https://material.karlov.mff.cuni.cz/people/janecek/studenti/FyzMetNano/Estrin_AM61_2013_782.pdf

Extreme grain refinement by severe plastic deformation: A wealth of challenging science

The excellent cryogenic tensile properties of the CrMnFeCoNi alloy are generally caused by deformation twinning, which is difficult to achieve at room temperature because of insufficient stress for twinning. Here, we induced twinning at room temperature to improve the cryogenic tensile properties of the CrMnFeCoNi alloy. Considering grain size effects on the critical stress for twinning, twins were readily formed in the coarse microstructure by cold rolling without grain refinement by hot rolling. These twins were retained by partial recrystallization and played an important role in improving strength, allowing yield strengths approaching 1 GPa. The persistent elongation up to 46% as well as the tensile strength of 1.3 GPa are attributed to additional twinning in both recrystallized and non-recrystallization regions. Our results demonstrate that non-recrystallized grains, which are generally avoided in conventional alloys because of their deleterious effect on ductility, can be useful in achieving high-strength high-entropy alloys.

/pdf/cryogenic-strength-improvement-by-utilizing-room-temperature-219l834bx7.pdf

Cryogenic strength improvement by utilizing room-temperature deformation twinning in a partially recrystallized VCrMnFeCoNi high-entropy alloy

Development of ultrafine grained high strength Al-Cu alloy by cryorolling

The effectiveness of the cryogenic (CT) rolling vis-a-vis room temperature (RT) rolling on strengthening is significantly affected by stacking fault energy (SFE) and there is an optimum SFE at which CT rolling is most effective. Studies on Al, Al alloy AA6061, Cu, Cu–4.6Al, Cu–9Al and Cu–15Al (in at.%) alloys revealed that in metals with very high and very low SFEs, the strength difference between CT and RT rolled samples is

Role of stacking fault energy in strengthening due to cryo-deformation of FCC metals

The mechanical properties of a precipitation hardenable Al–Mg–Si alloy subjected to cryorolling and ageing treatments are reported in this present work. The severe strain induced during cryorolling of Al–Mg–Si alloys in the solid solutionised state produces ultrafine microstructures with improved mechanical properties such as strength and hardness. The improved strength and hardness of cryorolled alloys are due to the grain size effect and higher dislocation density. The ageing treatment of cryorolled Al–Mg–Si alloys has improved its strength and ductility significantly due to the precipitation hardening and grain coarsening mechanisms, respectively. The reduction in dimple size of cryorolled Al–Mg–Si alloy upon failure confirms the grain refinement and strain hardening mechanism operating in the severely deformed samples.

A study on the mechanical properties of cryorolled Al–Mg–Si alloy

Influence of cryo-rolling reduction and annealing of commercially pure (CP) Al is evaluated in four aspects: microstructure, mechanical properties, electrical conductivity and general corrosion. It is shown that by selecting optimal cryo-rolling reduction and subsequent annealing condition result in ultrafine grains in CP Al with good combination of high strength and ductility. Electrical conductivity of the cryo-rolled samples decreased due to increased number of the electron scattering centers (lattice defects and grain boundary area). However, optimization of cryo-rolling and annealing treatment could restore the conductivity coupled with high strength in CP Al. Corrosion behaviour of cryo-rolled CP Al improved after annealing treatment. High dissolution rate and low thermal stability of the ultrafine grain structure could override the anticipated advantage of uniform corrosion in ultrafine grain CP Al.

T. Raghuram

Papers

Effect of cryo-rolling and annealing on microstructure and properties of commercially pure aluminium