Disinfection of wastewater with peracetic acid: a review.

Disinfection efficiency of peracetic acid, UV and ozone after enhanced primary treatment of municipal wastewater.

Peracids have gained interest in the water treatment over the last few decades. Peracetic acid (CH3CO3H) has already become an accepted alternative disinfectant in wastewater disinfection whereas p...

/pdf/peracids-in-water-treatment-a-critical-review-d5m4bx17n9.pdf

Peracids in water treatment : a critical review

The Montreal Urban Community Wastewater Treatment Plant (MUCWTP) located in Montreal. Quebec, Canada, uses physicochemical treatment processes prior to discharging wastewater into the St. Lawrence River via an outfall tunnel of 2 hours retention time. Although chlorination facilities exist, they are not being used, and the MUCWTP is seeking alternative methods for disinfection to achieve a 2- to 3-log fecal coliform reduction. Liquid chemical disinfectants were attractive options because of their low capital costs. This led to an investigation of the feasibility of using hydrogen peroxide or peracetic acid. A method for measuring peroxycompounds (hydrogen peroxide or peracetic acid plus hydrogen peroxide) was developed using the peroxidase-based oxidation of 2,2'-azino-bis(3-ethylbenz-thiazoline-6-sulfuric acid) diammonium salt (ABTS) with hydrogen peroxide. The validity of the method was confirmed using effluent from the MUCWTP. Recovery was higher than 90% for peracetic acid levels as low as 1.0 mg/L. Quenching of hydrogen peroxide was achieved with 50-mg/L catalase; quenching of peracetic acid was achieved with 100 mg/L of sodium thiosulfate, followed by 50 mg/L of catalase. Batch disinfection tests were conducted on MUCWTP effluent. Hydrogen peroxide and peracetic acid in wastewater over time could be modeled as a second-order decay, with the decay "constant" being a function of the initial concentration of peroxycompounds. This function was the same for both hydrogen peroxide and peracetic acid, possibly indicating similar decomposition pathways in wastewater matrices. Disinfection was modeled using a modified Hom equation. Required doses of hydrogen peroxide to reach the target fecal coliform levels ranged from 106 to 285 mg/L, with the higher doses occurring when ferric chloride instead of alum was used as the coagulant. Hence, hydrogen peroxide was infeasible as a disinfectant for this application. On the other hand, the peracetic acid dose needed to achieve the target fecal coliform level was only 0.6 to 1.6 mg/L. Therefore, peracetic acid seems to be a promising disinfectant for physicochemical or primary effluent, or combined sewer overflows.

Disinfection of Wastewater by Hydrogen Peroxide or Peracetic Acid: Development of Procedures for Measurement of Residual Disinfectant and Application to a Physicochemically Treated Municipal Effluent

The aims of this research were to study the influence of peracetic acid (PAA) on the formation of mutagens in surface waters used for human consumption and to assess its potential application for the disinfection of drinking water. The results obtained using PAA were compared to those found with sodium hypochlorite (NaClO) and chlorine dioxide (ClO2). The Ames test, root anaphase aberration assay, and root/micronuclei assay in Allium cepa and Tradescantia/micronuclei test were used to evaluate the mutagenicity of disinfected samples. Microbiological tests were also performed, and disinfection by-products (DBPs) were identified using gas chromatography/mass spectrometry (GC/MS). A slight bacterial mutagenicity was found in raw lake and river water, and similar activity was detected in disinfected samples. A plant test revealed genotoxicity in raw river water, and microbiological analysis showed that PAA has bactericidal activity but lower than that of the other disinfectants. The DBPs produced by PAA were mainly carboxylic acids, which are not recognized as mutagenic, whereas the waters treated with the other disinfectants showed the presence of mutagenic/carcinogenic halogenated DBPs. However, additional experiments should be performed with higher concentrations of PAA and using water with higher organic carbon content to better evaluate this disinfectant.

M. S. French

Papers

Disinfection of Sewage Effluent with Peracetic Acid