Impact of water treatment on the contribution of faucets to dissolved and particulate lead release at the tap

An in situ kinetic study of brass dezincification and corrosion

Effects of pH, chloride, bicarbonate, and phosphate on brass dezincification

Some α + β’ brass components of drinking water distribution systems in Morocco underwent early failures and were investigated to assess the nature and extent of the corrosion attacks. They exhibited different corrosion forms, often accompanied by extensive β’ dezincification. In order to offer viable alternatives to these traditional low cost materials, the corrosion behavior of two representative α + β’ brass components was compared to that of brass alloys with nominal compositions CuZn36Pb2As and CuZn21Si3P, marketed as dezincification resistant. CuZn21Si3P is a recently developed eco-friendly brass produced without any arsenic or lead. Electrochemical tests in simulated drinking water showed that after 10 days of immersion CuZn21Si3P exhibited the highest polarization resistance (Rp) values but after longer immersion periods its Rp values became comparable or lower than those of the other alloys. After 150 days, scanning electron microscope coupled to energy dispersive spectroscopy (SEM-EDS) analyses evidenced that the highest dezincification resistance was afforded by CuZn36Pb2As (longitudinal section of extruded bar), exhibiting dealloying and subsequent oxidation of β’ only at a small depth. Limited surface dealloying was also found on CuZn21Si3P, which underwent selective silicon and zinc dissolution and negligible inner oxidation of both α and κ constituent phases, likely due to peculiar galvanic effects.

Corrosion Behavior of Different Brass Alloys for Drinking Water Distribution Systems

Stress corrosion cracking of a copper elbow fitting

Despite a generally good corrosion resistance to tap and industrial water, many brass taps and fittings have failed in the past by stress corrosion cracking (SCC) and selective corrosion (dezincification or preferred removal of a phase). The experimental investigations of the present study clarify the influence of the ammonia concentration on the two types of corrosion. Notched specimens made of the alloys CuZn39Pb3, CuZn40Pb2, CuZn37, CuZn36P-b2As and CuZn21Si3P are polarized anodically in pure tap water and tap water with realistic ammonia concentrations (15 and 30 ppm) under a simultaneous mechanical loading condition. The influence of stress and of the third alloying elements lead and arsenic are investigated and evaluated. The experiments show that the ammonia additions significantly increase the risk of dezincification of the a-b-brasses. The arsenic in the CuZn36Pb2As alloy avoids dezincification, but enhances the risk of SCC. The rate of selective corrosion and SCC consistently increases with increase in tensile stress.

T. Beck

Papers

Stress corrosion cracking and selective corrosion of copper-zinc alloys for the drinking water installation†