areas highlighted. We conclude that time pressures, centralization and deferral are the key characteristics of learning in project based firms and that these impede project based members in learning from and through projects.

/pdf/quantity-versus-quality-in-project-based-learning-practices-3j5yjuu8hu.pdf

Quantity versus Quality in Project Based Learning Practices

Fault linkage and relay structures in extensional settings—A review

The temperature at the 410-km discontinuity is re-evaluated by comparing the depth of the discontinuity with the olivine–wadsleyite transition pressure obtained using in situ X-ray diffraction experiments by Katsura et al. (2004a) and equation of state (EoS) of MgO by Tange et al. (2009) (Tange scale) and Matsui et al. (2000) . The newly estimated temperature is 1830 ± 48 K, 70 K higher than that by our previous estimation. The EoSes of the major mantle minerals (olivine, wadsleyite, ringwoodite and perovskite) are also recalculated using the Tange scale. The adiabatic temperature gradient is calculated using the thermal expansion coefficient obtained from these EoSes. The adiabatic temperature gradient gradually decreases with increasing depth without a phase transition, and abruptly increases in association with phase transitions. The adiabatic temperature gradients are found to be 04–0.5 and 0.3 K/km in the upper and lower parts of the mantle, respectively. The temperatures at a depth of 200 km, the bottom of the mantle transition zone, the top of the lower mantle and a depth of 2700 km are found to be 1720 ± 40, 2010 ± 40, 1980 ± 40, and 2730 ± 50 K. The mantle potential temperature is found to be 1610 ± 35 K.

Adiabatic temperature profile in the mantle

We reconstructed Philippine Sea and East Asian plate tectonics since 52 Ma from 28 slabs mapped in 3-D from global tomography, with a subducted area of ~25% of present-day global oceanic lithosphere Slab constraints include subducted parts of existing Pacific, Indian, and Philippine Sea oceans, plus wholly subducted proto-South China Sea and newly discovered “East Asian Sea” Mapped slabs were unfolded and restored to the Earth surface using three methodologies and input to globally consistent plate reconstructions Important constraints include the following: (1) the Ryukyu slab is ~1000 km N-S, too short to account for ~20° Philippine Sea northward motion from paleolatitudes; (2) the Marianas-Pacific subduction zone was at its present location (±200 km) since 48 ± 10 Ma based on a >1000 km deep slab wall; (3) the 8000 × 2500 km East Asian Sea existed between the Pacific and Indian Oceans at 52 Ma based on lower mantle flat slabs; (4) the Caroline back-arc basin moved with the Pacific, based on the overlapping, coeval Caroline hot spot track These new constraints allow two classes of Philippine Sea plate models, which we compared to paleomagnetic and geologic data Our preferred model involves Philippine Sea nucleation above the Manus plume (0°/150°E) near the Pacific-East Asian Sea plate boundary Large Philippine Sea westward motion and post-40 Ma maximum 80° clockwise rotation accompanied late Eocene-Oligocene collision with the Caroline/Pacific plate The Philippine Sea moved northward post-25 Ma over the northern East Asian Sea, forming a northern Philippine Sea arc that collided with the SW Japan-Ryukyu margin in the Miocene (~20–14 Ma)

Philippine Sea and East Asian plate tectonics since 52 Ma constrained by new subducted slab reconstruction methods

We reconstructed Philippine Sea and East Asian plate tectonics since 52 Ma from 28 slabs mapped in 3-D from global tomography, with a subducted area of ~25% of present-day global oceanic lithosphere. Slab constraints include subducted parts of existing Pacific, Indian, and Philippine Sea oceans, plus wholly subducted proto-South China Sea and newly discovered “East Asian Sea.” Mapped slabs were unfolded and restored to the Earth surface using three methodologies and input to globally consistent plate reconstructions. Important constraints include the following: (1) the Ryukyu slab is ~1000 km N-S, too short to account for ~20° Philippine Sea northward motion from paleolatitudes; (2) the Marianas-Pacific subduction zone was at its present location (±200 km) since 48 ± 10 Ma based on a >1000 km deep slab wall; (3) the 8000 × 2500 km East Asian Sea existed between the Pacific and Indian Oceans at 52 Ma based on lower mantle flat slabs; (4) the Caroline back-arc basin moved with the Pacific, based on the overlapping, coeval Caroline hot spot track. These new constraints allow two classes of Philippine Sea plate models, which we compared to paleomagnetic and geologic data. Our preferred model involves Philippine Sea nucleation above the Manus plume (0°/150°E) near the Pacific-East Asian Sea plate boundary. Large Philippine Sea westward motion and post-40 Ma maximum 80° clockwise rotation accompanied late Eocene-Oligocene collision with the Caroline/Pacific plate. The Philippine Sea moved northward post-25 Ma over the northern East Asian Sea, forming a northern Philippine Sea arc that collided with the SW Japan-Ryukyu margin in the Miocene (~20–14 Ma).

The Andean margin is the plate-tectonic paradigm for long-lived, continuous subduction, yet its geology since the late Mesozoic era (the past 100 million years or so) has been far from steady state. The episodic deformation and magmatism have been attributed to cyclic changes in the dip angle of the subducting slab, slab break-off and the penetration of the slab into the lower mantle; the role of plate tectonics remains unclear, owing to the extensive subduction of the Nazca–Farallon plate (which has resulted in more than 5,500 kilometres of lithosphere being lost to the mantle). Here, using tomographic data, we recreate the plate-tectonic geometry of the subducted Nazca slab, which enables us to reconstruct Andean plate tectonics since the late Mesozoic. Our model suggests that the current phase of Nazca subduction began at the northern Andes (5° S) during the late Cretaceous period (around 80 million years ago) and propagated southwards, reaching the southern Andes (40° S) by the early Cenozoic era (around 55 million year ago). Thus, contrary to the current paradigm, Nazca subduction has not been fully continuous since the Mesozoic but instead included episodic divergent phases. In addition, we find that foredeep sedimentation and the initiation of Andean compression are both linked to interactions between the Nazca slab and the lower mantle, consistent with previous modelling. The current phase of subduction of the Nazca slab was established in the Peruvian Andes after a plate reorganization around 80 million years ago and then propagated progressively southwards.

Southward propagation of Nazca subduction along the Andes.

The past size and location of the hypothesized proto-South China Sea vanished ocean basin has important plate-tectonic implications for Southeast Asia since the Mesozoic. Here we present new details on proto-South China Sea paleogeography using mapped and unfolded slabs from tomography. Mapped slabs included: the Eurasia-South China Sea slab subducting at the Manila trench; the northern Philippine Sea Plate slab subducting at the Ryukyu trench; and, a swath of detached, subhorizontal, slab-like tomographic anomalies directly under the South China Sea at 450 to 700 km depths that we show is subducted ‘northern proto-South China Sea’ lithosphere. Slab unfolding revealed that the South China Sea lay directly above the ‘northern Proto-South China Sea’ with both extending 400 to 500 km to the east of the present Manila trench prior to subduction. Our slab-based plate reconstruction indicated the proto-South China Sea was consumed by double-sided subduction, as follows: (1) The ‘northern proto-South China Sea’ subducted in the Oligo–Miocene under the Dangerous Grounds and southward expanding South China Sea by in-place ‘self subduction’ similar to the western Mediterranean basins; (2) limited southward subduction of the proto-South China Sea under Borneo occurred pre-Oligocene, represented by the 800–900 km deep ‘southern proto-South China Sea’ slab.

/pdf/proto-south-china-sea-plate-tectonics-using-subducted-slab-ey19x1cltj.pdf

Proto-South China Sea Plate Tectonics Using Subducted Slab Constraints from Tomography

\n Recent studies have debated the timing and spatial configuration of a possible intersection between the Pacific-Izanagi spreading ridge and the northeast Asian continental margin during Cretaceous or early Cenozoic times. Here we examine a newly compiled magmatic catalog of ∼900 published Cretaceous to Miocene igneous rock radioisotopic values and ages from the northeast Asian margin for ridge subduction evidence. Our synthesis reveals that a near-synchronous 56–46 Ma magmatic gap occurred across ∼1500 km of the Eurasian continental margin between Japan and Sikhote-Alin, Russian Far East. The magmatic gap separated two distinct phases of igneous activity: (1) an older, Cretaceous to Paleocene pre–56 Ma episode that had relatively lower εNd(t) (−15 to + 2), elevated (87Sr/86Sr)0 (initial ratio, 0.704–0.714), and relatively higher magmatic fluxes (∼1090 km2/m.y.); and (2) a younger, late Eocene to Miocene post–46 Ma phase that had relatively elevated εNd(t) (−2 to + 10), lower (87Sr/86Sr)0 (0.702–0.707), and a lower 390 km2/m.y. magmatic flux. The 56–46 Ma magmatic gap links other geological evidence across northeast Asia to constrain an early Cenozoic, low-angle ridge-trench intersection that had profound consequences for the Eurasian continental margin, and possibly led to the ca. 53–47 Ma Pacific plate reorganization.

Jonny Wu

Papers

Philippine Sea and East Asian plate tectonics since 52 Ma constrained by new subducted slab reconstruction methods

Philippine Sea and East Asian plate tectonics since 52 Ma constrained by new subducted slab reconstruction methods

Southward propagation of Nazca subduction along the Andes.

Proto-South China Sea Plate Tectonics Using Subducted Slab Constraints from Tomography

Izanagi-Pacific ridge subduction revealed by a 56 to 46 Ma magmatic gap along the northeast Asian margin