Current status of research on optimum sizing of stand-alone hybrid solar–wind power generation systems

Hybrid energy systems are being utilized for supplying electrical energy in urban, rural and remote areas to overcome the intermittence of solar and wind resources. A hybrid renewable energy system incorporates two or more electricity generation options based on renewable energy or fossil fuel unit. The techno-economic analysis of the hybrid system is essential for the efficient utilization of renewable energy resources. Due to multiple generation systems, hybrid system analysis, is quite complex and requires to be analyzed thoroughly. This requires software tools for the design, analysis, optimization, and economic viability of the systems. In this paper, 19 softwares with their main features and current status are presented. The softwares studied are HOMER, Hybrid2, RETScreen, iHOGA, INSEL, TRNSYS, iGRHYSO, HYBRIDS, RAPSIM, SOMES, SOLSTOR, HySim, HybSim, IPSYS, HySys, Dymola/Modelica, ARES, SOLSIM, and HYBRID DESIGNER. The research work related to hybrid systems carried out using these softwares at different locations worldwide is also reviewed. The main objective of the paper is to provide the current status of these softwares to provide basic insight for a researcher to identify and utilize suitable tool for research and development studies of hybrid systems. The capabilities of different softwares are also highlighted. The limitations, availability and areas of further research have also been identified.

Review of software tools for hybrid renewable energy systems

Stand-alone hybrid renewable energy systems usually incur lower costs and demonstrate higher reliability than photovoltaic (PV) or wind systems. The most usual systems are PV–Wind–Battery and PV–Diesel–Battery. Energy storage is usually in batteries (normally of the lead-acid type). Another possible storage alternative, such as hydrogen, is not currently economically viable, given the high cost of the electrolyzers and fuel cells and the low efficiency in the electricity–hydrogen–electricity conversion. When the design of these systems is carried out, it is usually done resolve an optimization problem in which the Net Present Cost (NPC) is minimized or, in some cases, in relation to the Levelized Cost of Energy (LCE). The correct resolution of this optimization problem is a complex task because of the high number of variables and the non-linearity in the performance of some of the system components. This paper revises the simulation and optimization techniques, as well as the tools existing that are needed to simulate and design stand-alone hybrid systems for the generation of electricity.

T.R. Morgan

Papers

‘ARES’—A refined simulation program for the sizing and optimisation of autonomous hybrid energy systems