scispace - formally typeset
R

R.D.K. Misra

Researcher at University of Texas at El Paso

Publications -  340
Citations -  8153

R.D.K. Misra is an academic researcher from University of Texas at El Paso. The author has contributed to research in topics: Austenite & Martensite. The author has an hindex of 35, co-authored 338 publications receiving 5188 citations.

Papers
More filters
Journal ArticleDOI

Significance of Finish Cooling Temperature to Microstructure and Property Relationship of Low-Carbon V-N-Cr Microalloyed High-Strength Steel

TL;DR: In this article, three final cooling temperatures were employed to achieve high strength and toughness communication in the V-N-Cr microalloyed steels, and the highest yield strength and tensile strength were 835 and 989 MPa, respectively.
Journal ArticleDOI

Significant impact of cold-rolling deformation and annealing on damping capacity of Fe–Mn–Cr alloy

TL;DR: In this article, the damping capacity of Fe-19Mn-8Cr alloy with annealing and cold-rolling deformation was investigated, and it was observed that the cold-rolled Fe 19Mn 8c alloy with a reduction of 10% showed the relatively good damping performance.
Journal ArticleDOI

Softening and recrystallization behavior of a new class of ferritic steel

TL;DR: In this article, the recrystallization mechanism of low-density δ-ferrite steel Fe-4Al-2Ni was clarified by using interrupted and single-pass compression tests.
Journal ArticleDOI

Design of a cold-rolled novel advanced high-strength steel: An analysis of microstructural evolution and mechanical properties

TL;DR: In this article, a novel advanced high-strength steel Fe79.5Mn12C0.85Cr2.07Ni2.62Si2.68B0.23 (wt%) was designed in laboratory scale.
Journal ArticleDOI

The Impact of Isothermal Treatment on the Microstructural Evolution and the Precipitation Behavior in High Strength Linepipe Steel.

TL;DR: Thermal simulation of different isothermal treatment temperatures was adopted by using a thermomechanical simulator, and the results showed that hardness reached the maximum value at 600 °C holding temperature, which was related to a finer grain structure and granular bainite.