Solid-state switch-mode rectification converters have reached a matured level for improving power quality in terms of power-factor correction (PFC), reduced total harmonic distortion at input AC mains and precisely regulated DC output in buck, boost, buck-boost and multilevel modes with unidirectional and bidirectional power flow. This paper deals with a comprehensive review of improved power quality converters (IPQCs) configurations, control approaches, design features, selection of components, other related considerations, and their suitability and selection for specific applications. It is targeted to provide a wide spectrum on the status of IPQC technology to researchers, designers and application engineers working on switched-mode AC-DC converters. A classified list of more than 450 research publications on the state of art of IPQC is also given for a quick reference.

/pdf/a-review-of-single-phase-improved-power-quality-ac-dc-2pm6h4zjxq.pdf

A review of single-phase improved power quality AC-DC converters

New recommendations and future standards have increased the interest in power factor correction circuits. There are multiple solutions in which line current is sinusoidal. In addition, a great number of circuits have been proposed with nonsinusoidal line current. In this paper, a review of the most interesting solutions for single phase and low power applications is carried out. They are classified attending to the line current waveform, energy processing, number of switches, control loops, etc. The major advantages and disadvantages are highlighted and the field of application is found.

Single phase power factor correction: a survey

This paper explores predictive digital current programmed control for valley, peak or average current. The control laws are derived for the three basic converters: buck, boost, and buck-boost. It is found that for each variable of interest (valley, peak or average current) there is a choice of the appropriate pulse-width modulation method to achieve predictive digital current control without oscillation problems. The proposed digital control techniques can be used in a range of power conversion applications, including rectifiers with power factor correction (PFC). Very low current distortion meeting strict avionics requirements (400-800 Hz line frequency) is experimentally demonstrated on a digitally controlled boost PFC employing predictive average current programmed control.

/pdf/predictive-digital-current-programmed-control-276hrdxplj.pdf

Predictive digital current programmed control

A new family of single stage isolated power-factor correctors features fast regulation of the output voltage, one or two power switches operated in unison, a single control loop, and automatic shaping of the line current. We give topologies, steady-state analysis, design considerations, and experimental results. >

/pdf/a-new-family-of-single-stage-isolated-power-factor-16jfw0oxeh.pdf

A new family of single-stage isolated power-factor correctors with fast regulation of the output voltage

Multi-converter power electronic systems exist in land, sea, air, and space vehicles. In these systems, load converters exhibit constant power load (CPL) behavior for the feeder converters and tend to destabilize the system. In this paper, the implementation of novel active-damping techniques on dc/dc converters has been shown. Moreover, the proposed active-damping method is used to overcome the negative impedance instability problem caused by the CPLs. The effectiveness of the new proposed approach has been verified by PSpice simulations and experimental results.

Active Damping in DC/DC Power Electronic Converters: A Novel Method to Overcome the Problems of Constant Power Loads

An equivalent circuit model for the discontinuous conduction mode flyback converter based on the loss-free resistor concept is presented. This simple model correctly describes the basic power processing properties of the converter, including input port resistor emulation, output port power source characteristics, and control characteristics. Based on this model, steady-state design equations are described and are used in a design example. Design of the slow output voltage feedback loop is also considered. A small-signal AC model is developed for both the resistive load and the DC-DC converter-voltage regulator load cases. In addition, a simple first-order approximation for the line current distortion and phase shift caused by 120 Hz duty cycle variations is derived. >

Design of a simple high-power-factor rectifier based on the flyback converter

A family of AC-to-DC converters which integrate the functions of low harmonic rectification, low frequency energy storage, and wide bandwidth output voltage control into a single converter containing one, two, or four active switches is presented. These converters utilize a discontinuous conduction mode input inductor, an internal energy storage capacitor, and transformer secondary circuits which resemble the bridge, forward, flyback, or Cuk DC-DC converters. A large-signal equivalent circuit model for this family which uses the loss-free resistor concept is presented. Design strategies and experimental results are given. High performance regulation with satisfactory line current harmonics is demonstrated with conventional duty ratio control. Further improvements in line current are possible by simultaneous duty ratio and switching frequency control. >

Integrated high quality rectifier-regulators

A new family of AC-DC converters is derived which integrate the functions of low-harmonic rectification, low-frequency energy storage, and wide-bandwidth output voltage control into a single converter containing one, two, or four active switches. These converters utilize a discontinuous conduction mode input inductor, an internal energy storage capacitor, and transformer secondary circuits which resemble the bridge, forward, flyback, or Cuk DC-DC converters. A large-signal equivalent circuit model for this family is presented, which uses the "loss-free resistor" concept. Design strategies and experimental results are given. High-performance regulation with satisfactory line-current harmonics is demonstrated with conventional duty-ratio control. Further improvements in line current are possible by simultaneous duty-ratio and switching-frequency control.

M. Madigan

Papers

Design of a simple high-power-factor rectifier based on the flyback converter

Integrated high quality rectifier-regulators

Integrated high-quality rectifier-regulators