Orthogonal frequency division multiplexing (OFDM) is a modulation technique which is now used in most new and emerging broadband wired and wireless communication systems because it is an effective solution to intersymbol interference caused by a dispersive channel. Very recently a number of researchers have shown that OFDM is also a promising technology for optical communications. This paper gives a tutorial overview of OFDM highlighting the aspects that are likely to be important in optical applications. To achieve good performance in optical systems OFDM must be adapted in various ways. The constraints imposed by single mode optical fiber, multimode optical fiber and optical wireless are discussed and the new forms of optical OFDM which have been developed are outlined. The main drawbacks of OFDM are its high peak to average power ratio and its sensitivity to phase noise and frequency offset. The impairments that these cause are described and their implications for optical systems discussed.

OFDM for Optical Communications

The generation of RF/microwave power is required not only in wireless communications, but also in applications such as jamming, imaging, RF heating, and miniature dc/dc converters. Each application has its own unique requirements for frequency, bandwidth, load, power, efficiency, linearity, and cost. RF power is generated by a wide variety of techniques, implementations, and active devices. Power amplifiers are incorporated into transmitters in a similarly wide variety of architectures, including linear, Kalm, envelope tracking, outphasing, and Doherty. Linearity can be improved through techniques such as feedback, feedforward, and predistortion.

Power amplifiers and transmitters for RF and microwave

Single carrier frequency division multiple access (SC FDMA), a modified form of orthogonal FDMA (OFDMA), is a promising technique for high data rate uplink communications in future cellular systems. SC-FDMA has similar throughput performance and essentially the same overall complexity as OFDMA. A principal advantage of SC-FDMA is the peak-to-average power ratio (PARR), which is lower than that of OFDMA. SC FDMA is currently a strong candidate for the uplink multiple access scheme in the long term evolution of cellular systems under consideration by the third generation partnership project (3GPP). In this paper, we give an overview of SC-FDMA. We also analyze the effects of subcarrier mapping on throughput and PARR. Among the possible subcarrier mapping approaches, we find that localized FDMA (LFDMA) with channel-dependent scheduling (CDS) results in higher throughput than interleaved FDMA (JFDMA). However, the PARR performance of IFDMA is better than that of LFDMA. As in other communications systems there are complex tradeoffs between design parameters and performance in an SC-FDMA system

Single carrier FDMA for uplink wireless transmission

As of today, orthogonal frequency division multiplexing (OFDM) has been the dominant technology for broadband multicarrier communications. However, in certain applications such as cognitive radios and uplink of multiuser multicarrier systems, where a subset of subcarriers is allocated to each user, OFDM may be an undesirable solution. In this article, we address the shortcomings of OFDM in these and other applications and show that filter bank multicarrier (FBMC) could be a more effective solution. Although FBMC methods have been studied by a number of researchers, and some even before the invention of OFDM, only recently has FBMC been seriously considered by a few standard committees.

OFDM Versus Filter Bank Multicarrier

The automatic recognition of the modulation format of a detected signal, the intermediate step between signal detection and demodulation, is a major task of an intelligent receiver, with various civilian and military applications. Obviously, with no knowledge of the transmitted data and many unknown parameters at the receiver, such as the signal power, carrier frequency and phase offsets, timing information and so on, blind identification of the modulation is a difficult task. This becomes even more challenging in real-world scenarios with multipath fading, frequency-selective and time-varying channels. With this in mind, the authors provide a comprehensive survey of different modulation recognition techniques in a systematic way. A unified notation is used to bring in together, under the same umbrella, the vast amount of results and classifiers, developed for different modulations. The two general classes of automatic modulation identification algorithms are discussed in detail, which rely on the likelihood function and features of the received signal, respectively. The contributions of numerous articles are summarised in compact forms. This helps the reader to see the main characteristics of each technique. However, in many cases, the results reported in the literature have been obtained under different conditions. So, we have also simulated some major techniques under the same conditions, which allows a fair comparison among different methodologies. Furthermore, new problems that have appeared as a result of emerging wireless technologies are outlined. Finally, open problems and possible directions for future research are briefly discussed.

Survey of automatic modulation classification techniques: classical approaches and new trends

From the Book:
The manifestations of the mode of goodness can be experienced when all the gates of the body are illuminated by knowledge 
The Bhagavad Gita (14.11)

During the joint supervision of a Master's thesis "The Peak-to-Average Power Ratio of OFDM," of Arnout de Wild from Delft University of Technology, The Netherlands, we realized that there was a shortage of technical information on orthogonal frequency division multiplexing (OFDM) in a single reference. Therefore, we decided to write a comprehensive introduction to OFDM. This is the first book to give a broad treatment to OFDM for mobile multimedia communications. Until now, no such book was available in the market. We have attempted to fill this gap in the literature. 
Currently, OFDM is of great interest by the researchers in the Universities and research laboratories all over the world. OFDM has already been accepted for the new wireless local area network standards from IEEE 802.11, High Performance Local Area Network type 2 (HIPERLAN/2) and Mobile Multimedia Access Communication (MMAC) Systems. Also, it is expected to be used for the wireless broadband multimedia communications.
OFDM for Wireless Multimedia Communications is the first book to take a comprehensive look at OFDM, providing the design guidelines one needs to maximize benefits from this important new technology. The book gives engineers a solid base for assessing the performance of wireless OFDM systems. It describes the new OFDM-based wireless LAN standards; examines the basics of direct-sequence and frequency-hopping CDMA, helpful in understanding combinations of OFDM and CDMA. It also looks at applications of OFDM, includingdigital audio and video broadcasting, and wireless ATM. Loaded with essential figures and equations, it is a must-have for practicing communications engineers, researchers, academics, and students of communications technology. 
Chapter 1 presents a general introduction to wireless broadband multimedia communication systems (WBMCS), multipath propagation, and the history of OFDM. A part of this chapter is based on the contributions of Luis Correia from the Technical University of Lisbon, Portugal, Anand Raghawa Prasad from Lucent Technologies, and Hiroshi Harada from the Communications Research Laboratory, Ministry of Posts and Telecommunications, Yokosuka, Japan. 
Chapters 2 to 5 deal with the basic knowledge of OFDM including modulation and coding, synchronization, and channel estimation, that every post-graduate student as well as practicing engineers must learn. Chapter 2 contains contributions of Rob Kopmeiners from Lucent Technologies on the FFT design. 
Chapter 6 describes the peak-to-average power problem, as well as several solutions to it. It is partly based on the contribution of Arnout de Wild. 
Basic principles of CDMA are discussed in Chapter 7 to understand multi carrier CDMA and frequency-hopping OFDMA, which are described in Chapters 8 and 9. Chapter 8 is based on the research contributions from Shinsuke Hara from the University of Osaka, Japan, a postdoctoral student at Delft University of Technology during 1995-96, Chapter 9 is based on a UMTS proposal, with main contributions of Ralf Bohnke from Sony, Germany, David Bhatoolaul and Magnus Sandell from Lucent Technologies, Matthias Wahlquist from Telia Research, Sweden, and Jan-Jaap van de Beek from Lulea University, Sweden. 
Chapter 10 was written from the viewpoint of top technocrats from industries, government departments, and policy-making bodies. It describes several applications of OFDM, with the main focus on wireless ATM in the Magic WAND project, and the new wireless LAN standards for the 5 GHz band from IEEE 802.11, HIPERLAN/2 and MMAC. It is partly based on contributions from Geert Awater from Lucent Technologies, and Masahiro Morikura and Hitoshi Takanashi from NTT in Japan and California, respectively.
We have tried our best to make each chapter quite complete in itself This book will help generate many new research problems and solutions for future mobile multimedia communications. We cannot claim that this book is errorless. Any remarks to improve the text and correct any errors would be highly appreciated.

OFDM for Wireless Multimedia Communications

Methods and systems for communications that generate a plurality of spatial streams, wherein each of the spatial streams comprises a data packet with a training sequence; and multiply at least a portion of the training sequence in each of the spatial streams with a different spreading sequence. Methods and systems that receive a plurality of spatial streams, wherein each of the spatial streams comprises a data packet with a training sequence; multiply at least a portion of the training sequence in each of the spatial streams with a different spreading sequence; and decode the plurality of spatial streams based on the different spreading sequences.

Training sequences for very high throughput wireless communication

Summary form only given. The 802.11ac standard will push wireless LAN throughputs over the gigabit-per-second barrier in the coming years. Rather than only improving single link throughput by using more bandwidth and 256 QAM, 802.11ac also improves network throughput by adding MU MIMO capability. MU-MIMO makes it possible to achieve large throughputs cost effectively by having relatively simple client devices with just one or two antennas that can be simultaneously transmitted to by an access point that may have up to eight antennas.

Breaking the Gigabit-per-second barrier with 802.11AC

A packet detector joint detects 802.11a packets, 802.11b packets and interference that is within a monitored frequency range but is not formatted as 802.11a packets or 802.11b packets. The packet detector can use signals from one or more antennas. Detection of signals is done using differentially detected correlations. In addition to packet detection, the packet detector can identify signal levels, noise levels and locations of narrowband interference. The process of packet detection and identifying other indicators can be done simultaneously and as the signal is being received.

Joint packet detection in a wireless communication system with one or more receiver

Techniques and apparatus for controlling the transmit power of an uplink (UL) signal from a user terminal in a wireless communications system in an effort to achieve some target characteristic, such as a target carrier-to-interference (C/I) ratio, at an access point (AP) are provided. In this manner, such a user terminal may help avoid or compensate for imbalances in received radio frequency (RF) power between UL signals received from multiple user terminals by the AP. For example, the transmit power at each user terminal may be controlled in an effort to achieve a target post-processing C/I ratio of 28 dB per spatial stream in an effort to reduce large power imbalances and optimize throughput per user terminal. The user terminal and the AP may compose part of a multiple-input multiple-output (MIMO) communication system utilizing spatial-division multiple access (SDMA) techniques.

Richard van Nee

Papers

OFDM for Wireless Multimedia Communications

Training sequences for very high throughput wireless communication

Breaking the Gigabit-per-second barrier with 802.11AC

Joint packet detection in a wireless communication system with one or more receiver

Power control for wireless lan stations