Massimo Setti

TL;DR: In this article, the authors performed an archaeological study of the facade of the Church of Santa Maria del Carmine in Pavia (Italy) and obtained useful information about the firing temperatures, the provenance of raw materials and the type of oven used.

TL;DR: In this article, a reconnaissance study of the Khaung Daing hot spring outflows at a temperature of about 70C, and the water pH is slightly acidic, and, compared to the other water samples from the watershed, shows an EC in the high range (57-1284μS/cm), the lowest pH and Eh values, and is Na-HCO 3, whereas surface and ground waters are Ca(Mg)-HCO3 type.

TL;DR: In this paper, the compositional features of clay minerals in the lower sequence such as conglomerates, Devonian sandstones and dolerites are described and genetic processes clarified, and two clay mineral assemblages were characterized through analysis by X-ray diffraction (XRD), transmission electron microscopy (TEM) and scanning electron microscope (SEM).

TL;DR: In this article, the contribution of agricultural practices to diffuse pollution in cultivated soils was quantified by analyzing 1000 soil profiles for their potentially toxic elements (PTEs) content (Cd, Cu, Ni, Pb, Zn, Mn).

TL;DR: In this article, an increase of the firing cycle from 45 to 60min is suggested and the use of two low-rate heating stages: 1) 11min from 520°C to 590°C, and 2) 8min from 800 Â c to 900 Â C in the decarbonation zone, thereby eliminating glaze craters and bubbles.