The Gulong shale oil reservoir is situated in freshwater to slightly saline lacustrine basins mainly consisting of a pure shale geological structure, which is quite different from other shale reservoirs around the world. Currently, the development of Gulong shale oil mainly relies on hydraulic fracturing, while the subsequent shut-in period for imbibition has been proven to be an effective method for enhancing shale oil recovery. To clarify the characteristics of the fluid occurrence space and the variation in the fluid occurrence during saltwater imbibition in Gulong shale, this paper carried out porosity and permeability tests on Gulong shale cores and analyzed the fluid occurrence space characteristics and imbibition oil recovery based on nuclear magnetic resonance (NMR). In the porosity and permeability tests, T2 distributions were used to correct the porosity measured by the saturation method to obtain the NMR porosity. Combined with the identification of fractures in shale cores using micro-CT and the analysis of porosity and permeability parameters, it was found that the permeability of the shale cores was related to the development of fractures in the shale cores. Through the testing and analysis of T1-T2 maps of the shale cores before and after saturation with oil, it was found that the shale mainly contained heavy oil, light oil, and clay-bound water, and they were distributed in different regions in the T1-T2 maps. Finally, the T1-T2 maps of the shale cores at different imbibition stages were analyzed, and it was found that saltwater mainly entered the minuscule inorganic pores of clay minerals during the imbibition process and squeezed the larger-sized inorganic pores containing light oil through the hydration expansion effect, thus expelling the light oil from the shale core and achieving the purpose of enhanced oil recovery.

https://www.mdpi.com/2227-9717/11/6/1678/pdf?version=1685533646

NMR-Based Analysis of Fluid Occurrence Space and Imbibition Oil Recovery in Gulong Shale

This paper investigates high-maturity organic matter-rich shales with high clay mineral contents in the Qingshankou Formation, in the Gulong Depression of the Songliao Basin, at a sub-millimeter scale, using a new laminar division method based on XRF data. The influence of laminar structure on reservoir quality is examined using a combination of geochemistry, mineralogy, and pore structures. Explanatory models are established. Three types of laminar units are distinguished in the study area based on differences in pore structure. These are clay mineral laminae (UA), clay mineral-Ostracod laminae (UB), and clay mineral-felsic laminae (UC). UA has illite intergranular pores, micro-fractures, and organic pores, with diameters of 0.5~2 μm. UB primarily contains Ostracod shell margin fractures, pyrite intergranular pores, and chlorite intragranular pores. UC contains albite and illite intergranular pores. Nitrogen adsorption tests show that UA has the highest clay content and the best specific pore volume and specific surface area, indicating that clay minerals are the main contributors to the pores in this type of unit. 2D–3D models of different laminae reveal that carbonate cement is widely developed in UB and UC, but dissolution pores are less developed, with the result that the porosity of UA is two to three times greater than that of UB or UC. It appears that intergranular pores and fractures, formed during the transformation of clay minerals during the advanced thermal evolution stage, are the main contributors to storage space and flow channels. Thermal evolution, clay mineral transformation, and carbonate cementation are the key factors causing differences between laminar units. In addition, clay mineral laminae (UA) are the most important laminar units for shale oil enrichment in the study area. This finding is of great significance for accurately predicting the distribution of shale “sweet spots” and guiding shale oil and gas exploration.

/pdf/laminar-structure-and-reservoir-quality-of-shales-with-high-2m1q1vog.pdf

Laminar Structure and Reservoir Quality of Shales with High Clay Mineral Content in the Qingshankou Formation, Songliao Basin

Rolling optimization based on holism for the operation strategy of solar tower power plant

The exploration and development of Gulong shale oil in the Songliao Basin has achieved a major breakthrough, with the result that a national shale oil demonstration area is being built. The shale in the Sanzhao Sag is abundant in organic matter and is an important replacement area. For this reason, it has recently become a focus for research and exploration. Compared with the Gulong Sag, the Qingshankou Formation in the Sanzhao Sag is relatively immature, and comparatively little is known about its pore structure. For this study, well ZY1, a key well in the Sanzhao Sag, was selected as the research object. Thin section observation, high-resolution field emission scanning electron microscopy, Modular Automated Processing Systemimaging, X-ray diffraction of whole rock and clay, TOC pyrolysis, and Low-pressure N2 adsorption were used to investigate the pore structure in the sag to determine the factors influencing pore development. The principal understandings are as follows: (1) The Qingshankou Formation in the Sanzhao Sag is predominantly clay shale, with a high content of clay minerals (32.8 to 70%) and TOC contents of 0.7 to 11%. These values indicate good hydrocarbon generation potential. (2) Interparticle pores, intraparticle pores, and organic matter pores are developed. Intergranular pores are the main type, mostly observed between granular minerals or between granular minerals and clays. Intraparticle pores are observed in pyrite mass and dissolved unstable minerals. Organic matter pores (OMP) occur in primary organic matter and migrate into solid bitumen. (3) The shale pores in the Sanzhao Sag are mainly H3-type slit pores, with specific surface areas of 5.4~22.9 m2/g and pore volumes of 0.03~0.07 cm3/g. Mesopores make the largest contribution to pore volume and specific surface area. Scanning electron microscope (MAPS) imaging shows that the pore size distribution of shale is mainly 20~30 nm and 100~200 nm and that large pores, especially pores of 100~200 nm and 1~2 μm, make the largest contribution to the facies. (4) The pore structure in the Sanzhao Sag is affected by mineral composition, abundance of organic matter, thermal evolution degree, and diagenesis. Organic-inorganic interactions influence and determine the pore structure characteristics of the Qingshankou Formation shale. This paper is intended to provide scientific guidance and technical support for evaluating the effectiveness of shale oil reservoirs and selecting sweet spots in the Sanzhao Sag.

/pdf/pore-structure-and-its-controls-of-shale-in-the-qingshankou-2un5asel.pdf

Pore Structure and Its Controls of Shale in the Qingshankou Formation, Sanzhao Sag, Songliao Basin

The Permian Fengcheng Formation in the Mahu Sag was deposited in a volcanic-alkaline lacustrine evaporative environment and contains a unique variety of fine-grained sediments. This study examines, at a millimeter-scale, the influence of sedimentary microfacies on variability of lamina quality in fine-grained sediments in the second member of the Fengcheng Formation (P1f2). The methods used include thin-section identification, X-ray diffraction (XRD), X-ray fluorescence (XRF), scanning electron microscopy (SEM), nitrogen adsorption, and nuclear magnetic resonance (NMR). Six types of lamina were identified in two different lithofacies: fan-delta front facies (FDFF) and semideep/deep lacustrine facies (SDDLF). The laminae in FDFF are predominantly feldspar-quartz laminae (FQL), reedmergnerite laminae (RL), shortite laminae (SL), alkaline mineral laminae (AML), and chert laminae (CL). The laminae in SDDLF are predominantly FQL, RL, SL, CL, and dolomite laminae (DOL). Variations in reservoir quality, oil-bearing properties, and the fracability of laminae in different sedimentary facies are determined by the combined effects of lamina density, mineral composition, rock structure, organic matter abundance, and microfractures. Analysis of these factors indicates superior reservoir qualities in FDFF. In SDDLF, the pore structure is limited by high lamina density, chert content, and fine grain size with the NMR porosities of FQL, RL, SL, and CL being 1.32, 0.18, 0.84, and 0.39%, respectively. However, in FDFF, the combination of high organic matter content, feldspar, pyrite, and clay minerals has a superior effect on the organic matter and minerals deposited resulting in better pore structure and more storage space for shale oil. The NMR porosities of FQL, RL, SL, and CL are 2.81, 2.53, 1.80, and 1.12%, respectively. Overall, analysis of lamina variations and their relationships with sedimentary facies indicates that the reservoir in FDFF may offer more favorable targets for “sweet spot” evaluation.

Mengying Li

Papers

Laminar Structure and Reservoir Quality of Shales with High Clay Mineral Content in the Qingshankou Formation, Songliao Basin

Rolling optimization based on holism for the operation strategy of solar tower power plant

Pore Structure and Its Controls of Shale in the Qingshankou Formation, Sanzhao Sag, Songliao Basin

Lamina Variation and Its Relationship with Sedimentary Facies in Alkaline Lacustrine, Permian Fengcheng Formation, Junggar Basin, Northwest China