scispace - formally typeset
O

Olatunji Oladimeji Ojo

Researcher at Federal University of Technology Akure

Publications -  67
Citations -  1180

Olatunji Oladimeji Ojo is an academic researcher from Federal University of Technology Akure. The author has contributed to research in topics: Welding & Ultimate tensile strength. The author has an hindex of 17, co-authored 52 publications receiving 642 citations. Previous affiliations of Olatunji Oladimeji Ojo include Kocaeli University.

Papers
More filters
Journal ArticleDOI

Influence of multi-pass FSP on the microstructure, mechanical properties and tribological characterization of Al/B4C composite fabricated by accumulative roll bonding (ARB)

Moslem Paidar, +3 more
- 15 Mar 2019 - 
TL;DR: In this article, the impact of post-multi-pass friction stir processing (FSP) on the microstructure, mechanical, wear and fracture behaviors of the fabricated 10 cycle-accumulative roll bonded Al-2%B4C composites was analyzed.
Journal ArticleDOI

Weldability and mechanical properties of AA5083-H112 aluminum alloy and pure copper dissimilar friction spot extrusion welding-brazing

Moslem Paidar, +5 more
- 01 May 2021 - 
TL;DR: In this article, the friction spot extrusion welding-brazing (FSEW-B) process was employed to join AA5083-H112 aluminum alloy and pure Cu via the use of a Zn interlayer to improve the mechanical properties of the dissimilar joint.
Journal ArticleDOI

Mechanical Properties and Wear Behavior of AA5182/WC Nanocomposite Fabricated by Friction Stir Welding at Different Tool Traverse Speeds

Moslem Paidar, +3 more
- 20 Mar 2018 - 
TL;DR: In this paper, tungsten carbide (WC) nanoparticles were employed as reinforcements for the friction stir welding of 5mm-thick AA5182 aluminum alloy by varying tool traverse speeds.
Journal ArticleDOI

Enhancing the mechanical and tribological properties of Mg2Si-rich aluminum alloys by multi-pass friction stir processing

Ali Moharrami, +5 more
- 01 Aug 2020 - 
TL;DR: In this article, a multi-pass FSPed in-situ Al-25Mg2Si composite with a threaded triangular pin tool was conducted at constant tool rotational and traverse speeds of 1000-rpm and 80-mm/min for 1-6 passes.
Journal ArticleDOI

Role of Mg2Si particles on mechanical, wear, and corrosion behaviors of friction stir welding of AA6061-T6 and Al-Mg2Si composite:

A Moharami, +4 more
- 19 May 2020 - 
TL;DR: In this paper, the effect of different tool pin morphologies on the intermixing capability, microstructure, mechanical properties, corrosion, fracture, and wear behaviors of the dissimila...